Question is ⇒ A higher directivity is specified by, Options are ⇒ (A) high gain low BW (Beamwidth), (B) high gain high BW, (C) low gain high BW, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ A higher directivity is specified by, Options are ⇒ (A) high gain low BW (Beamwidth), (B) high gain high BW, (C) low gain high BW, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A higher directivity is specified by
A.	high gain low BW (Beamwidth) [Correct Answer]
B.	high gain high BW [Wrong Answer]
C.	low gain high BW [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Match the following:

	List I		List II
A.	Firm ware	1.	Converts program in high level language to machine language
B.	Compiler	2.	Converts assembly language program into machine language
C.	Assembler	3.	Software embedded in hardware
D.	Virtual addressing	4.	Grouping information between various memories

A-1, B-2, C-3, D-4
A-2, B-3, C-4, D-1
A-3, B-4, C-1, D-2
A-3, B-1, C-2, D-4

⇒ The unit for luminous energy is
lumens/sec
lumens/m²
lumen-sec
lumen/m

⇒ A chopper is a high efficiency circuit.
TRUE
FALSE

⇒

Assertion (A): An ac amplifier uses coupling capacitors at input and output

Reason (R): The capacitive reactance varies inversely with frequency. It is infinite for dc

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The circuit of the given figure realizes the func
Y = (A + B) C + DE
Y = A + B + C + D + E
AB + C +DE
AB + C(D + E)

⇒ The h parameter equivalent circuit of BJT has one voltage source and one current source.
TRUE
FALSE

⇒ The bandwidth of DSB suppressed carrier modulation system when the modulating frequency varies between 500 Hz and 5 kHz is
555 kHz
505 kHz
500 kHz
9 kHz

⇒ A line of characteristic impedance 400 Ω is terminated by a resistance of 400 Ω. The reflected quantities are
zero
equal to incident quantities
half the incident quantities
double the incident quantities

⇒ A thermal power plant has an efficiency of 0.4. If 0.6 kg of coal is burnt to generate 1 kWh, the calorific value of coal is
about 3500 kcal/kg
about 2500 kcal/kg
about 1500 kcal/kg
about 7500 kcal/kg

⇒ Which of the following is incorrect?
(8)₁₆ = (8)₈
(5)₁₆ = (5)₈
(8)₂ = (2)₁₀
(2)₁₆ = (2)₁₀

⇒ In an oscillator crystal, the parallel resonant frequency is
equal to
higher than
less than
series resonant frequency

⇒ The ratio of the diffusion coefficient in a semiconductor has the units
V^-1
em.V^-1
V.cm^-1
V.s

⇒ In a high frequency coaxial line and the length of line characteristic impedance is a function of
properties of insulating material only
inner and outer conductor radius only
both (a) and (b)
neither (a) nor (b)

⇒ In 8085 microprocessor, even after a Reset operation which of the following interrupts remains enabled?
INTR
RST 5.5
RST 7.5
TRAP

⇒ In free space, line of sight propagation case, the transmission losses between transmitter and receiver increase with frequency (f) as
f
f²
f⁴
f^1/2

⇒ Which of the following modulation is analog in nature?
PCM
DPCM
DM
PDM

⇒ The log magnitude for the system in the given figure is (where T =
20 log (1 + ωT)
-20 log (1 + ωT)
-10 log (1 + ω²T²)
-20 log (1 + ω²T²)

⇒ An oscillator at 4.2 MHz is followed by two frequency doublers and two triplers. The output frequency will be
84 MHz
112.4 MHz
151.2 MHz
303.4 MHz

⇒

Match the following:

	List I (Antenna)		List II (Communication system)
A.	Turnstile	1.	Radar
B.	Yagi	2.	TV transmission
C.	Dish	3.	MW broadcasting
D.	Vertical mast	4.	TV reception

A-4, B-2, C-3, D-1
A-2, B-4, C-1, D-3
A-2, B-4, C-3, D-1
A-4, B-2, C-1, D-3

⇒ A linear diode detector uses RC filter. As modulation index increases the maximum permissible value of time constant RC
increases
decreases
remains constant
either (a) or (c)

⇒ To produce magnetic flux, mmf is necessary.
TRUE
FALSE

⇒ In energy band diagram of n type semiconductor, the donor energy level is
in valence band
in conduction band
slightly above valence band
slightly below conduction band

⇒ Some desirable features of a computer communication network are

It should accept an intended transmission without excessive delay
The data arriving at a receiving point should be processed rapidly
When a transmission calls for a response, the delay of response should be minimum.

Which of the above are true?
1 and 2 only
1 and 3 only
1, 2, 3
2 and 3 only

⇒ In a linear op-amp circuit
the product of gain and bandwidth is constant
input can be dc only
input can be ac only
saturation may occur

⇒ The normalised form of 1.81 x 10^-11 is
18.1 x 10^-12
18.1 x 10^-13
0.181 x 10^-10
0.0181 x 10^-9

⇒ The input resistance R, of an ideal voltage amplifier is __________ and that of a current amplifier is __________ .
zero, zero
infinite, infinite
zero, infinite
infinite, zero

⇒ Fields are said to be circularly polarized if
their magnitudes are equal
their magnitudes are equal and they differ in phase by ± 90°
their magnitudes are unequal and they differ in phase ± 90°
their magnitudes are unequal and they are in phase

⇒ What is the frequency of audio modulation?
1000 Hz
2000 Hz
3000 Hz
2000 kHz

⇒ The units for intrinsic strength of dielectric are
kV
kV/m
A
A/m

⇒ In figure the cut in voltage of diode is 0.7 V and its bulk resistance is 20 Ω. The peak value of circuit current of during positive and negative half cycles
10 mA and zero
9.12 mA and zero
9.3 mA and zero
zero and 9.12 mA