Question is ⇒ A rectangular wave guide is designed to propagate at the dominant mode TE<sub>10</sub> at a frequency of 5 GHz. The cut-off frequency is 0.8 of signal frequency. The ratio of the guide width to height is 2. The dimensions of the guide are, Options are ⇒ (A) 3.75 cm, 1.875 cm, (B) 4 cm, 2 cm, (C) 8 cm, 4 cm, (D) 2.54 cm, 1.27 cm, (E) , Leave your comments or Download question paper.

Question is ⇒ A rectangular wave guide is designed to propagate at the dominant mode TE<sub>10</sub> at a frequency of 5 GHz. The cut-off frequency is 0.8 of signal frequency. The ratio of the guide width to height is 2. The dimensions of the guide are, Options are ⇒ (A) 3.75 cm, 1.875 cm, (B) 4 cm, 2 cm, (C) 8 cm, 4 cm, (D) 2.54 cm, 1.27 cm, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A rectangular wave guide is designed to propagate at the dominant mode TE₁₀ at a frequency of 5 GHz. The cut-off frequency is 0.8 of signal frequency. The ratio of the guide width to height is 2. The dimensions of the guide are
A.	3.75 cm, 1.875 cm [Correct Answer]
B.	4 cm, 2 cm [Wrong Answer]
C.	8 cm, 4 cm [Wrong Answer]
D.	2.54 cm, 1.27 cm [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Some features of RF stage in good radio receivers is

It increases sensitivity by providing amplification to RF signal
It eliminates image frequency interference
It increases selectivity
It reduces noise level

Which of the above are true?
1, 2 and 3 only
1, 2 and 4 only
2, 3, 4 only
1, 2, 3, 4

⇒ The skip distance is
same for each layer
independent of frequency
independent of the state of ionisation
independent of transmitted power

⇒ Which of the following components is essential for a voltage multiplier circuit?
Resistor
Inductor
Capacitor
Both (a) and (c)

⇒ In amplitude modulation the rms value of radio frequency voltage after 40% modulation is 60 mV. If modulation is 80% the rms value after modulation will be about
50 mV
60 mV
66 mV
80 mV

⇒ Push pull amplifier is
class B
class A
class C
Class A or Class C

⇒ For an ideal 3000 Hz channel, S/N ratio is
3
1.5
4
2

⇒ From the noise point of view, bandwidth should
be large
not be too large
should be as large as possible
should be infinite

⇒ A two branch parallel tuned circuit has a capacitance C in one of the two branches and resistance R in second branchs. As C is decreased the dynamic resistance
increases
decreases
remains constant
may increases or decreases

⇒

Assertion (A): Tristate logic is used for bus oriented systems

Reason (R): The outputs of a tristate logic are 0, 1 and indeterminant.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Three point tracking can be achieved with
gang condenser
variable selectivity
paddar capacitor
any of the above

⇒ Karnaugh map can not be drawn when the number of variables is more than 4
TRUE
FALSE

⇒ An RC series circuit has R = 20 Ω and X_C = 20 Ω. Then Z =
40 Ω
28.28 Ω
20 Ω
1 Ω

⇒ As compared to an ordinary semiconductor diode, a Schottky diode
has higher reverse saturation current
has higher reverse saturation current and higher cut in voltage
has higher reverse saturation current and lower cut in voltage
has lower reverse saturation current and lower cut in voltage

⇒ If there are M equally likely and independent messages and M = 2^N where N is an integer, the information in each message is equal to
N bits
0.5 N bits
2 N bits
4 N bits

⇒ In van der walls crystals, there exists a high degree of stability of the outer electron shell.
TRUE
FALSE

⇒ The figure of merit for a logic family is
gain band width product
(propagation delay time) (power dissipation)
(fan out) (power dissipation)
(noise margin) (power dissipation)

⇒ Δ²V = - r/E is known as __________ equation
Poisson
Fourier
Laplace
Maxwell

⇒ Paper capacitors are used in power supplies for filtering.
TRUE
FALSE

⇒ The control logic for a binary multiplier is specified by a states diagram. The state diagram has four states and two inputs. To implement it by the sequence register and decoder method.
two flip-flop & 2 x 4 decoder are needed
four flip-flop & 2 x 4 decoder are needed
two flip-flop & 3 x 9 decoder are needed
four flip-flop & 3 x 9 decoder are needed

⇒ An ac circuit has an impedance of (3 + j6) ohm for fundamental. The impedance for fifth harmonic is
(15 + j 30) Ω
(15 + j 6) Ω
(3 + j 30) Ω
(3 + j 1.2) Ω

⇒ An advantage of memory interlacing is that
a larger memory is obtained
effective speed of memory is increased
cost of memory is reduced
a non-volatile memory is obtained

⇒ In an amplitude modulated waveform, the amplitude of the sideband is
independent of the carrier amplitude
independent of the modulation index
carrier amplitude x modulation index
1/2 carrier amplitude x modulation index

⇒ The signal input to a given amplifier is made up of 100 mΩ signal power and 1 mΩ noise power. The amplifier contributes an additional 100 mΩ of noise and has a power gain of 20 dB. The input signal-to noise ratio is
2
10
20
100

⇒ Which one of the following is valid integer variable in FORTRAN 77?
BRG
IBRG
VS
PEC

⇒ A minimum function has
poles and zeros on imaginary axis of s plane
no poles or zeros on imaginary axis of s plane
only poles but no zeros on imaginary axis of s plane
only zeros but no poles on imaginary axis of s plane

⇒ TV receivers use flyback switched mode power supply because
it can supply many voltage outputs
it does not require a filter choke and is cheap
it has very good regulation at all loads
both (a) and (c)

⇒ Which one of the following statements is wrong. The radar cross-section of a target?
depends on frequency
may be reduced by special coating of non-spherical target
depends on the aspect of target if it is non-spherical
is equal to actual cross-sectional area for small targets

⇒ Fourier transform of an external exponential e^jW0t
δ(f - f₀)
1
δ(f + f₀)
∞

⇒ An electrolytic capacitor can be used for
ac only
dc only
both ac and dc
high frequency ac

⇒ A 2 mH inductor with some initial current can be represented as shown below, where s is the Laplace transform variable. The value of initial curren
0.5 A
1.0 A
2.0 A
0.0 A