Question is ⇒ A load commutated chopper circuit has, Options are ⇒ (A) one thyristor, (B) two thyristors, (C) four thyristors, (D) six thyristors, (E) , Leave your comments or Download question paper.

Question is ⇒ A load commutated chopper circuit has, Options are ⇒ (A) one thyristor, (B) two thyristors, (C) four thyristors, (D) six thyristors, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A load commutated chopper circuit has
A.	one thyristor [Wrong Answer]
B.	two thyristors [Wrong Answer]
C.	four thyristors [Correct Answer]
D.	six thyristors [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Dielectric materials have high specific resistance.
TRUE
FALSE

⇒ Three resistances of 15 Ω, 10 Ω and 3 Ω are connected in parallel. The overall resistance is
less than 3 Ω
between 15 and 10 Ω
between 10 and 3 Ω
more than 3 Ω

⇒

Assertion (A): In many materials, dielectric polarization causes mechanical distortion.

Reason (R): If dielectric polarization causes mechanical distortion then mechanical distortion must cause dielectric polarization.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Symbol shown in figure represen
P-channel DEMOSFET
N-channel DEMOSFET
UJT with N-type base
UJT with P-type base

⇒ Which of the following method cannot be used to increase the bandwidth for cascaded RF amplifier stages?
Wave traps in each stage
Stagger tuning
A shunt damping resistor across each tuned circuit
Doubled tuned transformers with tighter coupling

⇒ In a JFET, the lower end is called the __________ and the upper end is called the __________ .
source, channel
channel, drain
source, drain
drain source

⇒ Hysteresis curve is associated with motion of domain walls.
TRUE
FALSE

⇒ Values of V_T at 20°C for an ideal P-N diode
25.27 mV
30.3 mV
23 mV
50 mV

⇒ In 2's complement representation the number 11100101 represents the decimal number
37
-31
27
-27

⇒

Assertion (A): Electrodynamic instrument is not used as ammeter or voltmeter.

Reason (R): Electrodynamic instrument is more costly than PMMC and moving iron instrument.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In a tape recorder the output from RF oscillator is given to
only erase head coil
only record head coil
coils of both erase head and record head
none of the above

⇒ In 8085 microprocessor, how many I/O ports can be accessed by direct method?
8
256
32 K
64 K

⇒ An audio frequency of 5 kHz is translated to a radio frequency carrier of frequency 1 MHz and transmitted it to space through an antenna. The required height of antenna is
150 m
300 m
75 m
600 m

⇒ A stationary process has
all statistical properties independent of time
all statistical properties dependent of time
zero variance
ensemble average equal to time average

⇒ Nibble is
a string of 4 bits
a string of 8 bits
a string of 16 bit
a string of 64 bits

⇒ If 1.5% of the output of an amplifier is feedback positively to the input, the minimum gain required of the amplifier for oscillations to occur, is
16.6
44.4
66.6
75

⇒ In FDM systems used for telephone, which modulation scheme is adopted?
AM
DSB-SC
SSB-SC
FM

⇒ Three capacitors each 9 μF are connected in delta. The value of each capacitor in equivalent star connection is
3 μF
6 μF
27 μF
81 μF

⇒ Mouse is a very suitable input device for computers.
TRUE
FALSE

⇒ The depletion layer consists of immobile ions.
TRUE
FALSE

⇒ Consider the following state
1 only
1 and 2
2 only
3 only

⇒ The general purpose register code for accumulator in 8085 is
111
0
1
1111

⇒ Cross talk is due to reception of portions of a signal from one channel into another.
TRUE
FALSE

⇒ A circuit has two branches in parallel and each branch has only one element. The applied voltage and source current are v = 200 sin (200t + 30°) and i = 50 sin (200t + 50°). If one branch has capacitor, the other branch contains
resistance
inductance
capacitance
resistance or capacitance

⇒

Assertion (A): Ideal current sources and ideal voltage sources do not exist in reality.

Reason (R): All sources have finite internal impedances.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The equivalent form of the logical expression ABC + A BC + ABC + ABC + AB C is
C + (A ⊕ B)
(A + B + C)(A + B + C)
(A + B + C)(A + B + C)(A + B + C)
(A + B + C)(A + B + C)(A + B + C)

⇒ CE mode input V-I characteristic can be shown by a plot of
V_BE versus i_B for constant values of V_CE
V_CB versus i_C for constant values of I_E
V_CE versus i_E for constant values of V_EB
V_CE versus i_E for constant values of V_CE

⇒ The dynamic equalising circuit consists of a series combination of capacitor C and resistor R_C across each thyristor. This resistance R_C (along with parallel connected diode)
limits charging current
limits discharging current
limits both charging and discharging currents
none of the above

⇒ In measuring a resistance by voltmeter-ammeter method, the voltmeter can be connected either across supply or across the resistance. If the resistance is low, the voltmeters should be connected
across the supply
across the resistance
either in two positions
preferably across the supply

⇒

Match the following:

	List I (Electron spin)		List II (Phenomenon)
A.	↑↑↑↑	1.	Antiferromagnetism
B.	↑↓↑↓	2.	Ferrimagnetism
C.	↑↓↑↓	3.	Ferromagnetism

A-1, B-2, C-3
A-3, B-2, C-1
A-2, B-3, C-1
A-3, B-1, C-2