Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
A matched generator (Z_{g} = Z_{0}) with 1 Ω available. If all ports are matched, the power delivered at ports 1, 2, 3 respectively are | |
A. | 0.5 W, 0.5 W, 0 W [Correct Answer] |
B. | 0 W, 0 W, 1 W [Wrong Answer] |
C. | 0.33 W each [Wrong Answer] |
D. | 0 W, 0.25 W, 0.25 W [Wrong Answer] |
View Answer
Explanation:-
Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result |
Also Read Similar Questions Below :
⇒ A coil with large distributed capacitance has a
high resonant frequency
low resonant frequency
low quality factor
low resistance
⇒ For the K map of the given figure, the simplified Boolean expressio
A C + A D + ABC
A B D + BC
A C D + AC
A C D + AC + BC
⇒ The device having highest photo sensitivity is
photoconductive cell
photovoltaic cell
photodiode
phototransistor
⇒ In a full bridge single phase inverter feeding RLC load
one thyristor and one diode conduct simultaneously
two thyristors conduct simultaneously
two thyristors or two diodes conduct simultaneously
four thyristors conduct simultaneously
⇒ The feedback technique employed in the following circuit
voltage series feedback
current series feedback
voltage shunt feedback
current shunt feedback
⇒ In an intrinsic semiconductor, at a given temperature T
the number of electrons-hole pairs generated per second due to thermal motion are equal to the number of electron-hole pairs lost per second due to recombination
the number of electron-hole pairs generated per second due to thermal motion is always less than the number of electron-hole pairs lost per second due to recombination
the number of electron hole pairs generated per second due to thermal motion is always more than the number of electron-hole pairs lost per second due to recombination
any of the above
⇒ A source of angular frequency 1 rad sec has a source impedance consisting of 1 Ω resistance in series with 1 H inductance. The load that will obtained the maximum power transfer is
1 Ω resistance
1 Ω resistance in parallel with 1 H inductance
1 Ω resistance in series with 1 F capacitor
1 Ω resistance in parallel with 1 F capacitor
⇒ The relative permeability of an iron specimen is 400 when B = 0.2 T. If B = 0.4 T, μ_{r} will be
400
less than 400
more than 400
more or less than 400
⇒ The coupling capacitor mainly affects
bandwidth
lower cut-off frequency
higher cut-off frequency
both lower as well as higher cut-off frequency
⇒ Homodyne detection means
coherent detection
non-coherent detection
asynchronous detection
none of the above
⇒ The output voltage waveform of a CE amplifier is fed to a dc coupled CRO. The trace on the screen will be
dc output voltage
ac output voltage
sum of dc and ac output voltage
either (a) or (b)
⇒ Which one of the following is the correct statement? The region of convergence of z transform of x[n] consists of the values of z for which x[n] r^{-n} is
absolutely integrable
absolutely summable
unity
< 1
⇒
A-4, B-1, C-2, D-3
A-1, B-2, C-3, D-4
A-3, B-1, C-2, D-4
A-1, B-3, C-4, D-1
⇒
Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true
⇒ The skin depth at 1000 MHz as compared to that at 500 MHz is
2
12
0.707
0.5
⇒ If number of information bits is 4, the parity bits in Hamming code are located at bit positions __________ from the LSB.
1, 2, 5
1, 2, 4
1, 2, 3
1, 2
⇒ Voltage series feedback (Also called series-shunt feedback) results in
increase in both I/P and O/P impedances
decrease in both I/P and O/P impedances
increase in I/P impedance and decrease in O/P impedance
decrease in I/P impedance and increase in O/P impedance
⇒ The resistance of voltmeter affects the accuracy of measurement in loss of charge method.
TRUE
FALSE
⇒ The reflection coefficient is generally a
complex number
fraction
imaginary number
none of the above
⇒ In an op-amp a common mode signal is applied to
inverting terminal
non-inverting terminal
both terminals
one or both the terminals
⇒ Which of the following material is preferred for transformer cores operating in micro wave frequency range?
Ferrites
Silicon steel
Superalloy
Copper
⇒ The following switching functions are to be implemented using a decoder
2 to 4 line
3 to 8 line
4 to 16 line
5 to 32 line
⇒ In a lead acid battery
the numbers of positive and negative plates are equal
the number of positive plates may be equal to or more than the number of negative plates
the number of positive plates is more than the number of negative plates
the number of negative plates is more than the number of positive plates
⇒ A signal m(t) with bandwidth 500 Hz is first multiplied by a signal g(t) w
δ(t)
m(t)
0
m(t) δ(t)
⇒ A power transistor dissipates 5 W. If ambient temperature is 30° and case to air thermal resistance is 10° C/W, the case temperature is
80°C
20°C
32°C
305°C
⇒ For type 1 system the velocity lag error is
inversely proportional to bandwidth of system
directly proportional to gain constant
inversely proportional to gain constant
independent of gain constant
⇒ The system of the given fi
has two poles and one zero in left half plane
has two poles and one zero in right half plane
has two poles in left half plane and zero in right half plane
none of the above
⇒ If t is relaxation time and t_{c} is average time between collisions, then in an isotropic metal
t = t_{c}
t < t_{c}
t_{c} < t
T = 0.01 t_{e}
⇒ In a 100% amplitude modulated signal, the power in the upper sideband when carrier power is to be 100 W and modulation system SSBSC, is
100 W
66 W
50 W
25 W
⇒ Audio frequency range lies between
20 Hz and 20 kHz
20 kHz and 20 MHz
2 MHz and 20 MHz
20 MHz and 200 MHz
⇒ A coil with large distributed capacitance has a
high resonant frequency
low resonant frequency
low quality factor
low resistance
⇒ For the K map of the given figure, the simplified Boolean expressio
A C + A D + ABC
A B D + BC
A C D + AC
A C D + AC + BC
⇒ The device having highest photo sensitivity is
photoconductive cell
photovoltaic cell
photodiode
phototransistor
⇒ In a full bridge single phase inverter feeding RLC load
one thyristor and one diode conduct simultaneously
two thyristors conduct simultaneously
two thyristors or two diodes conduct simultaneously
four thyristors conduct simultaneously
⇒ The feedback technique employed in the following circuit
voltage series feedback
current series feedback
voltage shunt feedback
current shunt feedback
⇒ In an intrinsic semiconductor, at a given temperature T
the number of electrons-hole pairs generated per second due to thermal motion are equal to the number of electron-hole pairs lost per second due to recombination
the number of electron-hole pairs generated per second due to thermal motion is always less than the number of electron-hole pairs lost per second due to recombination
the number of electron hole pairs generated per second due to thermal motion is always more than the number of electron-hole pairs lost per second due to recombination
any of the above
⇒ A source of angular frequency 1 rad sec has a source impedance consisting of 1 Ω resistance in series with 1 H inductance. The load that will obtained the maximum power transfer is
1 Ω resistance
1 Ω resistance in parallel with 1 H inductance
1 Ω resistance in series with 1 F capacitor
1 Ω resistance in parallel with 1 F capacitor
⇒ The relative permeability of an iron specimen is 400 when B = 0.2 T. If B = 0.4 T, μ_{r} will be
400
less than 400
more than 400
more or less than 400
⇒ The coupling capacitor mainly affects
bandwidth
lower cut-off frequency
higher cut-off frequency
both lower as well as higher cut-off frequency
⇒ Homodyne detection means
coherent detection
non-coherent detection
asynchronous detection
none of the above
⇒ The output voltage waveform of a CE amplifier is fed to a dc coupled CRO. The trace on the screen will be
dc output voltage
ac output voltage
sum of dc and ac output voltage
either (a) or (b)
⇒ Which one of the following is the correct statement? The region of convergence of z transform of x[n] consists of the values of z for which x[n] r^{-n} is
absolutely integrable
absolutely summable
unity
< 1
⇒
Match the following:
List I (Binary) | List II (Hexadecimal) | ||
---|---|---|---|
A. | 10101010 | 1. | FF |
B. | 11111111 | 2. | 88 |
C. | 10001000 | 3. | 92 |
D. | 10010010 | 4. | AA |
A-4, B-1, C-2, D-3
A-1, B-2, C-3, D-4
A-3, B-1, C-2, D-4
A-1, B-3, C-4, D-1
⇒
Assertion (A): Tunnel diode is used in many pulse and digital circuits.
Reason (R): The v-i curve of a tunnel diode resembles letter 'N'.
Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true
⇒ The skin depth at 1000 MHz as compared to that at 500 MHz is
2
12
0.707
0.5
⇒ If number of information bits is 4, the parity bits in Hamming code are located at bit positions __________ from the LSB.
1, 2, 5
1, 2, 4
1, 2, 3
1, 2
⇒ Voltage series feedback (Also called series-shunt feedback) results in
increase in both I/P and O/P impedances
decrease in both I/P and O/P impedances
increase in I/P impedance and decrease in O/P impedance
decrease in I/P impedance and increase in O/P impedance
⇒ The resistance of voltmeter affects the accuracy of measurement in loss of charge method.
TRUE
FALSE
⇒ The reflection coefficient is generally a
complex number
fraction
imaginary number
none of the above
⇒ In an op-amp a common mode signal is applied to
inverting terminal
non-inverting terminal
both terminals
one or both the terminals
⇒ Which of the following material is preferred for transformer cores operating in micro wave frequency range?
Ferrites
Silicon steel
Superalloy
Copper
⇒ The following switching functions are to be implemented using a decoder
- f_{1} = ∑m (1, 2, 4, 8, 10, 14)
- f_{2} = ∑m (2, 5, 9, 15)
- f_{3} = ∑m (2, 4, 5, 6, 7)
2 to 4 line
3 to 8 line
4 to 16 line
5 to 32 line
⇒ In a lead acid battery
the numbers of positive and negative plates are equal
the number of positive plates may be equal to or more than the number of negative plates
the number of positive plates is more than the number of negative plates
the number of negative plates is more than the number of positive plates
⇒ A signal m(t) with bandwidth 500 Hz is first multiplied by a signal g(t) w
δ(t)
m(t)
0
m(t) δ(t)
⇒ A power transistor dissipates 5 W. If ambient temperature is 30° and case to air thermal resistance is 10° C/W, the case temperature is
80°C
20°C
32°C
305°C
⇒ For type 1 system the velocity lag error is
inversely proportional to bandwidth of system
directly proportional to gain constant
inversely proportional to gain constant
independent of gain constant
⇒ The system of the given fi
has two poles and one zero in left half plane
has two poles and one zero in right half plane
has two poles in left half plane and zero in right half plane
none of the above
⇒ If t is relaxation time and t_{c} is average time between collisions, then in an isotropic metal
t = t_{c}
t < t_{c}
t_{c} < t
T = 0.01 t_{e}
⇒ In a 100% amplitude modulated signal, the power in the upper sideband when carrier power is to be 100 W and modulation system SSBSC, is
100 W
66 W
50 W
25 W
⇒ Audio frequency range lies between
20 Hz and 20 kHz
20 kHz and 20 MHz
2 MHz and 20 MHz
20 MHz and 200 MHz