Question is ⇒ A rectangular waveguide of internal dimensions (a = 4 cm and b = 3) is to be operated in TE11 mode. The minimum operating frequency is, Options are ⇒ (A) 6.25 GHz, (B) 6.0 GHz, (C) 5.0 GHz, (D) 3.75 GHz, (E) , Leave your comments or Download question paper.

Question is ⇒ A rectangular waveguide of internal dimensions (a = 4 cm and b = 3) is to be operated in TE11 mode. The minimum operating frequency is, Options are ⇒ (A) 6.25 GHz, (B) 6.0 GHz, (C) 5.0 GHz, (D) 3.75 GHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A rectangular waveguide of internal dimensions (a = 4 cm and b = 3) is to be operated in TE₁₁ mode. The minimum operating frequency is
A.	6.25 GHz [Correct Answer]
B.	6.0 GHz [Wrong Answer]
C.	5.0 GHz [Wrong Answer]
D.	3.75 GHz [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An amplifier without feedback has a voltage gain of 50, input resistance of 1 kΩ and output resistance of 2.5 kΩ. The input resistance of the current shunt -ve feedback amplifier using the above amplifier with a feedback factor of 0.2 is
1/11 kΩ
1/5 kΩ
5 kW
11 kW

⇒ In a CE amplifier the ac signal is increased. Which of the following will not change?
Ac base voltage
Ac collector voltage
Ac emitter voltage
Ac collector voltage and ac emitter voltage

⇒ The electric flux and field intensity inside a conducting sphere is
minimum
maximum
uniform
zero

⇒ Let JCOKE = 3 and LPEPSI = 5. Consider the statement 8
1
15
10

⇒ The method used to transfer data from I/O units to memory by suspending the memory-CPU data transfer for one memory cycle is called
I/O spooling
Cycle stealing
Line conditioning
Demand paging

⇒ If D is diagonal and F is focal length, lens angle θ is
θ = tan^-1 (D/F)
θ = 2 tan^-1 (D/F)
θ = tan^-1 (D/2F)
θ = 2 tan^-1 (D/2F)

⇒ Class-B amplifier has less efficiency compared to
class A
class B
class C
class A, AB and C

⇒ Linear diode detector utilizes
linear portion of static characteristics of diode
linear portion of dynamic characteristic of diode
square law portion of dynamic characteristics of diode
rectification property of diode

⇒ In air friction damping
the air pressure opposes the motion of piston when it is moving inwards
the air pressure opposes the motion of piston when it is moving outwards
the air pressure opposes the motion of piston both when it is moving inwards as well as outwards
the air pressure may oppose or aid the motion of piston depending on the design

⇒ The instrument used to check insulation of household wiring is
megger
ohmmeter
multimeter
high resistance voltmeter

⇒ Consider the following statements:

Acceptor level is formed very close to the conduction band.
The effective mass of the free electron is same as that of a hole.
The magnitude of the charge of a free electron is same as that of a hole.
Addition of donor impurities adds holes to the semiconductor.

Which of the above statements are correct?
1 and 3
2 and 3
2 and 4
3 and 4

⇒ In a thermocouple temperature transducer, the output voltage is usually measured by
high resistance ammeter
high resistance voltmeter
high resistance milli-voltmeter
none of the above

⇒ The current rating of dc tachogenerator is usually
small
high
medium
either (b) or (c)

⇒ As B is increased from zero to about 2T, μ_r, of a ferromagnetic material
increase
decrease
first increases then decreases
remains the same

⇒ In CE approximation, the upper end of d.c. load line is called the __________ point and the lower end is the __________ point.
Q, base
base, Q
saturation, cut off
cut off, saturation

⇒ A 4 bit synchronous counter uses flip flops with a delay time of 15 ns each. The time required for change of state is
15 ns
30 ns
45 ns
60 ns

⇒

Assertion (A): In AM carrier component remains constant in amplitude and frequency.

Reason (R): In AM the two side bands are images of each other.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The poles of an RC function
are simple and lie on jω axis
are simple and lie on negative real axis
may be complex conjugate
may be anywhere in s plane

⇒ Modulation index of a AM wave is measured using oscilloscope. The display on the CRO is as shown in figure it can be concluded t
the output wave is distorted
the output wave is under modulated
the modulation index is 100%
the modulation index is 50%

⇒

Match the following:

	List I (Characteristics)		List II (Decrease)
A.	Paramagnetic	1.	All dipoles are aligned is one preferred direction
B.	Ferromagnetic	2.	Half the dipoles are aligned in opposite direction and have equal magnitude
C.	Antiferromagnetic	3.	Half the dipoles (with equal magnitudes) are aligned in opposite direction to the other half having equal but lower magnitude
D.	Ferrimagnetic	4.	All dipoles have equal magnitude but are randomly oriented

A-4, B-3, C-2, D-1
A-4, B-1, C-2, D-3
A-2, B-1, C-4, D-3
A-2, B-3, C-4, D-1

⇒ Which of the following circuits can operate class AB for audio power output?
Emitter follower
Push pull
Cascade
Darlington pair

⇒ In push button type telephone set, pressing a button generates
one frequency
two high frequencies
two low frequencies
one low frequency and one high frequency

⇒ Read the following statements about 8085

RAL instruction rotates ACC contents left by 1 bit
When RAL instruction is executed once the binary number gets doubled
STC means set CY to 1

Which of the above statements are correct?
1 and 2 only
1, 2 and 3 only
1, 2 and 4 only
1 and 4 only

⇒

Match the following:

	List I		List II
A.	Detection of a periodic signal in noise	1.	Increase in bandwidth
B.	Recovery of a band limited signal from its uniformly sampled values	2.	Slope overload error
C.	Finer quantization of signal	3.	Nyquist rate
D.	Delta modulation	4.	Cross correlation

A-4, B-3, C-1, D-2
A-3, B-4, C-2, D-1
A-4, B-3, C-2, D-1
A-4, B-2, C-1, D-3

⇒ -8 is equal to signed binary number
10001000
1000
10000000
11000000

⇒ Transconductance indicates the
control of output voltage by input voltage
control of output current by input voltage
control of input voltage by output current
control of input current by input voltage

⇒ The material used for fuse must have
low melting point and low specific resistance
low melting point and high specific resistance
high melting point and low specific resistance
none

⇒ With which decoder it is possible to obtain many code conversions?
2 line to 4 line
3 line to 8 line
not possible with any decoder
4 line to 16 line decoder

⇒ Norton's equivalent circuit
is same as Thevenin's circuit
has no relation with Thevenin's circuit
is dual of Thevenin's circuit
is reciprocal of Thevenin's circuit

⇒ Which one is a non-causal system?
y(n) = x(2n)
y(n) = x(n/2)
y(n) = x(n/2) + x(n)
all