Question is ⇒ A noiseless 3 kHz channel can't transmit binary bit at the rate, Options are ⇒ (A) 12000 bps, (B) 1000 bps, (C) 6000 bps, (D) 3000 bps, (E) , Leave your comments or Download question paper.

Question is ⇒ A noiseless 3 kHz channel can't transmit binary bit at the rate, Options are ⇒ (A) 12000 bps, (B) 1000 bps, (C) 6000 bps, (D) 3000 bps, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A noiseless 3 kHz channel can't transmit binary bit at the rate
A.	12000 bps [Correct Answer]
B.	1000 bps [Wrong Answer]
C.	6000 bps [Wrong Answer]
D.	3000 bps [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The main reason why Ni-Zn ferrites are used for audio and T.V. transformers is that
they have large saturation magnetization
they are easy to fabricate by rolling
they are totally free from pores and voids
they have a high electrical resistivity

⇒ Nichols chart consists of
constant magnitude loci
constant phase angle loci
magnitude and phase angle loci in log-magnitude versus phase diagram
none of the above

⇒ The advantage of using crystal oscillator is that it
requires low d.c. supply voltage
works at high frequency
gives high output voltage
gives constant frequency of oscillations

⇒

Assertion (A): Rochelle salt and Barium titanate are both ferroelectric.

Reason (R): Ferroelectric materials exhibit hysteresis effect.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The op amp is used in
A/D converters
D/A converters
both (a) and (b)
shift registers

⇒ A voltage v = 100 sin ωt + 10 sin 5 ωt is applied to a pure capacitor having capacitance of 1 μF. If ω = 314 rad/sec, the current through the capacitor is
0.0314 cos 314 t + 0.0157 cos 1570 t
0.0314 sin 314 t + 0.0157 sin 1570 t
0.0314 cos 314 t + 0.0314 cos 1570 t
0.0157 cos 314 t + 0.0157 cos 1570 t

⇒ An RLC series circuit is fed form 100 V ac supply. Inductance is 1 H and Q = 7.5. At resonance, the voltage across inductance is
750 V
100 V
about 13.5 V
1500 V

⇒ Leak type bias is used in a plate-modulated class C amplifier to
prevent tuned circuit damping
prevent over modulation
increase the bandwidth
prevent excessive grid current

⇒ In FM reception, amplitude disturbances due to static change
reduce the signal frequencies
increase the signal frequencies
disturb the signal frequencies
do not affect the signal frequencies

⇒ In the generic microprocessor
instruction cycle time period is shorter than machine cycle time period
machine cycle time period is shorter than instruction cycle time period
instruction cycle time period is exactly half of machine cycle time period
instruction cycle time period is exactly equal to machine cycle time period

⇒ As per Hartley law
redundancy is essential
it is necessary to use only binary codes
maximum rate of information transmission depends on the channel bandwidth
the maximum rate of information depends on depth of modulation

⇒ A 4 cm by 3 cm rectangular waveguide with air cavity, is operating at 12 GHz with TE₁₁ mode. The cut-off frequency is:
6.25 GHz
4.75 GHz
1.5 GHz
8.75 GHz

⇒ A cable has an insulation resistance of 10¹⁰ ohms. If the length is doubled, the insulation resistance will be
2 x 10¹⁰ Ω
0.5 x 10¹⁰ Ω
10¹⁰ Ω
4 x 10¹⁰ Ω

⇒ The atomic number of silicon is 14. It can be therefore concluded that
a silicon atom contains 14 protons
a silicon atom contains 14 neutrons
a silicon atom contains 14 electrons
all of the above

⇒ The characteristic equation of a feedback control system is given by s³ + 5s² + (K + 6)s + K
(- 3, 0)
(- 2, 0)
(- 1, 0)
(2, 0)

⇒ Which of the following waves do not exist in waveguides?
TE waves
TM waves
TE and TM waves
TEM waves

⇒ Four messages band limited to W, W, 2W and 3W respectively are to be multiplex using Time Division Multiplexing (TDM). The minimum bandwidth required for transmission of this TDM signal is
W
3W
6W
7W

⇒ A peak responding ac voltmeter using a half wave rectifier has been calibrated to read 1 V for 1 V rms sine wave input. If input is 1 V dc the reading will be
0.707 V
0.707 or 0 V
1.414 V
1.414 or 0 V

⇒ Which of the following instruments has non-linear scale?

Moving coil instrument
Moving iron instrument
Electrostatic instrument
Rectifier instrument

Select the answer as per following codes
2 only
2 and 3 only
2, 3 and 1
1, 2, 3 and 4

⇒ With respect to the differential amplifier configuration shown below, the differential gain A_d will
273.63
213.63
113.63
233.63

⇒ The total power radiated from an antenna system is determined by imagining that the antenna is at the centre of a very large
sphere
rectangle
square
ellipse

⇒ A ring counter with 5 flip-flops will have __________ states.
5
10
32
Infinite

⇒ Which of the following 8085 instructions does not belong to arithmetic group?
SHLD addr
SUI data
ADCM
INR r

⇒ Gain stability in an oscillator can bs achieved by
providing negative feedback
providing positive feedback
using low Q circuits
controlling the gain

⇒ Which of the following is correct?
Voltages across a capacitance can change instantaneously
Voltages across a capacitance cannot change instantaneously
Charge across a capacitance is always constant
Charge across a capacitance can change instantaneously

⇒ Consider the following operation in a computer

Multiplication of scalar
Iversion of matrix
Printing a line of 120 characters on a printer

Which of the above is a subroutine?
1 and 2 only
1 and 3 only
1, 2 and 3
2 only

⇒

Assertion (A): A parallel resonant circuit is also called anti-resonant circuit.

Reason (R): In a parallel resonant circuit impedance is maximum at resonance.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ If one wants to design a binary counter, preferred type of flip-flop is
D-type
SR type
Latch
JK type

⇒ If the energy gap of a semiconductor is 1.1 eV, then it would be.
opaque to the visible light
transparent to the visible light
transparent to the ultraviolet radiation
opaque to the infrared radiation

⇒ Which of the following terms is not applicable to Yagi-Uda array?
High gain
Folded dipole
Parasitic elements
Good bandwidth