Question is ⇒ A number is expressed in binary 2's complement as 10011 decimal equivalent value is, Options are ⇒ (A) 19, (B) 13, (C) -19, (D) -13, (E) , Leave your comments or Download question paper.

Question is ⇒ A number is expressed in binary 2's complement as 10011 decimal equivalent value is, Options are ⇒ (A) 19, (B) 13, (C) -19, (D) -13, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A number is expressed in binary 2's complement as 10011 decimal equivalent value is
A.	19 [Wrong Answer]
B.	13 [Wrong Answer]
C.	-19 [Wrong Answer]
D.	-13 [Correct Answer]
View Answer 3 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following noise becomes of great importance at high frequencies?
Shot noise
Agitation noise
Flicker noise
Transit time noise

⇒ The spectrum of the white noise and an impulse function is similar in following aspects
both have similar magnitude spectrum
both have similar magnitude and Phase spectrum
no relation
similar phase spectrum

⇒ Speeds of sound and radio waves are equal.
TRUE
FALSE

⇒ If the number of information bits is m, the number of parity bits p in the Hamming code is given by equation
2^p = m + p + 1
2^p ≥ m + p + 1
2^P = m + p
2^p ≥ m + p

⇒ Consider the following BJT circ
2.46 kΩ
2.88 kΩ
200 Ω
18.48 Ω

⇒ Which of the following is correct?
Speed torque characteristics of permanent magnet dc servomotor is more flat than that of wound field dc servomotor
Speed torque characteristics of wound field dc servo- motor is more flat than that of permanent magnet dc servo motor
Speed torque characteristics of wound field and permanent magnet dc servomotor are equally flat
None of the above

⇒ In a centre tap full wave rectifier, 50 V is the peak voltage between the centre tap and one of the ends of the secondary. The maximum voltage across the reverse biased diode will be
100 V
72 V
50 V
38 V

⇒ At millimeter wavelength the favoured mode in circular wave guide is
TE₀₁
TE₁₁
TE₂₀
TE₂₁

⇒ If there are M equally likely and independent messages and M = 2^N where N is an integer, the information in each message is equal to
N bits
0.5 N bits
2 N bits
4 N bits

⇒ Which of the following is not a valid logical expression in Pascal?
A > = B
A < = B
A = < B
A < > B

⇒ A number is expressed in binary 2's complement as 10011 decimal equivalent value is
19
13
-19
-13

⇒ A reflex klystron oscillator is a
low power device
high power device
high efficiency device
both (a) and (b)

⇒ The equivalent inductance measured between the terminals 1 and 2 for the circuit shown in the figur
L₁ + L₂ + M
L₁ + L₂ - M
L₁ + L₂ + 2M
L₁ + L₂ - 2M

⇒ A 16 x 8 ROM stores these words in its first four locations, as given below. Which of this represents 3 CH in hexadecimal?
R₀ = 1110 0010
R₁ = 0101 0111
R₂ = 0011 1100
R₃ = 1011 1111

⇒ Which of the following is true as regards photo emission?
Velocity of emitted electrons is dependent on light intensity
Rate of photo emission is inversely proportional to light intensity
Maximum velocity of electron increases with decreasing wave length
Both holes and electrons are produced

⇒ A clock signal driving a 6-bit ring counter has a frequency of 1 MHz. How long is each timing bit high?
1 ms
2 ms
3 ms
6 ms

⇒ A 200 Hz sound wave is to be transmitted by a 1000 kHz radio wave using frequency modulation. The instantaneous frequency variation will be
100 times a second
200 times a second
400 times a second
1000 times a second

⇒ A 4 bit ripple counter uses flip flops with propagation delay of 50 ns each. The maximum clock frequency which can be used is
5 MHz
10 MHz
20 MHz
25 MHz

⇒ In a series ac circuit a voltage of 20 V at 25 Hz causes a current of 0.20 A, while the same voltage at 75 Hz causes a current of 0.12 A. The circuit consists of
R and C in parallel
R and C in series
R and L in series
either (a) or (b)

⇒ In an R-C series circuit excited by a voltage E, the charge across capacitor at t = 0⁺ is
0
CE
CE (1 - e^-t/RC)
none of the above

⇒ Which mode has the minimum cutoff frequency in rectangular wave guides?
TE₁₁
TE₁₀
TE₀₁
TE₂₀

⇒ A circuit is replaced by its Thevenin's equivalent to find current through a certain branch. If V_TH = 10 V and R_TH = 20 Ω, the current through the branch
will always be 0.5 A
will always be less than 0.5 A
will always be equal to or less than 0.5 A
may be 0.5 A or more or less

⇒ If F(jω) is the Fourier transform of f(t), then
£ f(- t) = F(jω)
£ f(- t) = F* (jω)
£ f(- t) = F(- jω)
£ f(- t) = F* (- jω)

⇒ When a wave reaches an open circuit
the voltage at termination is doubled the incident voltage
the current at termination is doubled the incident voltage
the voltage at termination is zero
both V and I at termination are doubled the incident voltage and current

⇒ Which of the following is error correcting code?
EBCDIC
Gray
Hamming
ASCII

⇒ The moving iron instruments are generally repulsion type.
TRUE
FALSE

⇒ The accuracy of an instrument is determined by
closeness of indicated value to the actual value
repeatability of measured value
speed with which the reading approaches final value
least value which can be measured

⇒ A function table is required in very large numbers the memory most switched for this purpose would be
ROM
PROM
EPROM
EAROM

⇒ Which one is correct option?
TEM mode exist in free space of infinite boundary
TEM mode exist in two conductor pattern system for finite-boundary
TEM mode exist in waveguide only
Both (a) and (b)

⇒

Assertion (A): A good algorithm should be fast, require minimal computer memory and time.

Reason (R): Many times an algorithm is prepared in the form of a flow chart.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct