Question is ⇒ A resistor of 10 kΩ has an rms noise voltage of 1 mV under a certain set of conditions. A resistor of 20 kΩ under the same conditions will have an rms noise voltage of, Options are ⇒ (A) 1 mV, (B) 2 mV, (C) 1.414 mV, (D) 4 mV, (E) , Leave your comments or Download question paper.

Question is ⇒ A resistor of 10 kΩ has an rms noise voltage of 1 mV under a certain set of conditions. A resistor of 20 kΩ under the same conditions will have an rms noise voltage of, Options are ⇒ (A) 1 mV, (B) 2 mV, (C) 1.414 mV, (D) 4 mV, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A resistor of 10 kΩ has an rms noise voltage of 1 mV under a certain set of conditions. A resistor of 20 kΩ under the same conditions will have an rms noise voltage of
A.	1 mV [Wrong Answer]
B.	2 mV [Wrong Answer]
C.	1.414 mV [Correct Answer]
D.	4 mV [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which one of the following theorem can be conveniently used to calculate the power consumed by the 10 Ω resistor in the network shown in the above fig
Thevenin's theorem
Maximum power transfer theorem
Millman's theorem
Superposition theorem

⇒ The signal plate of vidicon tube is coated with tin oxide.
TRUE
FALSE

⇒

Assertion (A): When a high reverse voltage is applied to a p-n junction the diode breaks down.

Reason (R): High reverse voltage causes Avalanche effect.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The number of select lines in a 16 : 1 multiplexer are
4
3
2
1

⇒ If the potential functions V₁ and V₂ satisfy Laplace's equation within a closed region and assume the same values on its surface, then which of the following is correct?
V₁ and V₂ are identical
V₁ is inversely proportional to V₂
V₁ has the same direction as V₂
V₁ has the same magnitude as V₂ but has different direction

⇒ A separately excited dc motor is run from a dc source through a chopper. At 600 rpm and rated torque, the duty cycle of chopper is 0.8. At 600 rpm and half the rated torque, the duty cycle is likely to be
0.9
0.8
0.75
0.6

⇒ Semiconductor ROM's are sometimes preferred to semiconductor RAM's because
ROM's are cheaper than RAMs
ROMs are faster
ROMs do not require power supply for their operations
Programs stored in ROMs cannot be altered either by the power failure or by the user

⇒ The range of signed decimal number that can be represented by 6 bit in complement number is
-31 to +31
-63 to +64
-64 to +63
-32 to +31

⇒ The most commonly used transistor amplifier circuit is
CB
CC
CE
CE or CC

⇒ For a series resonant circuit at low frequency circuit impedance is __________ and at high frequency circuit impedance is _______
capacitive, inductive
inductive, capacitive
resistive, inductive
capacitive, resistive

⇒ Which one of the following is an indirect way of generating FM?
Armstrong modulator
Varactor diode modulator
Reactance FET modulator
Reactance bipolar transistor modulator

⇒ Choose the correct option
tree does not contain any loop
tree contain all the nodes
tree is always open
all

⇒ In a class C amplifier, full cycle conductor of the current is achieved by employing
tuned circuit
transformers
complementary pair
Push pull configuration

⇒ Rotation of a geosynchronous satellite means its
drift from stationary position
wobbling
three-axis stabilization
three-dimensional stabilization

⇒ Figure shows the terminals of a transistor in plastic package TO 18. T
terminals 1, 2, 3 are emitter, collector, base respectively
terminals 1, 2, 3 are emitter, base, collector respectively
terminals 1, 2, 3 are base, emitter collector, respectively
terminals 1, 2, 3 are collector, emitter, base respectively

⇒ The mechanical system shown below has its pole(s)
- K/D
- D/K
- DK
0, - K/D

⇒ If the bandwidth is increased by 2, the γ_FM γ_AM (where γ is the ratio of SNR of output to SNR at input, FM is frequency modulation and AM is amplitude modulation) is increased by a factor of
2
3
4
6

⇒ In n channel JFET
I_D and V_DS are positive but V_GS is negative
I_D and V_GS are positive but V_DS is negative
V_DS and V_GS are positive but I_D is negative
I_D, V_DS and V_GS are all positive

⇒ Cross-over distortion behaviour is a characteristic of
class A output stage
class B output stage
class AB output stage
common base output stage

⇒ What is the minimum value of VSWR that may exist on a transmission line?
Less than zero
Zero
One
10

⇒ In fibre optics the use is made of thin glass fibres for efficient transmission of light.
TRUE
FALSE

⇒ A dc amplifier can operate
at zero frequency
only at low frequency
only at high frequencies
both at low and high frequencies

⇒ Power handling capacity of wire wound potentiometer used in control systems is about
0.1 W
5 W
25 W
100 W

⇒ A cycloconverter is
ac-dc converter
dc-ac converter
dc-dc converter
ac-ac converter

⇒ All of the following elements have three valence electrons EXCEPT
boron
indium
gallium
arsenic

⇒

Assertion (A): Divide-64 counter is a Mod-64 counter and divides the input frequency by 64

Reason (R): A Mod 64 counter can be obtained by cascading Mod 16 and Mod 4 counters.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ For checking the parity of a digital word, it is preferable to use
AND gates
NAND gates
EX-OR gates
NOR gates

⇒ The circuit shown depic
voltage series negative feedback
voltage shunt negative feedback
current series negative feedback
current shunt negative feedback

⇒ If the op-amp in figure has a unity gain frequency of 1 MHz, the cut off frequenc
100 kHz
1 MHz
10 MHz
90 MHz

⇒ In Gunn diode electrons are transferred from
Ridge guide is essentially a form of capacitively loaded guide
low to high mobility energy bands
valley to domain formation
domain to valley formation