Question is ⇒ A rectangular waveguide (2.29 x 1.02) cm operates at a freq. of 11 GHz in TE<sub>10</sub> mode. If the maximum potential gradient of the signal is 5 kV/cm, then the maximum power handling capacity of the waveguide will be, Options are ⇒ (A) 31.11 mW, (B) 31.11 W, (C) 31.11 kW, (D) 31.11 MW, (E) , Leave your comments or Download question paper.

Question is ⇒ A rectangular waveguide (2.29 x 1.02) cm operates at a freq. of 11 GHz in TE<sub>10</sub> mode. If the maximum potential gradient of the signal is 5 kV/cm, then the maximum power handling capacity of the waveguide will be, Options are ⇒ (A) 31.11 mW, (B) 31.11 W, (C) 31.11 kW, (D) 31.11 MW, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A rectangular waveguide (2.29 x 1.02) cm operates at a freq. of 11 GHz in TE₁₀ mode. If the maximum potential gradient of the signal is 5 kV/cm, then the maximum power handling capacity of the waveguide will be
A.	31.11 mW [Wrong Answer]
B.	31.11 W [Wrong Answer]
C.	31.11 kW [Correct Answer]
D.	31.11 MW [Wrong Answer]
View Answer 2 -4 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The properties of FETs resemble closely to
UJT
current transformer
thyristor
thermionic valves

⇒

Assertion (A): Magnetic tape can be accessed only sequentially.

Reason (R): Magnetic tape consists of magnetised spots or tracks.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ A 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000). Then, what will be input, if the output register shows 100111 at the end of conversion.
5.85 V
6 V
5 V
10 V

⇒ Strength of space wave is not dependent on distance.
TRUE
FALSE

⇒ As the reverse voltage is increased, the depletion layer
becomes narrow
widens
remains the same
reduce to zero

⇒ In an ac circuit that delivers constant power at varying p.f., the current is
lowest when p.f. is leading
lowest when p.f. is lagging
lowest when p.f is unity
the same for all power factors

⇒ In a varistor, as the voltage increases beyond a certain value, its resistance
rapidly increases
rapidly decreases
becomes negative, i.e., varistor goes into negative resistance region
none of these

⇒ From a measurement of the rise time of the output pulse of an amplifier whose input is a small amplitude square wave, one can estimate the following parameter of the amplifier
gain bandwidth product
slew rate
upper 3 dB frequency
lower 3 dB frequency

⇒ Television receiver antenna is usually
loop type
yagi antenna
parabolic dishes
none of the above

⇒ In a TV receiver antenna the length of reflector rod
is the same as that of dipole
is less than that of dipole
is more than that of dipole
may be equal, more or less than that of dipole

⇒

Assertion (A): Microprocessor 8085 has 16 address bus lines and 8 data bus lines.

Reason (R): Address bus in 8085 is unidirectional.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The number of valence electrons in trivalent impurity is
5
4
3
1

⇒ In figure, I_D = 4 mA. Then V_{DS20 V
16 V
4 V
0.4 V}

⇒ In 8085 microprocessor, the RST 5.5 interrupt service routine start from location
0020 H
0024 H
0028 H
002 CH

⇒ For an op-amp source follower circuit
input and output voltages have same magnitude
output and input voltages are in phase
output and input voltages are in phase but have different magnitudes
output and input voltages have same magnitude and are in phase

⇒ If e = 10 sin(10⁸ t + 3 sin 10⁴ t) then carrier frequency is
0.159 MHz
1.59 MHz
15.9 MHz
159 MHz

⇒ When two coupled coils of equal self inductance are cormected in series in one way the net inductance is 12 mH and when they are connected in the other way the net inductance is 4 mH. The maximum value of inductance when they are connected in parallel is
2 mH
3 mH
4 mH
6 mH

⇒ In the given figure, the curves 1, 2, 3 are respectively
all pass, minimum phase and non-minimum phase functions
minimum phase, all pass and non-minimum phase functions
non-minimum phase, all pass and minimum phase functions
minimum phase, non-minimum phase and all pass functions

⇒ Ultra high frequency oscillators work in the range
20 Hz to 20 kHz
1 kHz to 30 kHz
30 kHz to 30 MHz
above 30 MHz

⇒ Which of the following are difficult to be fabricated in a monolithic IC?
Inductors
Large capacitors
Small capacitors
Both (a) and (b)

⇒ The simplest mixer circuit for public address system uses
fixed resistances
variable resistances
inductances
capacitances

⇒ Which of the following method cannot be used to increase the bandwidth for cascaded RF amplifier stages?
Wave traps in each stage
Stagger tuning
A shunt damping resistor across each tuned circuit
Doubled tuned transformers with tighter coupling

⇒ In a 3 phase bridge inverter with 120° mode of operation the. number of thyristors conducting at one time are
1
2
3
4

⇒

Assertion (A): A class C amplifier can also be used as frequency multiplier

Reason (R): When narrow current pulses drive a resonant circuit the output can be a near perfect sine wave

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒

Match the following:

	List I (Double Rectifier)		List II (Number of Diodes)
A.	Full wave Bridge rectifier	1.	1
B.	Half wave rectifier	2.	2
C.	Full wave rectifier using centre tapped transformer	3.	4

A-1, B-2, C-3
A-3, B-1, C-2
A-2, B-1, C-3
A-3, B-1, C-2

⇒ In a 3 phase full converter, the instantaneous output voltage can have negative part if
firing angle is less than 60°
firing angle is less than 90°
firing angle is more than 60°
firing angle is more than 90°

⇒ In figure the diode is ideal (zero cut in voltage zero forward resistance). Then the current through diod
0
0.166666666666667
0.0416666666666667
none of the above

⇒ The PAM Signal can be detected by
Band pass filter
Band stop filter
High pass filter
Low pass filter

⇒ An electromechanical closed loop control system has the following characteristics equation :s³ + 6Ks² + (K + 2)s
K = 0.528
K = 2
K = 0
K = -2528

⇒ A high level language is less efficient than machine language.
TRUE
FALSE