Question is ⇒ A loss less line is terminated in a circular lines are E lines, Options are ⇒ (A) SWR = 0, (B) SWE = 0, (C) SWR is finite, (D) SWR = ∞, (E) , Leave your comments or Download question paper.

Question is ⇒ A loss less line is terminated in a circular lines are E lines, Options are ⇒ (A) SWR = 0, (B) SWE = 0, (C) SWR is finite, (D) SWR = ∞, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A loss less line is terminated in a circular lines are E lines
A.	SWR = 0 [Wrong Answer]
B.	SWE = 0 [Wrong Answer]
C.	SWR is finite [Correct Answer]
D.	SWR = ∞ [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The pole-zero plot given below corresponds
low pass filter
high pass filter
band pass filter
notch filter

⇒ For a BJT, under the saturation condition,
I_C = βI_B
I_C = aI_B
I_C is independent of all other parameters
I_C < βI_B

⇒

Assertion (A): If we overdrive an amplifier the output signal may get clipped

Reason (R): To dissipate heat to atmosphere a heat sink is sometimes attached to the case of transistor

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Resistivity of rubber is about
10² Ω-m
10^-2 Ω-m
5 x 10⁸ Ω m
5 x 10¹² Ω-m

⇒ In a certain '12 channel TDM' system it is found that channel no. 3 and channel no. 8 are connected to the same input signal. This technique
wastes the channel capacity
takes care of different sampling rate
is required when different bandwidth signals are to be transmitted
reduces noise

⇒ (FE35)₁₆ XOR (CB15)₁₆ is equal to
(3320)₁₆
(FE35)₁₆
(FF50)₁₆
(3520)_l6

⇒ For the system with given characteristic equat
3, 2, 0
4, 0, 1
3, 0, 2
4, 1, 0

⇒ The voltage and current distributions on a grounded λ/4 dipole (Marconi antenna) are similar to those of a half wave dipole in space.
TRUE
FALSE

⇒ The number of FF required for a divide by 12 circuit is
16
12
8
4

⇒ The state equations are in the form
X = AX + BW
X = AX + Bu
X = AX + Bx
either (a) or (b)

⇒ Which of the following statement is false?
A half-wave dipole is a resonant antenna
A horizontal antenna transmits radio signal with horizontal polarization
The field strength of 200 mV/m will produced 200 μV of signal in an antenna 2 m long
All of the above

⇒

Assertion (A): A BJT can be used as a switch.

Reason (R): In forward active mode emitter base junction is forward biased and base collector junction is reverse biased.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Suppose a microprocessor has memory locations from 0000 to 3FFF, each storing I byte. How many bytes the memory can storing I bytes the memory can store?
4384
8644
12688
16384

⇒ When an electric field E is applied to solid and liquid insulating materials, the internal field E_i acting at the location of atom is such that
E_i = E
E_i > E
E_i < E
E_i may be equal to or less than E

⇒ In 8085 microprocessor, how many lines are there in address bus?
6
8
12
16

⇒ It has been found that in a rectifier circuit with RC filter one RC section reduces ripple by 15%. Two RC sections are used in cascade the reduction in ripple would be
0.15
0.3
1.5
2.25

⇒ Equipotential surfaces about a point charge are in which one of the following forms?
Sphere
Planes
Cylinders
Cubes

⇒ A linear displacement digital transducer generally uses
straight binary code
BCD
gray code
hexadecimal code

⇒ The rms voltage measured across each of the circuit element in figure is as shown, when the circuit is excited by a sinusoidal voltage E_s, the rms value of the source voltage e_{s10 volt
2 volt
E_s
5 volt}

⇒

Match the following:

	List I (Characteristics)		List II (Device)
A.	Voltage controlled device	1.	BJT
B.	Current controlled device	2.	UJT
C.	Conductivity modulation device	3.	FET
D.	Negative conductance device	4.	Impatt diode

A-2, B-3, C-1, D-1
A-2, B-3, C-4, D-1
A-3, B-1, C-2, D-4
A-3, B-1, C-4, D-2

⇒ Choose the correct option
tree does not contain any loop
tree contain all the nodes
tree is always open
all

⇒ Which of following antenna produces elliptical polarisation?
Helical
Parabolic
Dipole
None

⇒ Negative feedback reduces noise originating at the amplifier input.
TRUE
FALSE

⇒ Electrons can be emitted from a metal surface due to high electric field.
TRUE
FALSE

⇒ In a JK master slave flip flop race condition does not occur.
TRUE
FALSE

⇒

Assertion (A): Copper is a monoatomic solid.

Reason (R): In a metal the valence electrons belong to all atoms.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ When a magnetic circuit is compared with an electric circuit, the equivalent of the magnetic flux is
the conductivity of the lines
the voltage of the source
the current in the lines
the conductance of the load

⇒ The coil of a moving iron instrument has a resistance of 500 Ω and an inductance of 1 H. It reads 250 V when a 250 V dc is applied. If series resistance is 2000 Ω, its reading when fed by 250 V, 50 Hz ac will be
260 V
252 V
250 V
248 V

⇒ A signal g(t) = A then g(t) is a
energy signal
power signal
neither energy nor power signal
insufficient data

⇒ AM transmitter employing low level modulation
uses class C amplifier for amplification
requires higher audio power
has a poor efficiency
has a higher efficiency