Question is ⇒ A lossless transmission line with air dielectric is 6 m long. what is the phase constant?, Options are ⇒ (A) 1p rad/m, (B) 2p rad/m, (C) 0.2p rad/m, (D) 0.1p rad/m, (E) , Leave your comments or Download question paper.

Question is ⇒ A lossless transmission line with air dielectric is 6 m long. what is the phase constant?, Options are ⇒ (A) 1p rad/m, (B) 2p rad/m, (C) 0.2p rad/m, (D) 0.1p rad/m, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A lossless transmission line with air dielectric is 6 m long. what is the phase constant?
A.	1p rad/m [Wrong Answer]
B.	2p rad/m [Wrong Answer]
C.	0.2p rad/m [Correct Answer]
D.	0.1p rad/m [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An ac circuit has two branches in parallel. The impedances of the two branches are equal. Their power factors are 0.8 lagging and 0.8 leading. The overall p.f. is
1
zero
about 0.7 lagging
about 0.7 leading

⇒

Assertion (A): Impulse function is an important function in network analysis.

Reason (R): Convolution integral enables us to find the response of a network to an arbitary input in terms of the impulse response.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ 25 persons are in a room. 15 of them play hockey, 17 of them play football and 10 of them play both hockey and football. Then the number of persons playing neither hockey nor football is:
2
17
13
3

⇒ The unit of displacement density is
volt/metre
ampere/metre²
coulombs/metre
coulombs/metre²

⇒

Match the following:

	List I		List II
A.	Darlington amplifier	1.	A circuit using pnp and npn transistors
B.	CB amplifier	2.	A CS amplifier driving a CG amplifier
C.	Cascade amplifier	3.	A circuit with over-all voltage gain close to 1 and very large input impedance
D.	Complementary symmetry amplifier	4.	A circuit with low input impedance

A-1, B-2, C-3, D-4
A-2, B-1, C-3, D-4
A-3, B-4, C-2, D-1
A-4, B-3, C-2, D-1

⇒ The dynamic resistance of a forward biased p-n diode
varies inversely with current
varies directly with current
is constant
is either constant or varies directly with current

⇒ In binary data transmission DPSK is preferred to PSK because
a coherent carrier is not required to the generated at the receiver
for a given energy per bit, the probability for zero is less
the 180° phase shifts of the carrier
more protection is provided against impulse noise

⇒ The power rating of radio transmitters is around
100 mW
10 W
10 kW
10 MW

⇒ A 2-terminal network consists of one of the RLC elements. The elements is connected to an ac supply. The current through the element is 1 A. When an inductor is inserted in series between the source and the element, the current through the element becomes 2 A. What is this element?
A resistor
An inductor
A capacitor
Cannot be single element

⇒ A transmission line has Z₀ = 300 Ω and Z_L = (300 - j300) ohm. The transmission coefficient is
1.265 ∠ - 18.43°
1.01 ∠ - 10°
1.14 ∠ 66.68°
1.09 ∠ 66.68°

⇒ In LED the radiation is in
visible region
infrared region
both (a) and (b)
neither (a) nor (b)

⇒ A system has 12 poles or 2 zeros. Its high frequency asymptote in its magnitude plot has slope of
-200 dB/decade
-240 dB/decade
-280 dB/decade
-320 dB/decade

⇒ The different access methods which permit many satellite users to operate in parallel through a single transponder without interfering with each other as
Frequency Division Multiple Access (FDMA)
Time Division Multiple Access (TDMA)
Code Division Multiple Access (CDMA)
All of the above

⇒ Boolean expression for the output of XNOR (Equivalent) logic gate with inputs A and B is
AB + AB
AB + AB
(A + B). (A + B)
(A + B). (A + B)

⇒ Which of the following semiconductor has the highest melting point?
Germanium
Silicon
Gallium arsenide
Lead sulphide

⇒ Consider the following DO statement in FORTRAN 77 7
6
1
8

⇒ What is output 'Z' of an EX-OR gate, whose all inputs are set at A?
Z = A
Z = 1
Z = 0
Z = A

⇒ A hot wire instrument is not affected by stray magnetic fields.
TRUE
FALSE

⇒ In the circuit of figure v₁ = 8 V and v₂ = 0. Which diode will conduct (Assume ideal diod
D₁ only
D₂ only
Both D₁ and D₂
Neither D₁ nor D₂

⇒ Which of the following is invalid in Basic?
A ** B + - C
A ** B - C
A * B - C
A * B - C ** D

⇒ In a certain network not containing any dependent sources, number of nodes = 4 and number of branches is equal to 6.
4
2
3
5

⇒ When a source is delivering maximum power to a load through a network, the ratio of power delivered to the source power
may be 50% or less than 50%
is 50%
may be 50% or more than 50%
may be 50% or more less than 50%

⇒ Find the electric charge required on the earth and moon to balance their gravitational attraction if the charge on the earth is 10 times that on the moon.
1.73 TC
17.3 GC
17.3 TC
1.73 GC

⇒ The reactance of bypass capacitor in a CE amplifier circuit should be
equal to the resistance in parallel with it
equal to 10% or less of the resistance in parallel with it
equal to 50% of the resistance in parallel with it
independent of the resistance in parallel with it

⇒ Germanium and Si phosphorus have their maximum spectral response in the
infrared region
ultraviolet region
visible region
X-ray region

⇒ For H(s) to be positive real, the condition Re[H(jω)] ≥ 0 for 0 ≤ ω ≤ ∞ is
a necessary condition
a sufficient condition
a necessary and sufficient condition
is not a necessary condition

⇒ The factor η for a UJT is about
0.1
0.2
0.6
0.9

⇒ In a base driver amplifier the voltage gain is the ratio of
ac collector voltage to ac base voltage
ac emitter voltage to ac base voltage
ac collector voltage to ac emitter voltage
ac base voltage to ac emitter voltage

⇒ The relationship of hysteresis loss to maximum flux density was first determined by
C. Steinmetz
G.R. Kirchoff
Mr. Laplace
Mr. Ampere

⇒ A short-circuit is that which is
used short pieces of wire
goes only a short distance
is used for dimming light
offer very low resistance path for current to flow