Question is ⇒ A lens has a hyperfocal distance of 7.5 m. It is focused at 7.5 m. Then, Options are ⇒ (A) all objects from 7.5 m to infinity will appear in focus, (B) all objects from 3.75 m to infinity will appear in focus, (C) all objects from 0 to 7.5 m will appear in focus, (D) all objects from 0 to 3.75 m will appear in focus, (E) , Leave your comments or Download question paper.

Question is ⇒ A lens has a hyperfocal distance of 7.5 m. It is focused at 7.5 m. Then, Options are ⇒ (A) all objects from 7.5 m to infinity will appear in focus, (B) all objects from 3.75 m to infinity will appear in focus, (C) all objects from 0 to 7.5 m will appear in focus, (D) all objects from 0 to 3.75 m will appear in focus, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A lens has a hyperfocal distance of 7.5 m. It is focused at 7.5 m. Then
A.	all objects from 7.5 m to infinity will appear in focus [Wrong Answer]
B.	all objects from 3.75 m to infinity will appear in focus [Correct Answer]
C.	all objects from 0 to 7.5 m will appear in focus [Wrong Answer]
D.	all objects from 0 to 3.75 m will appear in focus [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The reactance of bypass capacitor in a CE amplifier circuit should be
equal to the resistance in parallel with it
equal to 10% or less of the resistance in parallel with it
equal to 50% of the resistance in parallel with it
independent of the resistance in parallel with it

⇒ The integral of a unit step function is
an impulse function
a ramp function
a ramp function of slope 1
none of these

⇒ The line of sight communication requires the transmit and receive antennas to face each other. If the transmit antenna is vertically polarized, for best reception to the receive antenna should be
horizontally polarized
vertically polarized
at 45° within respect to horizontal polarization
at 45° with respect to vertical polarization

⇒ Class-B amplifier has less efficiency compared to
class A
class B
class C
class A, AB and C

⇒ In low power factor wattmeter, the compensating coil is connected
in series with current coil
in parallel with current coil
in series with pressure coil
in parallel with pressure coil

⇒ The transistor of following figure in Si diode with a base current of 40 μA and I_CBO = 0, if V_BB = 6V, R_E = 2 kΩ and β = 90, I_BQ = 20 μA then I_{EQ1800 μA
180 μA
2000 μA
3000 μA}

⇒ Consider the following statements about polar plots

Addition of a non-zero pole to a transfer function results in further rotation of polar plot through an angle of - 90° as ω → ∞
Addition of a pole at the origin to a transfer function rotates the polar plot at zero and infinite frequencies by a further angle of - 90°

Of the above statements:
Both are correct
Both are wrong
1 is correct and 2 is wrong
2 is correct and 1 is wrong

⇒ Which camera tube has highest sensitivity and very wide spectral response?
Vidicon
Plumbicon
New vicon
Saticon

⇒ As wavelength decrease the size of high directivity antenna
decreases
increases
is not affected
either (b) or (c)

⇒ In cell communication, cell stands for
Geographical Area
Battery
Location
No meaning

⇒ RECTIFIER : OSCILLATOR ::
Capacitance : Inductance
Series resonance : Parallel resonance
DC : AC
Regulation : Efficiency

⇒ A video transmission system transmits 625 picture frames per second. Each frame consist of a 400 x 400 pixel grid with 64 intensity levels per pixel. The data rate of the system is
16 Mbps
100 Mbps
600 Mbps
6.4 Gbps

⇒ Calculate wave impedance for TE mode
(377)Ω
226 Ω
∞
629 Ω

⇒

Match the following:

	List I		List II
A.	PMMC	1.	Square law type scale
B.	Moving iron	2.	Very good response
C.	Thermo-couple	3.	Linear scale
D.	Electrostatic	4.	Voltmeter

A-4, B-1, C-2, D-3
A-3, B-2, C-1, D-4
A-4, B-2, C-1, D-3
A-3, B-1, C-2, D-4

⇒ Emitter follower is in which of following configuration.
common Base
common Emitter
common collector
common Base or common Emitter

⇒

Match the following:

	List I		List II
A.	Resistance	1.	M^-1L^-2T²I²
B.	Inductance	2.	ML²T^-2I^-2
C.	Capacitance	3.	M^-1L^-2T⁴I²
D.	Reluctance	4.	ML²T^-3I^-2

A-1, B-2, C-3, D-4
A-2, B-1, C-3, D-4
A-4, B-2, C-3, D-1
A-2, B-4, C-3, D-1

⇒ A series RLC circuit has a resonance frequency of 1 kHz and a quality factor Q = 100. If each of R, L and C is doubled from its original value, the new Q of the circuit is
25
50
100
200

⇒ The resolution of 4 bit counting ADC is 0.5 volt, for an Analog input of 6.6 volts. The digital output of ADC will be
1011
1101
1100
1110

⇒ An induction wattmeter can be used for
dc only
50 Hz ac only
both ac and dc
high frequency ac only

⇒ What will happen to a bird sitting on a conductor?
It will die of shock
It will not die of shock because its claws are insulated
It will not die because it is insulated from earth and other conductors
None of the above

⇒ Which of the following has unique representation of 0?
sign magnitude
1's complement
2's complement
both (b) and (c)

⇒ A certain sound has 10000 times more energy than another sound. The number of times it would sound stronger to a listener is
40
10000
100
10

⇒ Generally the gain of a transistor amplifier falls at high frequencies due to the
internal capacitance of device
coupling capacitor at the I/P
skin effect
coupling capacitor at the O/P

⇒ For the logic circuit shown in figure, the simplified Boolean expression for the output
A + B + C
AB
B
C

⇒ In Bode plots, frequency is plotted on log scale.
TRUE
FALSE

⇒ The efficiency of a chopper circuit is about
80% or more
around 50%
around 20%
around 5%

⇒

Assertion (A): A dc potentiometer measures the true open circuit emf of a source.

Reason (R): At balance point, a dc potentiometer does not draw any current from the source.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ A 3 x 8 decoder with two enable inputs is to be used to address 8 blocks of memory. What will be the size of each memory block when addressed from a sixteen bit bus with two MSBs used to enable the decoder?
2 K
4 K
16 K
64 K

⇒ The v-i characteristics of a FET is shown in figure. In which region is the device biased for small signal amplifica
AB
BC
CD
BD

⇒ A disadvantage of microstrip line as the connections of compared to strip line is that former
do not lend themselves to printed circuit
are more likely to radiate
are bulky
are more expensive and complex