Question is ⇒ A multivibrator generates, Options are ⇒ (A) sinusoidal waveforms, (B) non-sinusoidal waveforms, (C) both (a) and (b), (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ A multivibrator generates, Options are ⇒ (A) sinusoidal waveforms, (B) non-sinusoidal waveforms, (C) both (a) and (b), (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A multivibrator generates
A.	sinusoidal waveforms [Correct Answer]
B.	non-sinusoidal waveforms [Wrong Answer]
C.	both (a) and (b) [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 2 -3 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Spontaneous magnetisation is characteristic of ferromagnetic materials.
TRUE
FALSE

⇒ A memory chip has 65536 cells in it. Then
time required to access cell is same as that to access cell 65536
time required to access cell is less than that required to access cell 65536
time required to access cell is more than that required to access cell 65536
either (a) or (b)

⇒

Assertion (A): The inductance of an iron cored solenoid is not constant.

Reason (R): BH curve of an iron specimen is non-linear.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In given figure a silicon diode is carrying a constant current of 1 mA. When the temperature of the diode is 20°C, V_D is found to be 700 mV. If the temperature rises to 40°C, V_D becomes approximately equa
747 mV
660 mV
680 mV
700 mV

⇒ The drift velocity of electrons and holes is proportional to electric field strength.
TRUE
FALSE

⇒

Assertion (A): A demultiplexer cannot be used as a decoder

Reason (R): A multiplexer selects one of many outputs whereas a decoder selects on output corresponding to coded input.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Adder is a combinational logic circuit.
TRUE
FALSE

⇒ In a network
the number of tree branches is always less than the number of links
the number of tree branches is always more than the number of links
the number of tree branches and links are always equal
the number of tree branches has no relation with the number of links

⇒ Which of the following form of angle modulation in this? If e = 10 sin(10⁸ t + 3 sin 10⁴ t)
AM
FM
AM or FM
AM or PCM

⇒ An ideal op-amp requires
zero input offset voltage
low input offset voltage
high input offset voltage
infinite input offset voltage

⇒

Match the following:

	List I		List II
A.	T (Reflection coefficient) = 0	1.	(Z_L - Z_o)/(Z_L + Z_o)
B.	T = - 1	2.	Z_L = Z_o
C.	T = + 1	3.	Z_L = 0
D.	- 1 < T < + 1	4.	Z_L = ∞

A-2, B-3, C-4, D-1
A-2, B-4, C-1, D-3
A-1, B-2, C-3, D-4
A-3, B-2, C-4, D-1

⇒ In a transistor β_dc is likely to vary between 100 and 400. The proper value of β_dc to be used to located Q point is
100
400
250
200

⇒ Which of the following noise does not occur in transistors?
Partition noise
Shot noise
Flicker noise
Resistance noise

⇒ A zener diode is used in
voltage regulator circuit
amplifier circuits
both voltage regulator and amplifier circuit
none of the above

⇒ Which of the following is not necessarily the advantages of a push pull amplifier?
It gives more output
It removes odd a well as even harmonics
There is no effect of ripple of the power supply
It consumes least power

⇒ In solids the current flow is due to electrons only.
TRUE
FALSE

⇒ An average response rectifier type electronic voltameter has a d.c. voltage of 10 V applied to it. What is the meter reading?
7.1 V
10 V
11.1 V
22.2 V

⇒ In figure, the value of R shoul
5 kΩ
50 kΩ
20 kΩ
10 kΩ

⇒ Consider the Boolean expression X = ABCD + ABCD + ABCD + ACBD The simplified form of X is
C + D
BC
CD
B

⇒ While calculating Norton's resistance, all current sources are short circuited.
TRUE
FALSE

⇒ The circuit shown in figure conv
BCD to binary code
binary to excess-3 code
excess-3 to Gray code
gray to binary code

⇒ When a potential is applied across an intrinsic semiconductor, holes flow
towards positive terminal
away from positive terminal
in the external circuit only
none of the above

⇒ Which of the following 8085 instructions does not belong to arithmetic group?
SHLD addr
SUI data
ADCM
INR r

⇒ The counter in the given figur
Mod 3
Mod 6
Mod 8
Mod 7

⇒ To couple a coaxial line to a parallel wire line it is best to use
slotted line
balun
directional coupler
λ/4 transformer

⇒

Assertion (A): Rochelle salt and Barium titanate are both ferroelectric.

Reason (R): Ferroelectric materials exhibit hysteresis effect.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ 110.11₂ x 110₂ = __________ ₁₀
40.5
30.5
20.5
10.5

⇒ The efficiency of a full wave rectifier using centre tapped transformer is twice that in full wave bridge rectifier.
TRUE
FALSE

⇒ An audio signal is band limited to 4 kHz. It is sampled at 8 kHz. What will be the spectrum of the sampled signal?
-4 kHz to 4 kHz
-8 kHz to 8 kHz
every 4n kHz repeating
every ± 8 kHz and operating as well as at zero (k integer)

⇒ In a transistor operating in forward active mode
depletion layer between emitter and base is thin and that between base and collector is also thin
both depletion regions are thick
depletion layer between emitter and base is thin and that between base and collector is thick
depletion layer between emitter and base is thick and that between base and collector is thin