Question is ⇒ A sawtooth current wave is passed through a resistance, Options are ⇒ (A) the waveshapes of voltages across resistance and power will also the sawtooth, (B) the waveshape of voltage across resistance will be sawtooth, (C) the waveshape of power will be sawtooth, (D) neither the voltage waveshape nor power wave-shape will be sawtooth, (E) , Leave your comments or Download question paper.

Question is ⇒ A sawtooth current wave is passed through a resistance, Options are ⇒ (A) the waveshapes of voltages across resistance and power will also the sawtooth, (B) the waveshape of voltage across resistance will be sawtooth, (C) the waveshape of power will be sawtooth, (D) neither the voltage waveshape nor power wave-shape will be sawtooth, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A sawtooth current wave is passed through a resistance
A.	the waveshapes of voltages across resistance and power will also the sawtooth [Wrong Answer]
B.	the waveshape of voltage across resistance will be sawtooth [Correct Answer]
C.	the waveshape of power will be sawtooth [Wrong Answer]
D.	neither the voltage waveshape nor power wave-shape will be sawtooth [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A directional coupler is used
to transmit microwave signals
to generate microwave signals
to measure amplitude and phase of a travelling wave
both (a) and (b)

⇒

Match the following:

	List I (type of controller)		List II (Operation)
A.	Pneumatic controller	1.	Flexible operation
B.	Hydraulic controller	2.	High torque high speed operation
C.	Electronic controller	3.	Fire and explosion proof operation

A-1, B-3, C-2
A-1, B-2, C-3
A-3, B-1, C-2
A-3, B-2, C-1

⇒ Measurement of radiation resistance by reflection method is suitable for
parasitic element antennas
low frequency vertical conductor antenna
all type of antennas
none of the above

⇒ Which of these instrument does not have a control spring?
Moving iron ammeter
PMMC ammeter
Electrostatic voltmeters
Power factor meter

⇒ A 50 Hz current has an amplitude of 10 A. The rate of change of current at t = 0.005 after i = 0 and is increasing is
2221.44 A/s
0
- 2221.44 A/s
- 3141.6 A/s

⇒ For a MOD-12 counter, the FF has a t_pd = 60 ns The NAND gate has a t_pd of 25 n sec. The clock frequency is
3.774 MHz
> 3.774 MHz
< 3.774 MHz
4.167 MHz

⇒ As comparated to an ordinary p-n diode, the extent of impurity atoms in a tunnel diode
is more
is less
may be more or less
is almost the same

⇒

Match the following:

	List I (DOS commands)		List II (Meaning)
A.	DBLSPACE	1.	Deletes a director and its sub-directories
B.	MEM	2.	Displays the amount of used and free memory
C.	SYS	3.	Put a copy of DOS on disk
D.	DELTREE	4.	Compresses files to increase the storage capacity of disc

A-4, B-3, C-2, D-1
A-2, B-3, C-4, D-1
A-4, B-2, C-3, D-1
A-1, B-2, C-3, D-4

⇒ The amplifier network is shown bel
6.42 kΩ, 5.6 kΩ
6.42 Ω, (5.62) kΩ
6.4kΩ, (5.62) kΩ
6.42 Ω, 5.6 kΩ

⇒ The current passing through a resistance of 100 ± 0.2% Ω is 2 ± 0.5% A. The limiting error in computation of power will be
± 0.7%
± 0.9%
± 1.2%
± 0.3%

⇒ If f is more than f_unity the gain of op-amp becomes less than 1.
TRUE
FALSE

⇒ A n-channel JFET has I_DSS = 2 mA, Gate to source voltage V_GS = - 2 V and trans-conductance is 0.5 mW then pinch-off voltage is __________ .
- 2 V
2 V
- 4 V
4 V

⇒ Which of the following can be used for measuring capacitance?
De sauty bridge
Maxwell's bridge
Anderson bridge
Hay's bridge

⇒ If μ_n is mobility of free electron and μ_p is mobility of holes then for silicon at 300 K
μ_n = μ_p
μ_n > μ_p
μ_n < μ_p
μ_n may be more or less than μ_p

⇒ When a diode is not conducting, its bias is
forward
zero
reverse
zero or reverse

⇒ A T network is inserted between source and R as shown in figure. The resistance seen by the source remains the same with or without T network when
5 Ω
10 Ω
15 Ω
20 Ω

⇒ The energy to cause thermionic emission is supplied by heating the cathode.
TRUE
FALSE

⇒ A 555 timer can be used as
an astable multivibrator
monostable multivibrator
frequency Divider only
any of the above

⇒ An audio signal of FM radio station is sampled at a rate of 15% above the Nyquist rate. Signal is sampled in 512 levels and bandwidth of the signal is 4 KHz. The minimum bandwidth required to transmit this signal will be
77 K bits/sec
92 K bits/sec
84.8 K bits/sec
82.8 K bits/sec

⇒ Some of MOS families are PMOS, NMOS, CMOS. The family dominating the LSI field where low power consumption is necessary is
NMOS
CMOS
PMOS
both NMOS and CMOS

⇒ D/A converters are generally
weighted resistor network
binary ladder network
either (a) or (b)
neither (a) nor (b)

⇒ In a three input AND gate A = 1, B = 1, C = 0 The output Y =
ABC
ABC
ABC
ABC

⇒ Two coupled coils lie in parallel planes such that 50% of magnetic flux produced by one links the other. The coefficient of coupling is
0.5
0.25
0.125
0.5

⇒ For global communication, the number of satellites needed is
1
3
10
5

⇒ Data can be changed from spatial code to temporal code and vice-versa by using
ADC and DAC
shift Register
synchronous counter
timers

⇒ Due to which of the following reasons, the ground wave eventually disappears, as one moves away from the transmitter?
Tilting
Loss of line-of-eight conditions
Interference from the sky wave
Maximum single hop distance limitation

⇒ In figure the diode is ideal (zero cut in voltage zero forward resistance). Then the current through diod
0
0.166666666666667
0.0416666666666667
none of the above

⇒ A Wien bridge oscillator uses
negative feedback
positive feedback
both negative and positive feedback
none of the above

⇒ How many interrupts are there in 8085 microprocessor?
4
5
6
8

⇒ Nichrome is used for
overhead line wires
heater coils
lamp filaments
all of the above