Question is ⇒ A notch filter is sometimes used in communication receivers to, Options are ⇒ (A) reduce receiver gain at some specific frequency, (B) increase receiver gain at some specific frequency, (C) made selectivity more precise, (D) spread the bandwidth, (E) , Leave your comments or Download question paper.

Question is ⇒ A notch filter is sometimes used in communication receivers to, Options are ⇒ (A) reduce receiver gain at some specific frequency, (B) increase receiver gain at some specific frequency, (C) made selectivity more precise, (D) spread the bandwidth, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A notch filter is sometimes used in communication receivers to
A.	reduce receiver gain at some specific frequency [Correct Answer]
B.	increase receiver gain at some specific frequency [Wrong Answer]
C.	made selectivity more precise [Wrong Answer]
D.	spread the bandwidth [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a single phase full wave controlled rectifier using centre tap transformer, the voltage across each half of secondary is V_m sin ωt. The peak inverse voltage is
2 V_m
V_m
0.5 V_m
0.25 V_m

⇒

Assertion (A): An on off controller gives rise to oscillation of the output between two limits.

Reason (R): Location of a pair of poles on jω axis gives rise to self sustained oscillations in the output.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Which of these devices can conduct in both directions?
SCR
SUS
SBS
UJT

⇒ As the number SWG increases, area of cross-section decreases.
TRUE
FALSE

⇒ When an electron breaks a covalent bond and moves away,
a hole is created
a proton is also lost
atom becomes an ion
rest of the electron move at a faster rate

⇒ The turn off time of a bipolar transistor is about
0.5 ns
10 ns
70 ns
150 ns

⇒ Inverters find applications in
HVDC transmission
UPS
variable speed ac drives
all of the above

⇒ A coaxial line has L = 500 nH/m and C = 50 pF/m. The characteristic impedance is
500 Ω
250 Ω
100 Ω
50 Ω

⇒ For maximum output the width of air gap of audio head should be
equal to wavelength
half the wavelength
one quarter the wavelength
very small as compared to wavelength

⇒ For a nonlinear resistance
v-i plot is not a straight line
resistance increases as current increases
resistance decreases as current increases
current decreases as voltage increases

⇒ In a TV receiver the video IF amplifier provides a gain of about
5 dB
20 dB
60 dB
200 dB

⇒ The current due to thermionic emission is proportional to
T
T²
T³
T⁴

⇒ In a radar system the solution to blind speed problem is to
use MTI
use monopoles
vary PRF
change Doppler frequency

⇒ Which layer is least important in high frequency propagation?
D layer
E layer
F₁ layer
F₂ layer

⇒ The characteristic impedance of a twin wire feeder used for TV signals is about
1000 ohm
500 ohm
300 ohm
100 ohm

⇒ In a 3 phase semiconverter, the freewheeling diode comes into operation only if firing angle
is zero
is 60°
is more than 60°
is more than 90°

⇒ An ammeter of 0-25 A range has a guaranteed accuracy of 1% of full scale reading. The current measured is 5 A. The limiting error is
0.02
0.025
0.04
0.05

⇒ During day time ionosphere consist of
D, E, F₂ layers
D, E, F layers
D, E, F₁, F₂ layer
none

⇒ In a specimen of cast iron, a field strength of 400 AT/m cause a flux density of 0.6 T. In a specimen of silicon steel, the same value of H would cause B to be
0.6 T
more than 0.6 T
less than 0.6 T
0.6 T or less than 0.6 T

⇒ An XOR gate with 8 variable is as foll
255
127
128
256

⇒ Consider the following expressions which indicate the step or impulse response of an initially relaxed system

[5 - 4 e^-2t] u(t)
[e^-2t + 5] u(t)
d(t) + 8 e^-2t u(t)
d(t) + 4 e^-2t u(t)

Those which correspond to the step and impulse response of the same system include
1 and 3
1 and 4
2 and 4
2 and 3

⇒ In a radio receiver, if the intermediate frequency is too low
Image-frequency rejection will improve
Selectivity will be too sharp
The frequency selectivity of the local oscillator will have to be lowered
All of the above

⇒ Even at room temperature, an intrinsic semiconductor has some holes. These holes are due to
electron
doping
thermal energy
free electrons

⇒ Consider the following stateme
1, 2 and 3
1 and 2 only
2, 3 and 4
2, 3 and 4

⇒ The time constant of an R.C. circuit increases if the value of resistance is
increased
decreased
either of the above
none of the above

⇒ During playback the take up reel is
in clockwise motion
in anticlockwise motion
either clockwise or anticlockwise motion
none of the above

⇒ The inverse of given Laplace transfor
sin t
cos t
e^t
e^2t

⇒ The amplitude of a random signal uniformly distributed between - 5 V and
0.0333 V
0.05 V
0.0667 V
0.10 V

⇒ Resistivity of electrical conductors is most affected by
Pressure
temperature
composition
ageing

⇒ An antenna is synonymous to a
generator
transformer
regulator
reflector