Question is ⇒ A resistance wire strain gauge has gauge factor 2. If stress is 100 mega newton/m2 and Young's modulus is 200 giga newton/ m2, the percentage change in gauge resistance due to stress is, Options are ⇒ (A) 0.1, (B) 0.2, (C) 0.4, (D) 0.5, (E) , Leave your comments or Download question paper.

Question is ⇒ A resistance wire strain gauge has gauge factor 2. If stress is 100 mega newton/m2 and Young's modulus is 200 giga newton/ m2, the percentage change in gauge resistance due to stress is, Options are ⇒ (A) 0.1, (B) 0.2, (C) 0.4, (D) 0.5, (E) , Leave your comments or Download question paper. 2, the percentage change in gauge resistance due to stress is, Options are ⇒ (A) 0.1, (B) 0.2, (C) 0.4, (D) 0.5, (E) , Leave your comments or Download question paper. '/> 2, the percentage change in gauge resistance due to stress is, Options are ⇒ (A) 0.1, (B) 0.2, (C) 0.4, (D) 0.5, (E) , Leave your comments or Download question paper. '/>Previous question Next question


Q1.	A resistance wire strain gauge has gauge factor 2. If stress is 100 mega newton/m² and Young's modulus is 200 giga newton/ m², the percentage change in gauge resistance due to stress is
A.	0.1 [Correct Answer]
B.	0.2 [Wrong Answer]
C.	0.4 [Wrong Answer]
D.	0.5 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If initial value of PROD is zero and a program adds X to PROD, Y times we get the result
X + Y
XY
X / Y
X - Y

⇒ The overall noise temperature T_e, absolute temperature T and noise figure F are related as
T_e = T(F - 1)
T_e = F(T - 1)
T = T_e(F - 1)
T_e = (T)(F)

⇒ The wave applied to X plates, for ohtaining trace of voltage wave, is
sawtooth wave
sinusoidal wave
rectangular wave
either (a) or (c)

⇒

Assertion (A): For a dielectric, P = ∈₀(∈_r - 1) E.

Reason (R): Dipole moment per unit volume is called polarization of dielectric.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Consider the following statements

Thermistor is more sensitive than platinum resistance thermometer
The resistance of thermistor is solely a function of its absolute temperature whether the source of heat is external or internal
Thermistor has linear temperature-resistance relationship
Thermistor has linear negative temperature coefficient

Of the Statements, the correct statements are
1 and 2
3 and 4
1, 2, 3, 4
1, 2 and 4

⇒ An op-amp has zero gain for common mode inputs. Then CMRR =
zero
infinite
high
low

⇒ In equally tampered musical scale, an octave is divided into
12 intervals
10 intervals
7 intervals
5 intervals

⇒

Match the following:

	List I (Bit Pattern)		List II (Register pairs)
A.	00	1.	SP
B.	01	2.	B-C
C.	10	3.	D-E
D.	11	4.	H-L

A-1, B-2, C-3, D-4
A-2, B-3, C-4, D-1
A-2, B-3, C-1, D-4
A-4, B-3, C-2, D-1

⇒ A magnetron has a cylindrical cathode surrounded by an anode structure having cavities opening into interaction space by means of slots
TRUE
FALSE

⇒ Voltage series feedback (Also called series-shunt feedback) results in
increase in both I/P and O/P impedances
decrease in both I/P and O/P impedances
increase in I/P impedance and decrease in O/P impedance
decrease in I/P impedance and increase in O/P impedance

⇒ In electronic voltmeters the measuring device is a
moving coil instrument
moving iron instrument
dynamometer instrument
none of the above

⇒ The number of digit 1 present in the binary representation of 3 x 512 + 7 x 64 + 5 x 8 + 3 is
8
9
10
12

⇒ Average latency time of magnetic tape memory is of the order of
1 μ sec
1 msec
1 sec
1 minute

⇒ If V = 100 ∠ 16°, the (V) is
10 ∠ 32°
10 ∠ 8°
10 ∠ 16°
10 ∠ 4°

⇒ A voltage gain of a CE amplifier connected in collector to base configuration is 50. Collector to base resistor R_F = 1 kΩ, R_C = 4Ω, the O/P resistance R₀ =?
800 Ω
813 Ω
817 Ω
819 Ω

⇒

Match the following:

	List I		List II
A.	Flash converter ADC	1.	requires conversion time of a few μs
B.	Dual slope ADC	2.	requires DAC
C.	Successive approximation ADC	3.	minimizes the effect of power supply interference
		4.	requires complex hardware
		5.	is a tracking ADC

A-2, B-3, C-4
A-4, B-3, C-2
A-5, B-4, C-3
A-1, B-2, C-5

⇒ For wired AND connection we should use
TTL gates with active pull up
TTL gates with open collector
TTL gates without active pull up and with open collector
any of the above

⇒ When the mains supply is switched off the contents of primary computer memory are lost.
TRUE
FALSE

⇒

Assertion (A): When Diode used as rectifier the reverse breakdown voltage should not be exceeded.

Reason (R): A high inverse voltage can destroy a p-n junction.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The process of entering data into ROM is called
writing
burning
decoding
registering

⇒ An RL admittance function can also be realized as
RC admittance function
RC impedance function
LC admittance function
LC impedance function

⇒ With respect to the following 555 timer circuit what will be the value of R_A and R such that the LED turns on for a duration of 10 ms every time it receives negative trigger pulse. LED operating current = 20 mA, V_f = 1.4 V, Vo _on = 13.4 V and C = 0.22 nf
41.4 KΩ, 600 Ω
45 KΩ, 630 Ω
43.5 KΩ, 580 Ω
44.9 KΩ, 600 Ω

⇒ Karnaugh map can not be drawn when the number of variables is more than 4
TRUE
FALSE

⇒ The trapezoidal pattern of figure is obtained when examining an AM wave by an oscilloscope. Modulation factor of the wave
0.33
0.5
2
1

⇒ In one's complement 8 bit representation 11111111 represents
0
0
1
-1

⇒ For satellite communication, standard Earth stations have antenna diameters in the range of __________ metre.
27.5 to 30
10 to 15
30 to 50
5 to 10

⇒ Audio and video signals are called modulating waves.
TRUE
FALSE

⇒ In the circuit shown below, the outputs Y₁ and Y₂ for the given initial condition Y₁ = Y₂ = 1 and after four input pulses wil
Y₁ = 1, Y₂ = 0
Y₁ = 0, Y₂ = 0
Y₁ = 0, Y₂ = 1
Y₁ = 1, Y₂ = 1

⇒ An encoder converts decimal numbers to binary and other codes.
TRUE
FALSE

⇒ A network has 10 nodes and 17 branches. The number of different node pair are
7
9
10
45

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math