Question is ⇒ A λ/8 section of transmission line is determined of load impedance of (2 - j 5) Ω. If characteristic impedance of line is 10 Ω. Then input impedance of line is, Options are ⇒ (A) 10 Ω, (B) (6.9 + j 7.24) Ω, (C) (1.75 + j 3.098) Ω, (D) (2 - j 5) Ω, (E) , Leave your comments or Download question paper.

Question is ⇒ A λ/8 section of transmission line is determined of load impedance of (2 - j 5) Ω. If characteristic impedance of line is 10 Ω. Then input impedance of line is, Options are ⇒ (A) 10 Ω, (B) (6.9 + j 7.24) Ω, (C) (1.75 + j 3.098) Ω, (D) (2 - j 5) Ω, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A λ/8 section of transmission line is determined of load impedance of (2 - j 5) Ω. If characteristic impedance of line is 10 Ω. Then input impedance of line is
A.	10 Ω [Wrong Answer]
B.	(6.9 + j 7.24) Ω [Wrong Answer]
C.	(1.75 + j 3.098) Ω [Correct Answer]
D.	(2 - j 5) Ω [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A channel has a SNR of 7 and BW 4 kHz. Keeping the channel capacity (BPS) same, the BW is reduced to accommodate more channels. The SNR
decreases
increases
remains same
partially affected

⇒ Which of the following statement about JFET is true?
In a JFET, gate and source have opposite polarity with respect to drain irrespective of the type of FET
In its schematic symbol for JFET, the arrow always points to p-type material
In an n-channel JFET, the channel is the narrowest under zero gate bias condition
In JFET, gate source cut off voltage is numerically equal to the pinch off voltage

⇒ MS Access is a DBMS software.
TRUE
FALSE

⇒ A single phase semiconverter is feeding a highly inductive load and has a freewheeling diode across the load. The waveshape of input current is
sinusoidal
rectangular
sinusoidal or rectangular
triangular

⇒

Assertion (A): The equation D = ∈₀∈_rE is applicable only to isotropic materials.

Reason (R): In polycrystalline materials, the directional effects are absent.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Nibble is
a string of 4 bits
a string of 8 bits
a string of 16 bit
a string of 64 bits

⇒ Wagner earthing device is used to eliminate error due to
electromagnetic coupling
electrostatic coupling
both electrostatic and electromagnetic coupling
either (a) or (b)

⇒ Thevenin's impedance of an ac network is in general
resistance
R and L in series
R and C in series
Either R and L or R and C in series

⇒ The current due to thermionic emission is given by Richardson Dushman equation.
TRUE
FALSE

⇒ The total electrical energy emitted overall space from an electron of charge e and radius r is
e/ε₀r²
e²/ε₀r
e²/4pε₀r²
e²/8pε₀r

⇒ A sinusoidal signal is measured by CRO. The scale is set at 4 mV/cm. If vertical distance between positive and negative peaks is 6 cm, the peak value of ac signal is
6 mV
12 mV
24 mV
3 mV

⇒ A capacitor is considered to be completely charged in __________ time constant.
one
three
five
eight

⇒ Consider the following statements regarding registers and latches:

Registers are made of edge-triggered FFs, whereas latches are made from level-triggered FFs.
Registers are temporary storage devices whereas latches are not.
A latch employs cross-coupled feedback connections.
A register stores a binary word whereas a latch does not.

Which of the above statements is/are correct?
1 only
1 and 3
2 and 3
3 and 4

⇒ For the logic circuit of the given figure the simplified Boolean expressio
A + BC
A + BC
A + B C
A + BC

⇒ The silicon sample with unit cross-sectional area shown below is in thermal equilibrium. The following information is given: T = 300 K, electronic charge = 1.6 x 10^-19C, thermal voltage = 26mV and electron mobility = 1350 cm²
1 kV/cm
5 kV/cm
10 kV/cm
26 kV/cm

⇒ Of the various capacitances associated with a junction transistor the gain bandwidth product is affected to maximum extend by
base collector parasitic capacitor
base collector space charge layer capacitance
base emitter space charge layer capacitance
base emitter diffusion capacitance

⇒ Which one of the following theorem can be conveniently used to calculate the power consumed by the 10 Ω resistor in the network shown in the above fig
Thevenin's theorem
Maximum power transfer theorem
Millman's theorem
Superposition theorem

⇒ In figure, the effective capacitance between A and
2 μF
4 μF
8 μF
10 μF

⇒ Henry is equivalent to
Volts/Ampere
Weber/Volt
Weber/Ampere
Weber/Ampere²

⇒ Reception through space wave is limited to line of sight distance.
TRUE
FALSE

⇒ The z-transform of a particular signal is gi
casual and stable
non-casual and stable
non-casual and unstable
casual and unstable

⇒ IC 74181 has two select lines.
TRUE
FALSE

⇒ The complement of exclusive OR function is
AB + A B
AB + A B
A B + A
AB + A B

⇒ Which of the following can provide two or more voice circuits with the same carrier?
SSB
Carrier reinsertion
Lincompex
Independent side band system

⇒

Assertion (A): The transient performance of a control system is generally analysed by using unit step function as reference input.

Reason (R): Impulse is the most common input found in practice.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ n type semiconductors
are negatively charged
are produced when indium as impurity is added to germanium
are produced phosphorus as impurity is added to silicon
none of the above

⇒ The time constant of a series RL circuit is
LR
L/R
R/L
e^-R/L

⇒ In 8085, which of the following registers cannot be paired?
A
E
C
both (b) and (c)

⇒ A variable resistance R and capacitive reactance X_C are fed by an voltage. The current locus is
a semi circle in 4th quadrant
a semi circle in first quadrant
a straight line in 4th quadrant
a straight line first quadrant

⇒ A voltage of about 200 V dc can be measured
directly by dc potentiometer
by dc potentiometer in conjunction with a volt ratio box
a dc potentiometer in conjunction with a known resistance
both (b) and (c)