Question is ⇒ A n-channel JFET has IDSS = 2 mA, Gate to source voltage VGS = - 2 V and trans-conductance is 0.5 mW then pinch-off voltage is __________ ., Options are ⇒ (A) - 2 V, (B) 2 V, (C) - 4 V, (D) 4 V, (E) , Leave your comments or Download question paper.

Question is ⇒ A n-channel JFET has IDSS = 2 mA, Gate to source voltage VGS = - 2 V and trans-conductance is 0.5 mW then pinch-off voltage is __________ ., Options are ⇒ (A) - 2 V, (B) 2 V, (C) - 4 V, (D) 4 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A n-channel JFET has I_DSS = 2 mA, Gate to source voltage V_GS = - 2 V and trans-conductance is 0.5 mW then pinch-off voltage is __________ .
A.	- 2 V [Wrong Answer]
B.	2 V [Wrong Answer]
C.	- 4 V [Correct Answer]
D.	4 V [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The depletion layer in a reverse biased p-n junction is due to the presence of
electrons
holes
both electrons and holes
immobile ions

⇒ In the circuit of figure the current through L at t = &infin
0
0.416666666666667
6.67 A
5.1 A

⇒

Match the following:

	List I		List II
A.	Serial Binary adder	1.	(2n - 1)t_pd
B.	Ripple carry adder	2.	(n - 1)t_pd
C.	Carry look ahead binary adder	3.	Operation time independent of size
		4.	6t_pd for 4 bit carry look ahead adder

A-2, B-1, C-3
A-2, B-1, C-4
A-1, B-2, C-4
A-1, B-2, C-3

⇒ The 'h' parameters of the circuit shown in the figure are h_ib = 25 Ω, h_fb = 0.999 and h_ob = 10^-6Ω The Voltage gai
0.99
1.98
2
4

⇒ A moving coil instrument has a resistance of 0.6 Ω and full scale deflection at 0.1 A. To convert it into an ammeter of 0-15 A range, the resistance of shunt should be
0.6 Ω
0.06 Ω
0.1 Ω
0.004 Ω

⇒ To measure a resistance of about 8 ohms we should use
Kelvin's double bridge
Wheatstone bridge
Meggar
Either (b) or (c)

⇒ For the system in the given figure G varies slightly, the ratio of open loop sensitivity to closed loop sensitivit
1 : (1 + GH)
1 : (1 + GH)^-1
1 : (1 - GH)
1 : (1 - GH)^-1

⇒ The binary number 101100.110 in octal number will be
152.6
154.6
145.6
174.6

⇒ Which of the following is not a keyword in C?
int
float
return
capital

⇒ For the network in figure, which of the following expressions gives the value of net inductance between terminals A and B
1 only
1 and 2
3 and 4
2 and 4

⇒ The circuit shown in figure, will act as an ideal current source with respect to terminals A and B, when frequenc
zero
1 rad/s
4 rad/s
16 rad/s

⇒ Satellite launch sites are invariably located on Eastern seaboards to ensure that
launch takes place eastward
expenditure of propulsion fuel is reduced during plane changing
the satellite achieves circular orbit quickly
spent rocket motor and other launcher debris falls into the sea

⇒ Epitaxial growth is used in IC_s
because it produces low parasitic capacitance
because it yields back to back isolating pn Junction
to grow single crystal n doped silicon on a single crystal P-type substrate
to grow Selectivity single crystal P doped silicon of one resistivity on a P type substrate of a different resistivity

⇒
Assertion (A): The exponential form of Fourierserie
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Which of the following statement about the amplitude limiter is not valid?
Leak type bias must be used
Output must be tuned
The circuit is always biased in class C, by virtue of the leak type bias
When the input increases past the threshold of limiting, the gain decreases to keep the output constant

⇒ The semiconductor diode which can be used in switching circuit in microwave range is
PIN diode
Varactor diode
Tunnel diode
Gunn diode

⇒
Match the following:
List I (Form) List II (Network)
A. Cauer I 1. L in series arm and C in shunt arm of ladder
B. Cauer II 2. C in series arm and L in shunt arm of ladder
C. Foster I 3. Series combination of L and C in parallel
D. Foster II 4. Parallel combination of L and C in series

A-1, B-2, C-3, D-4
A-1, B-2, C-4, D-3
A-2, B-1, C-4, D-3
A-2, B-1, C-3, D-4

⇒ In figure the bridge is balanced when Z₄
120∠70°
187.5∠ - 10°
187.5∠ - 70°
333.3∠ - 70°

⇒ To measure an emf by dc potentiometer it is necessary to standardise the potentiometer with the help of a standard cell.
TRUE
FALSE

⇒ In figure, V_{020 V
10 V
5 V
0}

⇒ The inductance of a coil can be increased by
choosing core material having high relative permeability
decreasing diameter of the former
decreasing the number of turns
increasing core length

⇒ A second order system will have
all resistances
resistances and inductances
resistances, inductance and capacitances
either (b) or (c)

⇒ Audio and video signals are called modulating waves.
TRUE
FALSE

⇒ For global communication, the number of satellites needed is
1
3
10
5

⇒ Find V_th in the cir
100 V
10 V
0 V
5 V

⇒ The rms value of wave in figur
about 95 V
about 80 V
about 50 V
about 25 V

⇒ The box on the external left of the title bar of menu is called control menu box.
TRUE
FALSE

⇒ The data about p the pull required to lift a weight wby a pulley bloc
3.2 + 0.171 w
2.28 + 0.1879 w
1.2 + 0.25 w
0.6 + 0.3 w

⇒ The term __________ applies to troposcatter propagation
fading
Faraday rotation
SIDS
atmospheric storms

⇒ Mobility of electrons and holes are equal.
TRUE
FALSE

	List I (Form)		List II (Network)
A.	Cauer I	1.	L in series arm and C in shunt arm of ladder
B.	Cauer II	2.	C in series arm and L in shunt arm of ladder
C.	Foster I	3.	Series combination of L and C in parallel
D.	Foster II	4.	Parallel combination of L and C in series

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math