Question is ⇒ A moving coil instrument has a resistance of 0.5 Ω and a full scale deflection of 0.1 A. To convert it into an ammeter of 0-10 A the shunt resistance should be, Options are ⇒ (A) 0.004 Ω, (B) 0.005 Ω, (C) 0.05 Ω, (D) 0.1 Ω, (E) , Leave your comments or Download question paper.

Question is ⇒ A moving coil instrument has a resistance of 0.5 Ω and a full scale deflection of 0.1 A. To convert it into an ammeter of 0-10 A the shunt resistance should be, Options are ⇒ (A) 0.004 Ω, (B) 0.005 Ω, (C) 0.05 Ω, (D) 0.1 Ω, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A moving coil instrument has a resistance of 0.5 Ω and a full scale deflection of 0.1 A. To convert it into an ammeter of 0-10 A the shunt resistance should be
A.	0.004 Ω [Wrong Answer]
B.	0.005 Ω [Correct Answer]
C.	0.05 Ω [Wrong Answer]
D.	0.1 Ω [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ When a vector has positive divergence, it indicates that the vector quantity has at that point and if the divergence is negative, it indicates __________ .
source, sink
sink, source
positive value, negative value
negative value, positive value

⇒ In figure I_D = 4 mA. Then V_{S20 V
4.4 V
0.4 V
0.44 V}

⇒ In the circuit shown in the fi
only red will glow
only green will glow
both red and green will glow
none will glow

⇒ For the transport lag G(jω) = e^-jωT, the magnitude is always equal to
0
1
10
0.5

⇒

Assertion (A): Linear ICs include audio amplifier, wideband amplifier, RF amplifier and IF amplifier

Reason (R): The error voltage in a feedback circuit is very small

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ For a 50 Ω resistor for 3 GHz application, the stray capacitance should be less than
1 μF
1 nF
1 pF
0.1 pF

⇒ PAL system was proposed first in
USA
Japan
England
Germany

⇒ A function will have only sine terms if
f(t) = - f(t)
f(-t) = f(t)
f(-t) = -f(t)
none of the above

⇒ In a low power factor wattmeter, compensation for pressure coil current is provided.
TRUE
FALSE

⇒ The diffusion current is proportional to
applied electric field
concentration gradient of charge carrier
square of the electric field
cube of the applied electric field

⇒ The output of the circuit shown below will be of the frequ
125 Hz
250 Hz
500 Hz
750 Hz

⇒ In a communication receiver, a squelch circuit is normally inserted
before detector
after detector
before mixer
after power amplifier

⇒ For the same length of arrays, half power beam-width of binomial array
is equal to that of uniform arrays
is less than that of uniform array
is more than that of uniform array
is negligible as compared to that of uniform array

⇒ Symbol shown in figure represen
P-channel enhancement MOSFET
N-channel DEMOSFET
UJT with P-type base
UJT with N-type base

⇒ In a CE amplifier
both ac and dc load lines have the same slope
the ac load line has more slope than dc load line
the ac load line has less slope than dc load line
the two load lines may have slope more than the other

⇒ Given figure shows the magnitude plot for a system. The steady state error for unit step inpu
1/101
1/100
14977
14611

⇒ For a BJT, under the saturation condition,
I_C = βI_B
I_C = aI_B
I_C is independent of all other parameters
I_C < βI_B

⇒ A function Z(s) has zero at infinity if
the degree of numerator and denominator are equal
the numerator of Z(s) is one degree higher than denominator
the denominator of Z(s) is one degree higher than numerator
the degree of numerator and denominator are either equal or differ by one

⇒ A 2 bit binary multiplier can be implemented using
2 inputs ANDs only
2 inputs XORs and 4 input AND gates only
Two 2 inputs NORs and one XNOR gate
XOR gates and shift registers

⇒ A two winding transformer is feeding a single phase half wave rectifier circuit. The load is purely resistive. The rms value of transformer secondary current is I_s and rms value of load current in I_rms. Then
I_s = I_rms irrespective of the value of firing angle
I_s = 0.5 I_rms irrespective of the value of firing angle
I_s = I_rms if firing angle is less than 30°
I_s = I_rms if firing angle is more than 30°

⇒ In the given figure, the number of individual loop
2
4
5
6

⇒

Assertion (A): An op-amp amplifier can amplify dc signal

Reason (R): An op-amp amplifier is a direct coupled amplifier

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A conductor is said to be perfect if it has __________ conductivity
finite
infinite
unity
zero

⇒ In a single phase full wave ac regulator feeding R-L load, the gate pulses
are always of short duration
may be of short duration
should be rectangular with width (p - a)
cannot be rectangular with width (p - a)

⇒ In a bistable multivibrator, commutating capacitors are used to
increase the base storage charge
provide ac coupling
increase the speed of response
alter the frequency of the output

⇒ The initial contents of the 4 bit serial in parallel out right shift, shift register shown in figure is 0110. After three clock pulses are applied, the contents of the shift register wil
0
101
1010
1111

⇒ In a series R, L, C circuit the impedance triangle is the same when X_L < X_C and X_L > X_C .
TRUE
FALSE

⇒

Assertion (A): Heaviside partial expansion gives a simple procedure to find inverse Laplace transform of the terms having a complex conjugate pair of roots.

Reason (R): If I(s) = P(s)/Q(s) and all roots of Q(s) = 0 are simple, i(t) will have terms with exponentials having real exponents only.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In the circuit of figure, PIV can be u
E_m
2 E_m
0.5 E_m
2 E_m

⇒ DC voltage of the order of a few mV can be accurately of measured by
PMMC voltmeters
moving iron voltmeter
null balancing potentiometer
electrostatic voltmeter