Question is ⇒ A presettable counter with 4 flip flops can start counting from, Options are ⇒ (A) 0, (B) 1000, (C) any number from 0000 to 1000, (D) any number from 0000 to 1111, (E) , Leave your comments or Download question paper.

Question is ⇒ A presettable counter with 4 flip flops can start counting from, Options are ⇒ (A) 0, (B) 1000, (C) any number from 0000 to 1000, (D) any number from 0000 to 1111, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A presettable counter with 4 flip flops can start counting from
A.	0 [Wrong Answer]
B.	1000 [Wrong Answer]
C.	any number from 0000 to 1000 [Wrong Answer]
D.	any number from 0000 to 1111 [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A 16 x 8 ROM stores these words in its first four locations, as given below. Which of this represents 3 CH in hexadecimal?
R₀ = 1110 0010
R₁ = 0101 0111
R₂ = 0011 1100
R₃ = 1011 1111

⇒ To protect an SCR against high di/dt we connect
a capacitance in series with SCR
a capacitance in parallel with SCR
an inductance in parallel with SCR
an inductance in series with SCR

⇒ In communication satellites, the up-link normally operates at a higher frequency than the down-link because it
gives a narrow beam shining into space
results in lesser signal attenuation
gives better beam-shaping
is easier to polarize a high frequency beam

⇒ Which 8085 instruction causes exchange of contents of stack pointer with the contents of H L register pair?
XTHL
PCHL
LHLD
MVIA

⇒

Assertion (A): The velocity factor of a line is the ratio of wave velocity on the line to speed of light.

Reason (R): If the conductors of a line are immersed in a non magnetic insulating liquid, the wave velocity increases.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The direction in a Yagi Uda antenna
is longer than the radiating element
is shorter than the radiating element
can be longer or shorter than the radiating element
does not exist

⇒ In the given figure, the curves 1, 2, 3 are respectively
all pass, minimum phase and non-minimum phase functions
minimum phase, all pass and non-minimum phase functions
non-minimum phase, all pass and minimum phase functions
minimum phase, non-minimum phase and all pass functions

⇒ In the circuit shown in figure, I_s = 4A, V_s = 4, the voltage V is give
6 V
8 V
4 V
2 V

⇒ The circuit of figure is generally employed
bridge
low-pass filter
peaking network
high-pass filter

⇒ Manganin, an alloy of copper and manganese, is used in
Soldering material
Heating elements
Ballast resistors
Standard resistances

⇒ In register index addressing mode the effective address is given by
index register value
sum of the index register value and the operand
operand
difference of the index register value and the operand

⇒ Armoured submarine cable is used
to prevent insulation breakdown due to high voltage
to protect cable at great depths.
to prevent inadverent damage due to ploughing in
for the shallow shore ends of cable.

⇒ A current of 3.18 A is flowing through resistance of 35.68 Ω. The voltage drop across resistance to the appropriate number of significant figures is
113.4624 V
113.462 V
113.46 V
113 V

⇒ Find resistance R_B to bring transistor to threshold of saturation V_CB = 0, V_BE = 0.7 V, a =
1.5 kΩ
15 kΩ
10 kΩ
1 kΩ

⇒ In a dual converter operated in circulating current mode, the circulating current flows
when load current is zero
when load current is non-zero
even when load current is zero
none of the above

⇒

Assertion (A): When reverse voltage across a p-n junction is increased, the junction capacitance decreases.

Reason (R): Capacitance of any layer is inversely proportional to thickness.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Computers use RC circuit for edge triggering.
TRUE
FALSE

⇒ In a communication receiver, a squelch circuit is normally inserted
before detector
after detector
before mixer
after power amplifier

⇒ When a substance is repelled by a magnetic field it is known as
ferromagnetic
antiferromagnetic
diamagnetic
paramagnetic

⇒ Which of the following are needed both for protection and metering?
Wattmeters
Instrument transformers
Energy meters
Power factor meters

⇒ The two conductors of a single phase transmission line suspended in air carry currents in opposite directions. The force per unit length on each conductor varies
directly as the current in either conductor
directly as the distance between the two conductors
directly as the square of the current in either conductor
inversely as the square of the distance between the two conductors

⇒ In a waveguide if TE mode exist for z direction propagation, then
E_z = 0, H_z ≠ 0
E_z = 0, H_z = 0
E_z ≠ 0, H_z = 0
E_z ≠ 0, H_z ≠ 0

⇒ A reactance function
has a pole at origin
has a zero at origin
may have a pole or zero at origin
has a pole or zero at origin and a pole or zero at infinity

⇒ A 3 phase induction motor is fed by a 3 phase ac regulator to change the stator voltage. The variation in speed will be more if
load torque is constant
load torque increases with increase in speed
load torque decreases with increase in speed
either (a) or (b)

⇒ The disturbance from adjacent power lines is known as
cross talk
cross fire
inductive disturbance
none of the above

⇒ In a CE amplifier, the output voltage is equal to product of
ac collector current and ac collector resistance
ac base current and ac collector resistance
ac emitter current and ac emitter resistance
ac collector current and source resistance

⇒ The function shown in figure, can represent a probability density function for A _______
A = 1/4
A = 1/6
A = 1/9
A = 1/2

⇒ Contents of RAM cannot be altered.
TRUE
FALSE

⇒ A sinusoidal current having peak value of 7.07 A is superimposed on dc of 5A. If a hot-wire ammeter is used to measure the combined current in the circuit, it will indicate __________ ampere.
7.07
10
12.07
2.07

⇒ A complex wave is 5 + 5 sin ωt. Its rms value is
7.07 V
5 V
10 V
6.12 V