Question is ⇒ A reflex klystron oscillator uses, Options are ⇒ (A) one cavity resonator, (B) two cavity resonators, (C) three cavity resonators, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ A reflex klystron oscillator uses, Options are ⇒ (A) one cavity resonator, (B) two cavity resonators, (C) three cavity resonators, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A reflex klystron oscillator uses
A.	one cavity resonator [Correct Answer]
B.	two cavity resonators [Wrong Answer]
C.	three cavity resonators [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following statement : If a network has an impedance of (1 - j) as a specific frequency, the circuit would consist of series

R and C
R and L
R, L and C

Which of the statement are correct?
1 and 2
1 and 3
1, 2 and 3
2 and 3

⇒ Assuming that k is an integer what would the result of following expression
8
7
7.5
zero

⇒ Which of the following is an active device?
Transformer
Silicon controlled rectifier
Electric bulb
Loudspeaker

⇒ Data are recorded on a 2, 400 ft reel of magnetic tape at a density of 556 characters per inch. If the record length is of 100 characters and 0.75 inch of record gap, the tape utilization factor is
0.85
0.67
0.19
0.08

⇒ A Weinbridge oscillator is a
VHF oscillator
RF oscillator
microwave oscillator
audio frequency oscillator

⇒ If the poles lie in second quadrant, damping ratio is
1
less than 1
zero
more than 1

⇒ A sinusoidal signal with peak to peak amplitude of 1.536 volt is quantized into 128 levels using a mid-rise uniform quantizer. The quantization noise power is
0.768 V
48 x 10^-6 V
12 x 10^-6 V
3.072 Volt

⇒ In a radio receiver, the local oscillator is always tuned to a frequency higher than the incoming frequency to
facilitate tracking
allow permit adequate frequency coverage without switching
facilitate image frequency rejection
all of the above

⇒ The most commonly used moving iron instruments are
repulsion type
attraction type
a combination of attraction and repulsion type
none of the above

⇒ For a 16 bit computer the range of integer constants in C is
-32768 to + 32767
-32767 to + 32768
-65536 to + 65535
-65535 to + 65536

⇒ The reverse saturation current depends on the reverse bias.
TRUE
FALSE

⇒ The register set and instruction set of 8088 is similar to that of
8085
8086
partly 8085 and partly 8086
none of the above

⇒ When analysing two port networks in cascade, it is more convenient to use
z parameters
h parameters
T parameters
y parameters

⇒ Which of the following can be used as a rotating amplifier in a control system?

Amplidyne
Separately excited dc generator
Synchro
Self excited dc generator

Select the answer from the following codes:
3 and 4
1 and 2
1, 2 and 3
all

⇒ Thermistors are made of
pure metals
pure insulators
tintered mixture of metallic oxides
pure semiconductors

⇒ Consider the following statements associated with two port networks.

Z₁₂ = Z₂₁
Y₁₂ = Y₂₁
h₁₂ = h₂₁
AD - BC = 1

Which one of the statement given above are correct?
1, 2, 3
2, 3, 4
1, 3, 4
1, 2, 4

⇒ An antenna couple is used due to all of the following reasons except
to prevent reradiation of the local oscillator
to discriminate against harmonics
to make the antenna look resistive
to provide the output amplifier with the correct load impedance

⇒ Figure shows the feedback network of one of the very popular types of sinusoidal oscillators. Which one is t
Weinbridge oscillator
Hartley oscillator
Colpitt's oscillator
R-C phase shift oscillator

⇒ Which of the following can be accessed only sequentially?
Floppy disk
Hard disk
Magnetic tape
ROM

⇒ In a JK Master slave flip flop
both master and slave are positively clocked
both master and slave are negatively clocked
master is positively clocked and slave is negatively clocked
master is negatively clocked and slave is positively clocked

⇒ Which of the following material is preferred for transformer cores operating in micro wave frequency range?
Ferrites
Silicon steel
Superalloy
Copper

⇒ In a transistor β_dc is likely to vary between 100 and 400. The proper value of β_dc to be used to located Q point is
100
400
250
200

⇒ The M circle for M = 1 is the
straight line at x = - 0.5
critical point (-l, jo)
circle with r = 0.33
circle with r = 0.67

⇒ The number of TV channels which can be accommodated in a spectrum of 300 MHz is about
5
10
50
200

⇒ A CE amplifier has r_e = 6 Ω, β = 100 and a = 0.98. The input impedance is
6 Ω
100 Ω
600 Ω
98 Ω

⇒ A function will have only sine terms if
f(t) = - f(t)
f(-t) = f(t)
f(-t) = -f(t)
none of the above

⇒ In an 8085 microprocessor, the instruction CMP B has been executed while the content of the accumulator is less than that of register B, As a result.
carry flag will be set but zero flag will be reset
carry flag will be reset but zero flag will be set
both carry flag and zero flag will be reset
both carry flag and zero flag will be set

⇒ In a single phase full wave ac regulator using two thyristors only, the gate circuits of the two thyristors
must be isolated
may or may not be isolated
should be preferably, isolated
should not be isolated

⇒ A clock signal coordinates the working of different flip flops.
TRUE
FALSE

⇒ For very low frequencies, v₀/v_i in the given figure eq
1
0
∞
0.5