Question is ⇒ A load curve indicates, Options are ⇒ (A) average power used during the period, (B) average kWh (kW) energy consumption during the period, (C) either of the above, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ A load curve indicates, Options are ⇒ (A) average power used during the period, (B) average kWh (kW) energy consumption during the period, (C) either of the above, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A load curve indicates
A.	average power used during the period [Wrong Answer]
B.	average kWh (kW) energy consumption during the period [Correct Answer]
C.	either of the above [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 7 -3 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following is not necessarily an advantage of interconnecting various power stations ?
Improved frequency of power supplied
Reduction in total installed capacity
Increased reliability
Economy in operation of plants

⇒ Direct conversion of heat into electrical energy is possible through
fuel cells
solar cells
MHD generators
none of the above

⇒ The area under a load curve gives
average demand
energy consumed
raaximum demand
none of the above

⇒ In a distribution system, in order to improve power factor, the synchronous capacitors are installed
at the receiving end
at the sending end
either (a) or (b)
none of the aboye

⇒ Large capacity generators are invariably
water cooled
natural air cooled
forced air cooled
hydrogen cooled

⇒ An induction motor has relatively high power factor at
rated r.p.m.
no load
20 percent load
near full load

⇒ Air will not be the working substance in which of the following ?
Closed cycle gas turbine
Open cycle gas turbine
Diesel engine
Petrol engine

⇒ ____ is invariably used as base load plant.
Diesel engine plant
Nuclear power plant
Gas turbine plant
Pumped storage plant

⇒ ____ is invariably used for peak load
Nuclear power plant
Steam turbine plant
Pumped storage plant
None of the above

⇒ Generating capacity connected to the bus bars and ready to take load when switched on is known as ____
firm power
cold reserve
hot reserve
spinning reserve

⇒ Maximum demand tariff is generally not applied to domestic consumers because
they consume less power
their load factor is low
their maximum demand is low
none of the above

⇒ For any type of consumer the ideal tariff is
two part tariff
three part tariff
block rate tariff
any of the above

⇒ Approximate estimation of power demand can be made by
load survey method
statistical methods
mathematical method
economic parameters

⇒ The primary reason for low power factor is supply system is due to installation of
induction motors
synchronous motors
single phase motors
d.c. motors

⇒ For the same cylinder dimensions and speed, which of the following engine will produce least power ?
Supercharged engine
Diesel engine
Petrol engine
All of the above engines will equal power

⇒ Direct conversion of heat into electric power is possible through
fuel cell
batteries
thermionic converter
all of the above

⇒ Which of the following is the disadvantage of static capacitor for power factor improvement ?
Easily damaged by high voltage
Cannot be repaired
Short service life
All of the above

⇒ A load curve indicates
average power used during the period
average kWh (kW) energy consumption during the period
either of the above
none of the above

⇒ Low power factor is usually not due to
arc lamps
induction motors
fluorescent tubes
incandescent lamp

⇒ During load shedding
system power factor is changed
some loads are switched off
system voltage is reduced
system frequency is reduced

⇒ Which of the following equipment provides fluctuating load ?
Exhaust fan
Lathe machine
Welding transformer
All of the above

⇒ Load factor of a power station is generally
equal to unity
less than unity
more than unity
equal to zero

⇒ In India production and distribution of electrical energy is confined to
private sector
public sector
government sectors
joint sector

⇒ A consumer has to pay lesser fixed charges in
flat rate tariff
two part tariff
maximum demand tariff
any of the above

⇒ The load factor of domestic load is usually
10 to 15%
30 to 40%
50 to 60%
60 to 70%

⇒ A pilot exciter is provided on generators for which of the following reasons ?
To excite the poles of main exciter
To provide requisite starting torque to main exciter
To provide requisite starting torque to generator
None of the above

⇒ For cooling of large size generators hydrogen is used because
it is light
it offers reduced fire risk
it has high thermal conductivity
all of the above

⇒ Which lightening stroke is most dangerous ?
Direct stroke on line conductor
Indirect stroke on conductor
Direct stroke on tower top
Direct stroke on ground wire

⇒ For which of the following power plants highly skilled engineers are required for running the plants ?
Nuclear power plants
Gas turbine power plants
Solar power plants
Hydro-electric power plants

⇒ In power plants insurance cover is provided for which of the following ?
Unskilled workers only
Skilled workers only
Equipment only
All of the above