Question is ⇒ A Schottky diode has, Options are ⇒ (A) no minority carriers and very low voltage drop in forward direction, (B) no minority carriers and very high voltage drop in forward direction, (C) large number of minority carriers and very high voltage drop in forward direction, (D) large number of minority carriers and very low voltage drop in forward direction, (E) , Leave your comments or Download question paper.

Question is ⇒ A Schottky diode has, Options are ⇒ (A) no minority carriers and very low voltage drop in forward direction, (B) no minority carriers and very high voltage drop in forward direction, (C) large number of minority carriers and very high voltage drop in forward direction, (D) large number of minority carriers and very low voltage drop in forward direction, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A Schottky diode has
A.	no minority carriers and very low voltage drop in forward direction [Correct Answer]
B.	no minority carriers and very high voltage drop in forward direction [Wrong Answer]
C.	large number of minority carriers and very high voltage drop in forward direction [Wrong Answer]
D.	large number of minority carriers and very low voltage drop in forward direction [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The forbidden energy gap in semiconductors
is always zero
lies just below the valence band
lies between the valence band and the conduction band
lies just above the conduction band

⇒ The use of free wheeling diode in controlled rectifier improves the waveshape of load current.
TRUE
FALSE

⇒ The main advantage of TDM over FDM is
TDM requires more bandwidth than FDM
less complicated in hardware than FDM
better SNR
required filter

⇒ For a photo conductor with equal electron and hole mobilities and perfect ohmic contacts at the ends, an increase in the intensities of optical illumination results in
change in open circuit voltage
change in short circuit current
a reduction resistance
an increase of resistance

⇒ The units for electric dipole moment are
coulombs
colomb-metre
coulomb/metre
coulomb/m²

⇒

Match the following:

	List I		List II
A.	Reflex Klystron	1.	High efficiency
B.	Dielectric loaded wave guide	2.	Slow wave structure
C.	TWT	3.	Cross field device
D.	Multi Cavity Klystron	4.	Oscillator

A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-2, B-4, C-1, D-3
A-3, B-1, C-4, D-2

⇒ In EPROM integrated dose is defined as
UV light intensity x exposure time in seconds
UV light intensity / exposure time in seconds
exposure time in seconds / UV light intensity
none of the above

⇒ The contrast control in colour TV receiver is done by
chroma amplifier
SAW filter
video detector
luminance amplifier

⇒ In the field controlled motor the entire damping comes from
armature resistance
back emf
motor friction and load
field resistance

⇒ The recently-introduces CD-ROM PC by Head Start Technologies Co. of New York enables users to view or play __________ .
vast amounts of text
graphics
music
all of the above

⇒ The depletion layer consists of immobile ions.
TRUE
FALSE

⇒ At t = 0⁺, the current i_{1- V/2R
- V/4R
- V/R
zero}

⇒ The real part of complex frequency s corresponds to oscillations.
TRUE
FALSE

⇒ The bandwidth of DSB suppressed carrier modulation system when the modulating frequency varies between 500 Hz and 5 kHz is
555 kHz
505 kHz
500 kHz
9 kHz

⇒ As compared to tuned radio frequency receivers which of the following is the advantage of using superheterodyne receivers?
High gain and better sensitivity
Better selectivity at high frequencies
Stability
Noise suppression

⇒ A 1000 kHz carrier wave modulated 40% at 4000 Hz is applied to a resonant circuit tuned to a carrier frequency and having Q = 140. What is the degree of modulation after transmission through this circuit?
0.4
0.2
0.27
0.54

⇒ CSSB stands for
Compatible Single Sideband
Compressed Single Sideband
Carrier Single Sideband
Coded Single Sideband

⇒ The area of an impulse is
1
0
∞
any finite value

⇒ Which of the following statement is incorrect?
Curl of vector potential is magnetic field density
Electric charges in motion produce magnetic field
Electric charges at rest produce electrostatic field
None of the above

⇒ Which of the following is not the main characteristic of a FET?
Drain resistance
Forward transconductance
Temperature stability
Amplification factor

⇒ All of the output pulses are at full transmitter power for a strong signal in all of the following except
PWM
PAM
PFM
PCM

⇒

Match the following:

	List I		List II
A.	True type	1.	Type of calculator in window
B.	FIND	2.	Window command
C.	WORD PAD	3.	Name of a Font
D.	STANDARD	4.	Has many features of a simple word processor

A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4
A-3, B-2, C-4, D-1

⇒ Each term in POS form is called max terms.
TRUE
FALSE

⇒ A rhombic antenna is a
resonant antenna
non-resonant antenna
coupled antenna
none of the above

⇒

Assertion (A): When performance specifications are given in term of transient response characteristics, root locus method is a suitable method.

Reason (R): When performance specifications in terms of state variables are given, modern control methods can be used.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ In a JK Master slave flip flop
both master and slave are positively clocked
both master and slave are negatively clocked
master is positively clocked and slave is negatively clocked
master is negatively clocked and slave is positively clocked

⇒ A feedback amplifier has forward gains A₁, A₂ and feedback factor β as shown in signal flow graph of the given figure. Because of feedback as shown in signal noise ratio at output
increase
decrease
be unaffected
depend on value of β

⇒ For a 1 cm x 2 cm air filled rectangular waveguide the maximum frequency should be less than about
1000 MHz
5000 MHz
14000 MHz
140000 MHz

⇒ Which of the following terms is not applicable to Yagi-Uda array?
High gain
Folded dipole
Parasitic elements
Good bandwidth

⇒ When phase-lag compensation is used in a system, then gain cross over frequency, bandwidth and undamped frequency are respectively
Increased, Increased, Increased
Increased, Increased, Decreased
Increased, Decreased, Decreased
Decreased, Decreased, Decreased