Question is ⇒ A microprocessor can understand instruction written in, Options are ⇒ (A) machine language only, (B) mnemonics operation codes only, (C) high language only, (D) both machine language and mnemonics operation codes, (E) , Leave your comments or Download question paper.

Question is ⇒ A microprocessor can understand instruction written in, Options are ⇒ (A) machine language only, (B) mnemonics operation codes only, (C) high language only, (D) both machine language and mnemonics operation codes, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A microprocessor can understand instruction written in
A.	machine language only [Correct Answer]
B.	mnemonics operation codes only [Wrong Answer]
C.	high language only [Wrong Answer]
D.	both machine language and mnemonics operation codes [Wrong Answer]
View Answer 5 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which has the lowest propagation delay time?
ECL
TTL
CMOS
PMOS

⇒ Which of the following has the highest input impedance?
CE
CB
CC
Push pull

⇒ The loops ' for , 'while' , 'do-while' are used in
Fortran 77
Pascal
C
none of the above

⇒ A narrow band noise n(t) has symmetrical spectrum and has power density spectrum 0.2 x 10^-6. The power density of quadrature component is
0.2 x 10^-6
10^-7
4 x 10^-7
5 x 10^-8

⇒ The analog signal given below is sampled at 1200 samples per second. m(t) = 2 sin 120 pt + 3 sin 240 pt + 4 sin 360 pt + 5 sin 480 pt + 6 sin 600 pt + 7 sin 720 pt. The folding (maximum) frequency is __________ .
300 Hz
360 Hz
600 Hz
480 Hz

⇒ Most of the communication satellites are stationed to the West of their service areas in order to reduce their
eclipse period
loss of power
battery power provision
mass of station-keeping fuel

⇒ The inputs to a 3 bit binary adder are 111₂ and 110₂. The output will be
101
1101
1111
1110

⇒ In an SCR, the anode current is controlled by
gate current only
external circuit only
both gate current and external circuit
none of the above

⇒ In radar system which of the following is called A scope
deflection modulation of CRT
intensity modulation of CRT
computer display
none of the above

⇒ In the given figure the E and H lines in a coaxial c
The radial lines are E lines and circular lines are H lines
Radial lines are H lines and circular lines are E lines
The directions of E and H lines are wrong
Radial lines may be E and H lines depending an direction of current

⇒ Entropy gives
measure of Uncertainty
rate of Information
average information
probability of Information

⇒ The system of linear equations 4x + 2y = 1 , 2x + y = 6 has
a unique solution
no solution
an infinite number of solutions
exactly two distinct solutions

⇒ In a series resonant circuit Q is more than 10. Then the lower half power frequency ω₁, and resonant frequency ω₀ are related as
ω₁ = ω₀ + bandwidth
ω₁ = ω₀ + 0.5 (bandwidth)
ω₁ = ω₀ - 0.5 (bandwidth)
ω₁ = ω₀ + bandwidth

⇒ The pole zero plot of the given figure is
non-minimum phase function
minimum phase function
all pass function
none of the above

⇒ In order to rectify sinusoidal signals of millivolt range (< 0.6 V)
bridge rectifier using diodes can be employed
full wave diode rectifier can be used
a diode is to be inserted in the feedback loop of an op-amp
a diode is to be inserted in the I/P of an op-amp

⇒ If the characteristic equation is (λ + 1) (λ + 2) (λ + 3) = 0, the eigen values are
-1, -2, -3
1, 2, 3
0, 1, 2
0, 2, 3

⇒ A sinusoidal ac voltage of amplitude 100 V is applied to a rectifying device which offers 10 Ω resistance in forward direction and infinite resistance in reverse direction. The reading on hot wire ammeter will be
0.416666666666667
0.208333333333333
3.185 A
1.414 A

⇒

Assertion (A): Gate triggering is the most commonly used method for triggering of an SCR.

Reason (R): Even a small gate current is sufficient to turn on an SCR.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Millman's theorem is the best to find
equivalent voltage or current source
equivalent voltage source
equivalent voltage and resistance of a circuit
none of the above

⇒

Assertion (A): The function δ'(t - b) is equal to 0 for t ≠ b

Reason (R): A number of impulses spaced from one another form an impulse train.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The ratio of diffusion constant for hole D_P to the mobility for holes is proportional to
T²
T
1/T
T³

⇒ The greatest negative number which can be stored is 8 bit computer using 2's complement arithmetic is
-256
-128
-255
-127

⇒ When a complex signals is used to frequency modulate a carrier, the resulting sideband distribution is
symmetrical about the carrier
not necessarily symmetrical about the carrier
decided by the predominant sidebands
none of the above

⇒ Which of the following is used in automatic control of street lights?
Thermistor
Photoconductor
Transistor
Varistor

⇒ In a 4 bit parallel in parallel out shift register A = 1, B = 1, C = 0, D = 1. The data output after 3 clock pulses is
1101
1001
101
1

⇒ Two sinusoidal waves 1 and 2 have peak values V_m1 and V_m2. Wave 1 is leading wave 2 by ∠θ. Which of the following is correct?
v₁ = V_m1 sin θ and v₂ = V_m2 cos θ
v₁ = V_m1 sin ωt and v₂ = V_m2 sin (ωt - θ)
v₁ = V_m1 sin (ωt + θ/2) and v₂ = V_m2 sin ωt
none of the above

⇒ In a radar system the solution to blind speed problem is to
use MTI
use monopoles
vary PRF
change Doppler frequency

⇒ There is no radiation at right angles to the plane of the array, is end fire array.
TRUE
FALSE

⇒ Symbol shown in figure represen
P-channel DEMOSFET
N-channel DEMOSFET
UJT with N-type base
UJT with P-type base

⇒ In a lead acid cell the density of the acid gives an indication of
the level of the acid
the eventual damages caused to the plates
the charge of the battery
the e.m.f. of the battery