Question is ⇒ A network contains only independent current source and resistors. If the values of all resistors are doubled, the value of the node voltage, Options are ⇒ (A) will become half, (B) will remain unchange, (C) will become one third, (D) cannot be determined unless the circuit configuration and the values of the resistors are known, (E) , Leave your comments or Download question paper.

Question is ⇒ A network contains only independent current source and resistors. If the values of all resistors are doubled, the value of the node voltage, Options are ⇒ (A) will become half, (B) will remain unchange, (C) will become one third, (D) cannot be determined unless the circuit configuration and the values of the resistors are known, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A network contains only independent current source and resistors. If the values of all resistors are doubled, the value of the node voltage
A.	will become half [Wrong Answer]
B.	will remain unchange [Wrong Answer]
C.	will become one third [Correct Answer]
D.	cannot be determined unless the circuit configuration and the values of the resistors are known [Wrong Answer]
View Answer 3 -24 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Shifting digits from left to right and vice versa is needed in
storing numbers
arithmetic operations
counting
storing and counting

⇒ A point charge of 6 μC is located at the origin, uniform line charge density of 180 nC/m of 8 m length lies along the x axis and a uniform sheet of charge equal to 25 nC/m² of area p x 4² lies in the z = 0 plane. Calculate total electric flux leaving the surface of sphere of 4 m radius centered at origin.
86.97 μC
8.697 nC
8.697 μC
86.97 nC

⇒ Magnetic deflection is inversely proportional to
voltage
(voltage)^0.5
(voltage)^1.5
(voltage)²

⇒ In VHS format each video head is tilted from azimuth by
20°
10°
6°
1°

⇒ An R-C coupled amplifier has mid-frequency gain of 200 and a frequency response from 100 Hz to 20 kHz. A negative feedback network with β = 0.2 is incorporated into the amplifier circuit, the Bandwidth will be
50 kHz
20 kHz
100 kHz
infinite

⇒

Assertion (A): In a BCD to 7 segment decoder the number of outputs active at one time is always the same.

Reason (R): A decoder can be used to interface BCD input to LED display.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ For the wave shown in figure, the average valu
14.14 A
15 A
17.17 A
19.19 A

⇒ An ideal op-amp has zero slew rate.
TRUE
FALSE

⇒ A first order element yields almost exact duplication only for constant or slowly varying phenomenon.
TRUE
FALSE

⇒ For a NAND SR latch of input is the normal resting state of inputs is
S = R = 1
S = 0, R = 1
S = 1, R = 0
S = R = 0

⇒ Which quantity controls the effectiveness of LED in emitting light?
Applied voltage
Current
Extent of doping
Temperature

⇒

Assertion (A): In a parallel in-serial out shift register data is loaded one bit-at a time

Reason (R): A serial in-serial out shift register can be used to introduce a time delay.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Operating point signifies that
zero signal I_C and V_BE
zero signal I_C and V_CE
zero signal I_B and V_CE
zero signal I_C, V_CE

⇒ Which of the following are the properties of a medium?
Permeability, flux, magnesium
Permittivity, permeability, insulation
Permeability, resistivity, conductivity
Permittivity, permeability, conductivity

⇒ At resonance the network function magnitude will be
k/a
k/b
c
k/a + b

⇒ The 2's complement representation of the decimal number -4 is
100
1100
1011
1010

⇒ A lag compensator provides attenuation in
very low frequency range
low frequency range
high frequency range
none of the above

⇒

Assertion (A): In a BJT base current is very small.

Reason (R): In a BJT recombination in base region is high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ As the temperature increases the mobility of electrons __________ .
decreases because the number of carries increases with increased collisions
increases because the number of carries decreases with decreased collisions
remains same
none of the above

⇒ In CE configuration, the output characteristics of a bipolar junction transistor is drawn between
I_C and V_CB
I_E and V_CB
I_C and V_CE
I_E and V_CE

⇒ Maxwell's divergence equation for the magnetic field is given as
∇ . B = 0
∇² . B = 0
∇ . B = constant
∇² . B = constant

⇒ A plot of modulation index vs carrier amplitude yields a
horizontal line
vertical line
parabola
hyperbola

⇒ Let JCOKE = 20 and LPEPSI =15. Consider the statement 25
23
15
17

⇒

Assertion (A): The reverse current in a p-n junction is nearly constant.

Reason (R): The reverse breakdown voltage of a p-n diode depends on the extent of doping.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Figure given below shows the internal schematic of a TTL AND-OR Invert (AOI) gate, For the input shown in the given figure, the output
0
1
AB
AB

⇒ Which of the following instructions in 8085 does not belong to data transfer group?
L X I rp, data 16
MOV M, r
MVIM, data
ADC M

⇒ ∇² is
vector
scalar
depend on direction
none

⇒ What is typical bandwidths of a 2-wire telephone line?
300 Hz to 3.4 kHz
20 Hz to 4 kHz
dc to 4 kHz
20 Hz to 20 kHz

⇒ Transverse electric (TE) waves have
electric field component E in the direction of propagation
magnetic field component H in the direction of propagation
magnetic field component H in the direction of propagation and no component of electric field E in this direction
electric field component E in the direction of propagation and no component of magnetic field H in this direction

⇒ If the ratio p(s)/q(s) represents a transfer function then
the degree of p(s) may be as small as zero, independent of degree of q(s)
the degree of p(s) and q(s) must be equal
the degrees of p(s) and q(s) must not be equal
the degrees p(s) and q(s) must differ by at least two