Question is ⇒ A moving iron voltmeter reads 250 V when connected to 250 V dc. If connected to 250 V 50 Hz, the voltmeter reading is likely to be, Options are ⇒ (A) 250 V, (B) 252 V, (C) 248 V, (D) 210 V, (E) , Leave your comments or Download question paper.

Question is ⇒ A moving iron voltmeter reads 250 V when connected to 250 V dc. If connected to 250 V 50 Hz, the voltmeter reading is likely to be, Options are ⇒ (A) 250 V, (B) 252 V, (C) 248 V, (D) 210 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A moving iron voltmeter reads 250 V when connected to 250 V dc. If connected to 250 V 50 Hz, the voltmeter reading is likely to be
A.	250 V [Wrong Answer]
B.	252 V [Wrong Answer]
C.	248 V [Correct Answer]
D.	210 V [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a broadcast superheterodynes receiver having no RF amplifier, the loaded Q of the antenna coupling circuit is 100. If the intermediate frequency is 455 kHz. In receivers operating upto the limit of shortwave broadcasting the local oscillator often used is
Armstrong oscillator
Colpitts oscillator
Clapp oscillator
Ultra Audio oscillator

⇒ Which one of the following statements is correct for MOSFETS?
p channel MOS is easier to produce than n channel MOS
n channel MOS must have twice the area of p channel MOS for the same ON resistance
p channel MOS has faster switching action than n channel MOS
p channel MOS has higher packing density than n channel MOS

⇒ If sampling is done at the rate of 10 kHz. The bandwidth required is
35 kHz
70 kHz
10 kHz
1280 kHz

⇒ The source of which of the following noise is different from that of the remaining?
Solar noise
Cosmic noise
Galactic noise
Atmospheric noise

⇒ The method of frequency compensation in moving iron voltmeter is
to use a capacitor in series with coil
to connect a capacitor in parallel with coil
to connect a capacitor in parallel with series resistance
none of the above

⇒ Transient current in a loss free LC circuit when excited from an ac source is an __________ sine wave.
undamped
over damped
under damped
critically damped

⇒ What does the operator ( ) mean in C?
Function expression
Array expression
Structure operator
Increment / Decrement

⇒ If f(t) = A d(t - a), F(s) is
A e^-as
A e^as
A a e^-as
Aa e^as

⇒

Match the following:

	List I (BJT amplifier)		List II (Characteristics)
A.	CE	1.	good voltage gain, good current gain
B.	CC	2.	voltage gain less than 1, high current gain
C.	CB	3.	current gain less than 1, voltage gain high

A-1, B-2, C-3
A-1, B-2, C-3
A-3, B-1, C-2
A-3, B-2, C-1

⇒ If the secondary burden of a CT 15 VA and secondary current is 5 A, the load impedance of CT is
0.6 Ω
5 Ω
6 Ω
10 Ω

⇒ In a 7 segment LED display, the minimum number of segments is activated when the input decimal number is
0
1
2
3

⇒ Consider the following statements about Rhombic antenna

It is non resonant
It is a broad band antenna
It is ideally suited for HF transmission

Which of the above are correct?
1, 2, 3
1, 3 only
2, 3 only
1 only

⇒ Metals approach superconductivity conditions
near absolute zero temperature
near critical temperature
at triple point
under the conditions of high temperature and pressure

⇒ The effective length of an 1/2 antenna (Given R_r = 73 Ω and (A_e)_max = 0.34λ² and η = 120p) is __________ .
0.6348 λ
0.5133 λ
0.1587 λ
0.3714 λ

⇒ The selectivity curve of a standard receiver is represente
curve A
curve B
curve C
curve D

⇒ The Laplace transform of impulse δ(t) is
1
1/s
s
1/s²

⇒ In the two ports network shown in the figure, Z₁₂ and Z₂₁ are, respecti
r_e and βr₀
0 and - βr₀
0 and βr₀
r_e and - βr₀

⇒ Which op-amp circuit uses a resistance in series with input and capacitor in feedback path?
Differentiating amplifier
Integrating amplifier
Logarithmic amplifier
Exponential amplifier

⇒ For the factor (1 + 0.5 jω) the corner frequency is
1 rad/sec
0.5 rad/sec
2 rad/sec
0.25 rad/sec

⇒ The dielectric losses do not depend on frequency.
TRUE
FALSE

⇒ An image uses 512 x 512 picture elements. Each of the picture elements can take any of the 8 distinguishable intensity levels. The maximum entropy in the above image will be
2097152 bits
648 bits
786432 bits
144 bits

⇒ Two ammeters having resistances of 0.5 Ω and 0.25 Ω and having full scale reading of 25 A each are connected in parallel. To ensure that neither of them goes beyond scale, the total current should not be more than
50 A
37.5 A
25 A
40 A

⇒

Match the following:

	List I (Octal)		List II (Hexadecimal)
A.	66	1.	3 F
B.	77	2.	36
C.	55	3.	27
D.	47	4.	3D

A-1, B-3, C-2, D-4
A-2, B-1, C-4, D-3
A-3, B-1, C-2, D-4
A-4, B-1, C-2, D-3

⇒

Match the following:

	List I		List II
A.	C	1.	7 eV
B.	Si	2.	1.15 eV
C.	Ge	3.	0.75 eV
D.	Sn	4.	0.1 eV
E.	Pb	5.	0 eV

A-2, B-3, C-4, D-5, E-1
A-1, B-2, C-3, D-4, E-5
A-3, B-1, C-2, D-5, E-4
A-4, B-5, C-1, D-2, E-3

⇒ In the given figure x_{6de(ax₁ + bx₂ + cx₃)
(a + b + c) (x₁ + x₂ + x₃) (d + e)
(ax₁ + bx₂ + cx₃) (d + e)
a b c d e (x₁ + x₂ + x₃)}

⇒

Assertion (A): Ferrites are very useful at very high frequencies.

Reason (R): Ferrites have high permeability and high resistivity.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Two coupled coils lie in parallel planes such that 50% of magnetic flux produced by one links the other. The coefficient of coupling is
0.5
0.25
0.125
0.5

⇒

Assertion (A): At a temperature of 1000 K, thermionic emission current is about 0.1 A/cm² of surface.

Reason (R): Thermionic emission current is given by I_th = SA₀ T² e^-Ew/kT.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Wheatstone bridge is suitable for low resistances.
TRUE
FALSE

⇒ For a periodic signal with finite number of discontinuities in each period, at isolated points of discontinuity the series converges to __________ .
difference value of signal on either side of discontinuity
highest value of signal on either side of discontinuity
average value of signal on either side of discontinuity
sum of value of signal on either side of discontinuity