Question is ⇒ A periodic voltage has following value for equal time intervals changing suddenly from one value to next... 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, -5, -10 etc. Then rms value of the waveform is, Options are ⇒ (A) 31 V, (B) 32 V, (C) insufficient data, (D) none of these, (E) , Leave your comments or Download question paper.

Question is ⇒ A periodic voltage has following value for equal time intervals changing suddenly from one value to next... 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, -5, -10 etc. Then rms value of the waveform is, Options are ⇒ (A) 31 V, (B) 32 V, (C) insufficient data, (D) none of these, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A periodic voltage has following value for equal time intervals changing suddenly from one value to next... 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, -5, -10 etc. Then rms value of the waveform is
A.	31 V [Correct Answer]
B.	32 V [Wrong Answer]
C.	insufficient data [Wrong Answer]
D.	none of these [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Neper is
larger than a decibel
smaller than decibel
equal to 1 decibel
none of the above

⇒ A CT is used to feed current coils of wattmeter, energy meter, power factor meter and an ammeter. Then
all the coils are in series
all coils are in parallel
the coils are in series-parallel
either (a) or (b)

⇒ The 10 MHz in the specification of CRO means that
the sweep frequency is 10 MHz
the frequency of input signal should not be more than 10 MHz
the vertical amplifier has been designed for 10 MHz
none of the above

⇒ The reverse voltage applied to a varactor diode
is less than avalanche breakdown voltage
is more than avalanche breakdown voltage
may be more or less than a avalanche breakdown voltage
is very high as compared to avalanche breakdown voltage

⇒ Two capacitors of 1 μF and 2 μF capacitance are connected in parallel across a 30 V dc battery. After the capacitors have been charged, the charges across the two capacitors will be
30 μC each
60 μC each
30 μC and 60 μC respectively
60 μC and 30 μC respectively

⇒ Which of the- following display consumes least amount of power?
LCD
LED
Fluorescent display
All display consume same power

⇒ Find V_o(t) for the following circ
0 V
5 V
3 V
2 V

⇒ The thermal resistance of a BJT is about
100° C/W
200° C/W
20° C/W
2° C/W

⇒ In an integrated circuit the SiO₂layers provide
electrical connection to external Ckt.
physical strength
isolation
conducting path.

⇒ A signum function is
zero for t greater than zero
zero for t less than zero
unity for t greater than zero
2∪(t) - 1

⇒ With the switch in STOP position, Y will be equa
0
1
CLK
none of these

⇒

Assertion (A): In digital communication data is coded prior to being transferred.

Reason (R): A number of codes for digital data processing are available.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A typical signal strength received from a geosynchronous communication satellite is of the order of a few
milliwatts
kilowatts
picowatts
watts

⇒

Match the following:

	List I		List II
A.	Output of signal generator	1.	Modulated
B.	Error signal from a synchro	2.	Digital
C.	Output of a JK flip flop	3.	Analog
D.	Signal received by radar	4.	Stoichastic

A-1, B-3, C-2, D-4
A-3, B-1, C-2, D-4
A-3, B-1, C-4, D-2
A-1, B-3, C-4, D-2

⇒ 1's complement of 11100110 is
11001
10000001
11010
0

⇒ The depletion layer in a reverse biased p-n junction is due to the presence of
electrons
holes
both electrons and holes
immobile ions

⇒ In Z_RC(s) has a pole at s = 0, the first element in second Foster realization is
R
C
R and C in series
R and C in parallel

⇒ NMOS devices have __________ switching speeds and __________ on-state resistance; as compared with PMOS devices.
slower, higher
faster, lower
faster, higher
slower, lower

⇒ A 3 input NAND gate is to be used as inverter. Which of the following will give better results?
The two unused inputs are left open
The two unused inputs are connected to 0
The two unused inputs are connected to 1
None of the above

⇒ For an ideal 3000 Hz channel, S/N ratio is
3
1.5
4
2

⇒ In a diode rectifier with a capacitance input filter, a surge current is likely to flow when the circuit is switched on. The cause of this surge current is
the non linear behaviour of diodes
the capacitor acts as a short circuit at the instant of switching,
the inductance of leads
both (a) and (b)

⇒ The function of interface circuit is
to match output conditions of driver with input conditions of load device
to match output conditions of load device with input conditions of driver
both (a) and (b)
neither (a) nor (b)

⇒ A silicon (PN) junction at a temperature of 20°C has a reverse saturation current of 10 pico Ampere. The reverse saturation current at 40°C for the same bias is approximately.
30 pA
40 pA
50 pA
60 pA

⇒ The electrical requirement on wall thickness of rectangular wave guide is
wall thickness is more than skin depth
wall thickness is less than skin depth
wall thickness is equal to skin depth
either (b) or (c)

⇒

Assertion (A): When a photoconductive device is exposed to light, its bulk resistance increases.

Reason (R): When exposed to light, electron hole pairs are generated in the photoconductive device.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Fourier transform o the function f(t) = 1 is
2p δ (ω)
p δ (ω)
δ(ω)/2p
δ(ω)/p

⇒ In a multicavity klystron amplifier the electron velocity of the order of
10 m/s
10³ m/s
10⁶ m/s
10¹² m/s

⇒ The value of capacitor C for dynamic equalising circuit of series connected thyristors is determined by
forward characteristics of thyristors
reverse recovery characteristics of thyristors
both forward and reverse recovery characteristics of thyristors
none of the above

⇒ In which frequency range is the noise figure in a transistor independent of frequency
intermediate frequencies
high frequency
low frequencies
both low and high frequencies

⇒ For the system in the given figure, the characteristic equation
s² + s(3 + 6a) + 6 = 0
s² + s(3 + 12a) + 12 = 0
s² + 3s = 0
s² + 6s = 0