Question is ⇒ A reflex klystron oscillator is a, Options are ⇒ (A) low power device, (B) high power device, (C) high efficiency device, (D) both (a) and (b), (E) , Leave your comments or Download question paper.

Question is ⇒ A reflex klystron oscillator is a, Options are ⇒ (A) low power device, (B) high power device, (C) high efficiency device, (D) both (a) and (b), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A reflex klystron oscillator is a
A.	low power device [Correct Answer]
B.	high power device [Wrong Answer]
C.	high efficiency device [Wrong Answer]
D.	both (a) and (b) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A narrow band noise n(t) has symmetrical spectrum and has power density spectrum 0.2 x 10^-6. The power density of quadrature component is
0.2 x 10^-6
10^-7
4 x 10^-7
5 x 10^-8

⇒ The 8085 microprocessor is interrupted while executing MOV instruction at location 0210 H. What is the location at which contents of register D are stored
054 CH
054 DH
054 EH
054 FH

⇒ The direction of force an a conductor carrying current and lying in a magnetic field can be found by using
Fleming's left hand rule
Fleming's right hand rule
Cork screw rule
Any of the above

⇒ Fourier transform and F(jω) of a signal f(t) has the property
F(jω) = F(-jω)
F(jω) = -F(-jω)
F(jω) = F^*(jω)
F(jω) = -F^*(-jω)

⇒ The noise generated by a resistor depends upon
its resistance value
its operating temperature
both its resistance value and operating temperature
none of the above

⇒ By what name is the equation Δ . J = 0 frequency known?
Poisson's equation
Laplace's equation
Continuity equation for steady currents
Displacement equation

⇒ The current I for the netw
0 mA
10.72 mA
10.94 mA
11.32 mA

⇒ Following is a reason of distortion in communication system
external interference
random variations
insufficient Channel Bandwidth
all

⇒ In the Taylor series expansion of exp(x) + sin(x) about the point x = p, the coefficient of (x - p)² is
exp (p)
0.5 exp (p)
exp (p) + 1
exp (p) - 1

⇒ In figure, the battery has remained switched on for a long time. At t = 0 the switch is closed. The current i(t) is likely t
6
6 - 3e^-1
6 + 3e^-1
3 - 6e^-1

⇒ A pole zero pattern of a certain filter is shown in figure. This filter mus
LPF
BFP
HPF
APF

⇒ Frequency shift keying is used mostly in
telephony
telegraphy
radio transmission
none of the above

⇒ SSI refers to ICs with
less than 12 gates on the same chip
less than 8 gates on the same chip
less than 6 gates on the same chip
less than 3 gates on the same chip

⇒ It is required to measure pressure using LVDT. The additional device needed is
strain gauge
pitot tube
bourden tube
rotameter

⇒ If the voltage across the last resistor is V, and all the resistor is unity. Then V_s is give
8 V
4 V
13 V
0

⇒ Transformer coupling is mostly used in
RF amplifier
audio amplifier
both audio and RF amplifier
none of the above

⇒ The resolution of a 4 bit counting ADC is 0.5 volts. For an analog input of 6.6 volts, the digital output of the ADC will be
1011
1101
1100
1110

⇒

Assertion (A): A demultiplexer cannot be used as a decoder

Reason (R): A multiplexer selects one of many outputs whereas a decoder selects on output corresponding to coded input.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ ICs are
analog
digital
both analog and digital
mostly analog

⇒ Which synthesis procedure requires the use of mutual inductance?
Foster's synthesis
Cauer synthesis
Bott-Duffin synthesis
Brune's synthesis

⇒ Fourier transform pair are
autocorrelation and power spectral density
autocorrelation and convoloution
convolution and power spectral density
autocorrelation and energy

⇒ An amplifier has input impedance of 4 kΩ and output impedance of 80 kΩ. It is used in negative feedback circuit with 10% feedback. If open loop gain is 90, the closed loop input and output impedances are
40 kΩ and 8 kΩ respectively
4 kΩ and 80 kΩ respectively
0.4 kΩ and 800 kΩ respectively
8 kΩ and 160 kΩ respectively

⇒ A (0.75 - j50) ohm load is connected to a coaxial transmission line of Z₀ = 75 ohms at a frequency of 10 GHz Which of the following will be the best method of matching?
Connecting an inductance at the end
Connecting a short circuited stub at the load
Connecting a capacitance at some distance from the load
Connecting a short circuited stub at some specified distance from the load

⇒ For a Mod-64 synchronous counter the number of flip flops and AND gates needed is
6 and 4 respectively
4 and 6 respectively
7 and 5 respectively
5 and 7 respectively

⇒ Cassegrain feed is used with a parabolic reflection to
reduce the size of the main reflector
increase the gain of the system
increase the beamwidth of the system
allow the feed to be placed at a convenient point

⇒ Quantizing error occurs in
TDM
FDM
PCM
PWD

⇒ For the logic circuit of the given figure the simplified Boolean equa
Y = (A + B) (C + D) (E + F)
Y = A = B + C + D + E + F
ABCDEF
ABC + DEF

⇒ AM-SC stands for
Amplitude Modulated-Suppressed Carrier
Amplitude Modulated-Single Carrier
Amplitude Modulated-Synchronous Carrier
Amplitude Modulated-Self Carrier

⇒ The recently-introduces CD-ROM PC by Head Start Technologies Co. of New York enables users to view or play __________ .
vast amounts of text
graphics
music
all of the above

⇒ The F.T. of a conjugate symmetric function is always
imaginary
real
conjugate Unsymmetric
conjugate symmetric