Question is ⇒ A linear displacement digital transducer generally uses, Options are ⇒ (A) straight binary code, (B) BCD, (C) gray code, (D) hexadecimal code, (E) , Leave your comments or Download question paper.

Question is ⇒ A linear displacement digital transducer generally uses, Options are ⇒ (A) straight binary code, (B) BCD, (C) gray code, (D) hexadecimal code, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A linear displacement digital transducer generally uses
A.	straight binary code [Wrong Answer]
B.	BCD [Wrong Answer]
C.	gray code [Correct Answer]
D.	hexadecimal code [Wrong Answer]
View Answer 3 -4 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a specimen of n type semiconductor, the initial concentration of holes and electrons is p_no and n_no. When the specimen is subjected to radiation, the hole and electron concentration increase to p_n and n_n. Then
p_n - p_no = n_n - n_no
p_n + p_no = n_n + n_no
p_n - p_no = n_no + n_no
p_n + p_no = n_n - p_no

⇒ A silicon controlled switch has :
2 leads
3 leads
4 leads
5 leads

⇒ Tuned voltage amplifiers are not used
radio receivers
public address system
T.V. Receivers
band of freq. selected and amplified

⇒ For stable network the real parts of poles and zeros of driving point functions must be
negative
negative or zero
zero
positive

⇒ A land line telemetry system is suitable for distance upto
about 1 km only
about 10 km only
about 100 km only
any of the above

⇒ In the spectrum of an FM wave
When modulation index is large, carrier frequency disappears
carrier frequency cannot disappear
amplitude of any side band depends on modulation index
the total number of side bands depend on modulation index

⇒ In a 4 bit parallel in parallel out shift register A = 1, B = 1, C = 0, D = 1. The data output after 3 clock pulses is
1101
1001
101
1

⇒ The number of electrons in motion at the instant of positive peak of a symmetrical ac wave is the same as that at the instant of negative peak.
TRUE
FALSE

⇒ Which of the following terms is not applicable to Yagi-Uda array?
High gain
Folded dipole
Parasitic elements
Good bandwidth

⇒ The parameter A of a two port network is equal to
V₂/V₁ with I₁ = 0
V₁/I₂ with V₂ = 0
I₁/I₂ with V₂ = 0
V₁/V₂ with I₂ = 0

⇒ System satellites orbit the Earth once in
24 hours
12 hours
1 hours
6 hours

⇒ Power transistors are invariably provided with
soldered connections
heat sink
metallic casing
none of the above

⇒ In the human eye, an image persists for a time of about
1 second
0.1 second
0.05 second
0.02 second

⇒ Calculate the critical frequency for the E layer if maximum ionic densities are 3 x 10⁶
15.58 x 10⁶
15.58 kHz
1.58 x 10³
None of the above

⇒ The binary addition 1 + 1 =
11
10
111
100

⇒ For the 8085 assembly language program given below, the content of the accumulator after the execution of the progra
00H
45H
67H
E7H

⇒ A 3 input NAND gate is to be used as inverter. Which of the following will give better results?
The two unused inputs are left open
The two unused inputs are connected to 0
The two unused inputs are connected to 1
None of the above

⇒ A bulb rated at 60 W, 120 V is used for 30 minutes. The charge associated with this operation is
3600 C
900 C
7200 C
600 C

⇒ A 3 phase induction motor is controlled by voltage and frequency control such that the ratio V/f is constant. At 50 Hz, the speed is 1440 rpm. At 25 Hz, the speed is likely to be
about 1350 rpm
about 720 rpm
about 360 rpm
either (b) or (c)

⇒ In radar PRF depends on maximum range.
TRUE
FALSE

⇒ Transfer functions of even complicated components can be found by frequency response tests.
TRUE
FALSE

⇒ Which of the following is a valid real constant in FORTRAN 77?
1.2 E 231
3 E - 2
-3.2 E 2.3
1.2 E 23

⇒ Typical values of h parameters at about 1 mA collector current for small signal audio amplifier in CE configuration are :
h_ie = 100 Ω, h_re = 10^-1, h_fe = 50, h_oe = 1 m mho
h_ie = 5 kΩ, h_re = 10^-4, h_fe = 200, h_oe = 20 m mho
h_ie = 5 kΩ, h_re = 0, h_fe = 50, h_oe = 2 m mho
h_ie = 100 kΩ, h_re = 10^-2, h_fe = 100, h_oe = 10 m mho

⇒ In a metal the probability of a state 0.1 eV below Fermi level being occupied
is more than the probability of state 0.1 eV above Fermi level being occupied
is the same as the probability of state 0.1 eV above Fermi level being occupied
is less than the probability of state 0.1 eV above Fermi level being occupied
may be equal to or more or less than the probability of state 0.1 eV above Fermi level being occupied

⇒ Which one most appropriate dynamic system?
y(n) + y(n - 1) + y(n + 1)
y(n) + y(n - 1)
y(n) = x(n)
y(n) + y(n - 1) + y(n + 3) = 0

⇒ An incremental model of a solid state device is one which represents the
ac property of the device at desired operating point
dc property of the device at all operating points
complete ac and dc behaviour at all operating points
ac property of the device at all operating points

⇒ In figure, the switch is closed at t = 0 when current through inductor is 6 A, the rate of change of current through resistor is 6 A/s. The value of
1 H
2 H
3 H
4 H

⇒ Huffman code is also known as redundancy code
TRUE
FALSE
in some cases
depend upon efficiency

⇒ Which of the transistor models is most preferred for the analysis of a transistor circuit both at mid-band and at high frequencies?
h-parameter model
y-parameter model
s-parameter model
hybrid-p model

⇒ Surface impedance at high frequencies is a consideration for
good conductors
semiconductors
dielectrics
ferrites