Question is ⇒ A memory system of size 16 k bytes is to be designed using memory chips which have 12 address lines and 4 data lines each. The number of such chips required to design the memory system is, Options are ⇒ (A) 2, (B) 4, (C) 8, (D) 18, (E) , Leave your comments or Download question paper.

Question is ⇒ A memory system of size 16 k bytes is to be designed using memory chips which have 12 address lines and 4 data lines each. The number of such chips required to design the memory system is, Options are ⇒ (A) 2, (B) 4, (C) 8, (D) 18, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A memory system of size 16 k bytes is to be designed using memory chips which have 12 address lines and 4 data lines each. The number of such chips required to design the memory system is
A.	2 [Wrong Answer]
B.	4 [Wrong Answer]
C.	8 [Correct Answer]
D.	18 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The minor M_ij of an n x n matrix is the determinant of (n - 1) x (n - 1) matrix formed by deleting the ith row and j the column of n x n matrix.
TRUE
FALSE

⇒ A circular waveguide has an infinite set of TE and TM modes.
TRUE
FALSE

⇒ If zeros at infinity are included in the count, the number of zeros of G(s) H(s) is
equal to number of poles
one more than the number of poles
one less than the number of poles
none of the above

⇒ A differentiating amplifier has capacitor in the input path.
TRUE
FALSE

⇒ A device has two resistances 300 Ω and 200 Ω respectively. The noise voltages due to these two resistance calculated separately are 5.38 μV and 4.38 μV respectively. When both of them are used together, the noise voltage will be
9.76 V
1 μV
23.56 μV
6.94 μV

⇒ In colour TV system the colour sub carrier frequency is 4.43 MHz.
TRUE
FALSE

⇒ What is an advantage of an electronic voltmeter over a non-electronic voltmeter?
Low power consumption
Low input impedance
The ability to measure wide ranges of voltages and resistance
Large portability

⇒ A broadside array consisting of 200 cm wavelength with 10 half-wave dipole spacing 10 cm. And if each array element feeding with 1 amp. current and operating at same frequency then find the radiated power
730 W
73 W
100 W
None

⇒ Which of the following is a better propagation mode to propagate television frequency modulation and radar signals?
Satellite communication
Ground propagation
Polarized communication
None of the above

⇒ If a driving point function N(s) = p(s)/q(s), then
the terms of lowest degree in p(s) and q(s) may differ in degree by zero only
the terms of lowest degree in p(s) and q(s) may differ by one at the most
the terms of lowest degree in p(s) and q(s) may differ in degree by two at the most
the terms of lowest degree in p(s) and q(s) may differ in degree by three at the most

⇒ Consider z transform of a signal as given b
IIR
FIR
Depends on value of n
Cannot determined

⇒ Figure shows an 8-bit LED display. A light circle means that a LED is ON (binary 1) and a dark circle means a LED is OFF (binary 0). What is the decimal equivalent of the binary number displa
100
121
144
172

⇒ If the intermediate frequency of a superheterodyne receiver falls within the tuning range of the receiver
Unsuitability will occur
Heterodyne whistles will be heard
Tuning to the frequency band immediately adjacent to the intermediate frequency will become impossible
All of the above

⇒ If p is the probability of success and q is the probability of failure, then the probability that there are r successes in n trails is
ⁿc_r p^r qⁿ ^- ^r
ⁿc_r p^{n -} ^r q^r
ⁿc_r p^r qⁿ ⁺ ^r
ⁿc_r pⁿ qⁿ ^{- r}

⇒ The advantages of high density IC are
more circuits on chip
high operating speed
low power consumption
both (a) and (b)

⇒ In a semiconductor material. The hole concentration is found to be 2 x 2.5 x 10¹⁵ cm^-3. If mobility of carriers is 0.13 m²/ v-s. Then find the current density if electric field intensity is 3.62 x 10^-19
7.6237 x 10^-4 A/cm²
7.6237 x 10^-5 A/cm²
7.6237 x 10^-3 A/cm²
none of these

⇒ Three cascaded stages have gains of 10, 20 and 25. The overall gain will be
10
55
500
5000

⇒ Hysteresis loss in a transformer working at 220 V and at a frequency of 50 Hz is 100 W. When the transformer is operated at 220 V and at a frequency of 100 Hz, what is the hysteresis loss?
50 W
100 W
200 W
400 W

⇒ De Sauty bridge is very widely used due to
simplicity
perfect balance for imperfect capacitor
perfect balance for air capacitors
maximum sensitivity

⇒ In metals, the average drift velocity of electron per unit field is called mobility.
TRUE
FALSE

⇒ The modulation index of an FM is changed from 0 to 1. How does the transmitted power change?
Gets halved
Gets doubled
Gets increased by 50 percent
Remains unchanged

⇒ Quantization noise occurs in
PAM
DM
PWM
PPM

⇒ The Causal system given below is _______
maximum phase
minimum phase
mixed phase
none of these

⇒ The V_s is give
8 V
13 V
1 V
4 V

⇒ The amplitude of a random signal uniformly distributed between - 5 V and 5 V. If the positive values of the signal are uniformly quantized with a step size of 0.05 V, and the negative values are uniformly quantized with a step size of 0.10 V, the resulting signal to quantization noise is approximately
46 dB
43.8 dB
42 dB
40 dB

⇒ A broadcast radio transmitter radiates 5 kW when the modulation percentage is 60. How much of this is carrier power?
6.66 kW
5 kW
4.9 kW
4.23 kW

⇒ In figure, the switch is initially open. At t = 0 switch is closed. v_c (0⁺) and i_L (0⁺)
60 V and - 0.3 A
150 V and zero
zero and 0.3 A
90 V and - 0.3 A

⇒ The number of PM radio channels which can be accommodated in a spectrum of 300 MHz is about
10
100
500
1500

⇒ Class A amplifiers are preferred when
minimum distortion is required
maximum voltage gain is required
output signal is desired in phase with input signal
signal having A.C. superimposed on D.C. are to be amplified

⇒ If resistance is 20 Ω and inductance is 2 H in a R-L series circuit, then time constant of this will be
0.001 s
0.1 s
10 s
100 s