Question is ⇒ A low noise device is most important, Options are ⇒ (A) at front end of equipment, (B) in the last stage of equipment, (C) in the middle stages of equipment, (D) both (b) and (c), (E) , Leave your comments or Download question paper.

Question is ⇒ A low noise device is most important, Options are ⇒ (A) at front end of equipment, (B) in the last stage of equipment, (C) in the middle stages of equipment, (D) both (b) and (c), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A low noise device is most important
A.	at front end of equipment [Correct Answer]
B.	in the last stage of equipment [Wrong Answer]
C.	in the middle stages of equipment [Wrong Answer]
D.	both (b) and (c) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ What does a link budget for satellite communication include?
Total cost of satellite
Cost of satellite plus launch vehicle
Signal and noise levels is dB
Margins of error permitted

⇒ A constant k high pass filter has f_c = 3000 Hz. At f = 1000 Hz, the phase shift is
zero
p
2 p
more than p

⇒ Consider the resonant circuit as shown b
R = 10⁴ L = 5 μH C = 20 pF
1000 L = 50 μH C = 200 pF
10 K L = 50 μH C =20 pF
None of these

⇒ The main advantage of hexadecimal numbers is
ease of conversion from hexadecimal to binary and vice-versa
ease of conversion from hexadecimal to decimal and vice-versa
ease of conversion from gray code to binary and vice-versa
the use of numbers and alphabets

⇒ Parity means the same as positive or negative number.
TRUE
FALSE

⇒ Energy density function is always
even
odd
neither even nor odd
both (a) and (b)

⇒ As per temperature limits, the number of categories of solid dielectrics are
7
6
8
5

⇒ In the signal flow graph in the given figure the number of forward paths and pairs of non-touching loops are respecti
3 and 1
3 and 2
4 and 2
2 and 4

⇒ In a two stage CE amplifier circuit, the ac collector resistance of the first stage depends on
load resistance
input impedance of first stage
input impedance of second stage
all of the above

⇒

Assertion (A): In an R-L circuit having low resistance, current lags the voltage by nearly 90°.

Reason (R): Power factor of a series RL circuit is R/Z.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Impedance inversion may be obtained with
a short circuited stub
a quarter wave line
an open circuited stub
a half wave line

⇒ Which device uses Pneumatic fluid?
LED
LCD
VF display
None of these

⇒ __________ will have the least value of relative permeability.
Palladium
Silver
Cobalt
Iron

⇒ Stability factor for S is given by for a fixed bias
1 + β
1 - β
1/β
β - 1

⇒ In a radio receiver with simple AGC
the highest AGC voltage is produced between stations
the faster the AGC time constant, the more accurate the output
an increase in signal strength produces more AGC
the audio stage gain is normally controlled by AGC

⇒ In a hi-fi system the nonlinear distortion should be less than
0.1
0.05
0.02
0.01

⇒ Which of the following is/are correct statement(s)?

Bus is a group of wires carrying information.
Bus is needed to achieve reasonable speed of operation.
Bus can carry data or address.
A bus can be shared by more than one device.

Select the correct answer from the codes given below
1 only
1 and 2 only
2, 3 and 4 only
1, 2, 3 and 4

⇒ A communication satellite is a repeater between
a transmitting station and a receiving station
a transmitting station and many receiving station
many transmitting station and many receiving station
none

⇒ Which of the following form of angle modulation in this? If e = 10 sin(10⁸ t + 3 sin 10⁴ t)
AM
FM
AM or FM
AM or PCM

⇒ In a CE amplifier
both ac and dc load lines have the same slope
the ac load line has more slope than dc load line
the ac load line has less slope than dc load line
the two load lines may have slope more than the other

⇒ The current i(t) through a 10 Ω resistor in series with an inductance is given by i(t) = 3 + 4 sin (100t + 45°) + 4 sin (300t + 60°) Amperes. The RMS value of the current and the power dissipated in the circuit are
41 A, 410 W respectively
35 A, 350 W respectively
5 A, 250 W respectively
11 A, 1210 W respectively

⇒ Absolute instruments are used in
laboratories
industries
power houses
standard laboratories

⇒

Assertion (A): Free space does not interfere with normal radiation and propagation of radio waves

Reason (R): Free space has no magnetic or gravitational fields.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): A VMOS can handle much larger current than other field effect transistors.

Reason (R): In a VMOS the conducting channel is very narrow.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ If air pressure in a rectangular waveguide is increased the maximum power handling capacity
is decreased
is increased
remains the same
may increase or decrease depending on pressure

⇒ In a high speed modem the data rate handled is about
1000 bps
5000 bps
20000 bps
50000 bps

⇒ The minor M_ij of an n x n matrix is the determinant of (n - 1) x (n - 1) matrix formed by deleting the ith row and j the column of n x n matrix.
TRUE
FALSE

⇒ The resonant frequency of the circuit shown in figure
1/22p Hz
1/2p Hz
1/4p Hz
1/2p Hz

⇒ A balanced modulator circuit uses
two identical diodes with same V-I characteristics
two triodes with different V-I characteristics
two diodes with different V-I characteristics
a diode and a triode

⇒ An earth mat for a communication tower consists of
one or two radials extending from base of tower at a depth of about 5 cm below ground
a large number of radials extending from base of tower at a depth of about 3 m
a large number of radials extending from base of tower at a depth of about 30 cm
none of the above