Question is ⇒ A rectangular waveguide measures 3 x 4.5 cm internally and has a 10 GHz signal propagated in it. Calculate the guide wavelength for dominant mode., Options are ⇒ (A) 13.5 m, (B) 3 m, (C) 88/3 m, (D) 3/88 m, (E) , Leave your comments or Download question paper.

Question is ⇒ A rectangular waveguide measures 3 x 4.5 cm internally and has a 10 GHz signal propagated in it. Calculate the guide wavelength for dominant mode., Options are ⇒ (A) 13.5 m, (B) 3 m, (C) 88/3 m, (D) 3/88 m, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A rectangular waveguide measures 3 x 4.5 cm internally and has a 10 GHz signal propagated in it. Calculate the guide wavelength for dominant mode.
A.	13.5 m [Wrong Answer]
B.	3 m [Wrong Answer]
C.	88/3 m [Wrong Answer]
D.	3/88 m [Correct Answer]
View Answer 1 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If X(z) = (1 - az^-1), and |a| < |z|, the initial value x₀ is
1
0
2
∞

⇒ The symbol shown in figure represen
P-channel MOSFET
UJT with N-type base
N-channel DEMOSFET with internal zener protection
P-channel DEMOSFET with internal zener protection

⇒ Assuming earth to be a sphere of radius 6400 km and height of a geosynchronous satellite above Earth as 36000 km, the velocity of a geosynchronous satellite is __________ km/hr.
28000
15000
36000
11100

⇒ Two RLC series circuit has same damping ratio. Circuit 1 has higher natural frequency as compared to circuit 2. Then
transients in circuit 2 will decay faster
transients in circuit 1 will decay faster
transients in both circuits will decay at the same rate
transients in any one may decay faster than in the other

⇒ A polyphase wattmeter basically consists of two wattmeters. The moving system of two wattmeters
are common
are separate
are generally common
are generally separate

⇒ In figure, V₁ = 40 V when R = 10 Ω, if R = 0, V₂ wil
40 V
30 V
20 V
10 V

⇒ A push pull amplifier balance out
odd harmonics
even harmonics
both odd as well as even harmonics
neither odd nor even harmonics

⇒ In op-amp integrating amplifier the input is feed to
inverting input
non-inverting input
both inverting and non-inverting input
either inverting or non-inverting input

⇒ The binary sum of 111010₂ and 11011₂ is
1010101₂
1011001₂
1011101₂
1111111₂

⇒ Data are recorded on a 2, 400 ft reel of magnetic tape at a density of 556 characters per inch. If the record length is of 100 characters and 0.75 inch of record gap, the tape utilization factor is
0.85
0.67
0.19
0.08

⇒ When a dc chopper feeds an RLE load, the load current, during steady state operation
remains constant
varies between maximum and minimum values
may remain constant or vary
is constant if R is constant

⇒ The purpose of incorporating a pre-selector stage in a receiver is to
provide higher selectivity
provide higher fidelity
improve linearity
larger passband

⇒ For a reactance function H(s), the slope dH (jω)/dω is
0
always positive
always negative
either 0 or positive

⇒ FF₁₆ when converted to 8421BCD =
0000 0101 0101
0010 0101 0101
1111 0101 0101
1000 0101 0101

⇒ Which of the following circuit does not need a coupling capacitor?
Resistance loaded
Transformer coupled
Impedance coupled
Single tuned

⇒ Which of the following theorems is a manifestation of law of conservation of energy?
Tellegen's theorem
Reciprocity theorem
Thevenin's theorem
Norton's theorem

⇒ Audio and video signals are called modulating waves.
TRUE
FALSE

⇒ Pilot-carrier transmission is one in which
only one sideband is transmitted
one sideband and carrier are transmitted
only two sidebands are transmitted
two sidebands as well as a trace of carrier are transmitted

⇒ The main difference between the broadside arrays and end fire arrays is that
individual elements are fed with same current in broadside arrays and of different magnitude in end fire arrays
in broadside arrays the elements are equidistant whereas in end fire array the distance between elements increases progressively
the total number of elements in broadside array is always one and a half times that of elements in end fire arrays
in broadside array the individual elements are fed in, out of phase by 180° whereas in end fire array individual elements are fed with currents of equal magnitude but their phases vary progressively along the line in such a way as to make the entire arrangement substantially unidirectional

⇒ CW Doppler radar is capable of giving accurate measurements of relative velocities.
TRUE
FALSE

⇒ When the phase velocity of an EM wave depends on frequency in any medium the phenomenon is called
scattering
polarisation
absorption
dispersion

⇒ Choose correct option
var (X + Y) = Var (X) + Var (Y)
var (X - Y) = Var (X) + Var (Y)
var (X + Y) = Var (X) x Var (Y)
Both (a) and (b)

⇒ In figure which diode will conduct and what will be the value of V_{0D₃, 1 V
D₁, 2 V
D₂, 5 V
D₁, 5 V}

⇒ In the circuit of figure, the switch is closed at t = 0 with i_L (0) = 0 and V_C (0) = 0. In the steady state n_c equ
100 v
0 v
∞
- 100 v

⇒ The maximum effective aperture of an antenna which is operating at wavelength of 2 m and has a directivity of 100 is __________ .
15.92
31.84
3.184
1.592

⇒ In a positive edge triggered JK flip flop
High J and High K produce inactive state
Low J and High K produce inactive state
Low J and Low K produce inactive state
High J and Low K produce inactive state

⇒ The low pass filter characteristic shown in figure realiza
TRUE
FALSE

⇒ In a single phase full wave regulator, the firing angles in the positive and negative half cycles are generally
equal
different
equal or different
different but sometimes equal

⇒ Consider the following statements

ECL has least propagation delay
TTL has largest fan out
CMOS has highest noise margin
TTL has lowest power dissipation

Which of these are correct?
1 and 3
2 and 4
3 and 4
1 and 2

⇒ Insertion of a dielectric material between the plates of an air capacitor
increases the capacitance
decreases capacitance
has no effect an capacitance
increases breakdown voltage