Question is ⇒ A particular current is made up of two components 10A dc and sinusoidal current of peak value 14.14A. The average of resultant current is, Options are ⇒ (A) zero, (B) 24.14A, (C) 10A, (D) 14.14A, (E) , Leave your comments or Download question paper.

Question is ⇒ A particular current is made up of two components 10A dc and sinusoidal current of peak value 14.14A. The average of resultant current is, Options are ⇒ (A) zero, (B) 24.14A, (C) 10A, (D) 14.14A, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A particular current is made up of two components 10A dc and sinusoidal current of peak value 14.14A. The average of resultant current is
A.	zero [Wrong Answer]
B.	24.14A [Wrong Answer]
C.	10A [Correct Answer]
D.	14.14A [Wrong Answer]
View Answer 1 -13 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The gain of a source follower is unity.
TRUE
FALSE

⇒ An incremental model of a solid state device is one which represents the
ac property of the device at desired operating point
dc property of the device at all operating points
complete ac and dc behaviour at all operating points
ac property of the device at all operating points

⇒ In Bode plots, frequency is plotted on log scale.
TRUE
FALSE

⇒ The input to an op-amp integrating amplifier is a constant voltage. The output will be
a constant voltage
a sawtooth wave
a ramp
ac voltage

⇒ The total power radiated from an antenna system is determined by imagining that the antenna is at the centre of a very large
sphere
rectangle
square
ellipse

⇒ A series RLC circuit is supplied from a variable frequency ac source. The resonant frequency is ω₀. The voltage across C is maximum at a frequency
equal to ω₀
slightly less than ω₀
slightly more than ω₀
none of the above

⇒ Consider the following statements

In 8085 address and data buses are multiplexed.
In Z 80 address and data buses are multiplexed
In Z 80 address and data buses are not multiplexed.
Z 80 has 16 bit address bus and 8 bit data bus.

Which of the above statements are correct?
1 and 2 only
1, 3 and 4 only
1, 2 and 4 only
2 and 4 only

⇒ The number of protons in a silicon atom are
4
8
12
14

⇒ Which inductor is used at high frequencies?
Cast iron cored
Sheet steel cored
Iron alloy cored
Ceramic cored

⇒ The signal y(t) = x(- t) is __________ .
causal
non-causal
depends on x(t)
none of these

⇒ The number of leads in an SCR are :
2
3
4
5

⇒ In a purely resistive circuit the instantaneous power varies from zero to maximum twice in each cycle.
TRUE
FALSE

⇒ Lead mounting for SCR is used for
rating less than mA
rating about 1 A or less
rating of 20 A or less than 20 A
rating 100 A or less

⇒ In the circuit of figure the switch is open for a long time, At t = 0 the switch is closed. At t = 0⁺ the current supplied by batter
0.25
0.125
3.6 A
1.5 A

⇒ For measuring a very high resistance we should use
Kelvin's double bridge
Wheatstone bridge
Meggar
Either (a) or (c)

⇒ A retriggerable one shot is one which
can be triggered only once
has two quasi stable states
can not be retriggered till the complete pulse appears at output
can be retriggered while the output is being generated

⇒ PAL system was proposed first in
USA
Japan
England
Germany

⇒ The braking torque in single phase energy meter is proportional to speed of disc.
TRUE
FALSE

⇒ A silicon controlled switch has :
2 leads
3 leads
4 leads
5 leads

⇒ An inverting amplifier has R₁ = 10 kΩ, and R_f = 150 kΩ then the O/P voltage, if input voltage V_i = 1 volt.
-15 V
-10 V
15 V
-14 V

⇒ Which of the following READ statements is correct in FORTRAN 77?
READ *, HONEY (I), I = 1, 5
READ *, (HONEY (I), I = 1, 5)
READ * HONEY I, I = 1, 5
READ HONEY I, I = 1, 5

⇒ If A = 10 + j then log_eA is
14.14 ∠45°
200 ∠45°
2.65 + j45°
2.65 + j0.785

⇒ The density of states (i.e. number of states per eV per m³) in the conduction band for energy level E is proportional to
E
E
E^1.5
E²

⇒ If the minimum range of a radar is to be doubled, the peak power has to be increased by a factor of
2
4
8
16

⇒ If the secondary burden of a CT 15 VA and secondary current is 5 A, the load impedance of CT is
0.6 Ω
5 Ω
6 Ω
10 Ω

⇒ An RLC series circuit is excited by an ac voltage v = 1 sint. If L = 10 H, C = 0.1 F peak value of voltage across R is
0.707 V
1 V
1.44 V
indeterminate as value of R is not given

⇒ The signal to noise ratio in telemetry should be better than
5 db
10 db
25 db
60 db

⇒ Consider the following statements about a moving iron instrument

It is an unpolarised instrument.
It has permanent magnet.
It has a fixed coil.
It has two iron vanes.

Of these statements
1, 2, 3 are correct
1, 2, 4 are correct
1, 3 and 4 are correct
2, 3, 4 are correct

⇒ A small signal source v_i(t) = A cos 20t + B sin10⁶t is applied to a transistor amplifier as shown below. The transistor has β = 150 and h_ie = 3 kΩ. Which expression best approximates V₀(t<
v₀(t) = -1500 (A cos 20t + B sin 10⁶t)
v₀(t) = -150 (A cos 20t + B sin 10⁶t)
v₀(t) = -1500 B sin 10⁶t
V₀(t) = -1500 sin 10⁶t

⇒ In an ac single phase energy meter, the potential coil is put on
both side limbs, of upper magnet
central limb of upper magnet
one side limb of upper magnet
either (a) or (b)

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math