Question is ⇒ A Hartley oscillator uses, Options are ⇒ (A) a tapped capacitor, (B) a tapped inductor, (C) a tapped inductor for inductive feedback, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ A Hartley oscillator uses, Options are ⇒ (A) a tapped capacitor, (B) a tapped inductor, (C) a tapped inductor for inductive feedback, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A Hartley oscillator uses
A.	a tapped capacitor [Wrong Answer]
B.	a tapped inductor [Wrong Answer]
C.	a tapped inductor for inductive feedback [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In single tone AM modulation, the transmission efficiency for m = 1 is
0.333
0.5
1
0.1665

⇒ Figure uses 10 V zener diode. The minimum and maximum current through series resistance
10 mA and 30 mA
20 mA and 40 mA
0 and 30 mA
0 and 40 mA

⇒

Match the following:

	List I		List II
A.	Servomotor	1.	Error detector
B.	Amplidyne	2.	Transducer
C.	Potentiometer	3.	Actuator
D.	Flapper valve	4.	Power amplifier

A-3, B-1, C-2, D-4
A-4, B-3, C-2, D-1
A-3, B-4, C-1, D-2
A-3, B-4, C-2, D-1

⇒ If operator 'a' = 1 ∠120° then (1 - a²) =
1 ∠ - 30°
1 ∠ 30°
1 ∠ - 60°
1 ∠60°

⇒ The disadvantage of FET over BJT is
poor high frequency performance
low power-handling ability
low values of voltage gain
all of the above

⇒ A frequency doubler has an FM signal input at 13 MHz with a deviation of 5 kHz. The output, frequency for the carrier will be
26 MHz
26.1 MHz
10 kHz
160 kHz

⇒

Match the following:

	List I		List II
A.	Bode	1.	Asymptotic plots
B.	Evans	2.	Polar plots
C.	Nyquist	3.	Root locus technique
		4.	M and N circles

A-1, B-4, C-2
A-2, B-3, C-4
A-3, B-1, C-4
A-1, B-3, C-2

⇒ Maximum effective aperture (A_e)max of short dipole antenna is
1.119 λ²
0.119 λ²
1.19 λ²
1.919 λ²

⇒ The number of comparators of needed in a parallel conversion type 8 bit A to D converter is
8
16
255
256

⇒ Given below a block diagram of oscillator circuit with various reactance elemen
x₁ = C, x₂ = L, x₃ = C
x₁ = C, x₂ = L, x₃ = L
x₁ = C, x₂ = C, x₃ = L
x₁ = L, x₂ = C, x₃ = L

⇒ The primary function of a clamper circuit is to
suppress variations in signal voltage
raise +ve half cycle to the signal
Lower -ve half cycle of the signal
introduce a dc level into an a.c. signal

⇒ The number of roots of s³ + 2s² + 7s + 3 = 0 in the left half of the s-plane is :
zero
one
two
three

⇒ To protect an SCR against high di/dt we connect
a capacitance in series with SCR
a capacitance in parallel with SCR
an inductance in parallel with SCR
an inductance in series with SCR

⇒ Consider isotropic radiator radiating a power of 1 watt. At a distance of 1 metre, the power per unit area with equal
1 watt/m²
4p watt/m²
1/4p watt/m²
2p watt/m²

⇒ Choose the correct option
var (X) = σ_x²
σ² = E(X²) - μ²
var (CX) = C² Var (X)
all

⇒ In a strain measuring device using a strain gauge, the output quantity is
voltage
resistance
impedance
either (a) or (b)

⇒ A good ohmic contact on a P-type semiconductor chip is formed by introducing
gold as an impurity below the contact
high concentration of donors below the contact
high concentration of acceptors below the contact
thin insulator layer between the metal and semiconductor

⇒ Data from a satellite is received in serial form (1 bit after another). If this data is coming at a 5 MHz rate and if the clock frequency is 5 MHz how long will it take to serially load a word in a 32-bit shift register?
1.6ms
3.2ms
6.4ms
12.8ms

⇒ In a transistor I_E = 10 mA, I_CO = 0.5 μA and a = 0.995. Then I_CEO =
100 μA
25 μA
10.1 mA
10.5 mA

⇒

Match the following:

	List I		List II
A.	D Layer	1.	110 km
B.	E layer	2.	10 km
C.	F layer	3.	60 km
D.	Troposphere	4.	350 km

A-3, B-1, C-4, D-2
A-2, B-1, C-4, D-2
A-3, B-2, C-1, D-4
A-4, B-3, C-1, D-2

⇒ The figure of merit for a logic family is
gain band width product
(propagation delay time) (power dissipation)
(fan out) (power dissipation)
(noise margin) (power dissipation)

⇒ In the following figure C = 0.02 μF, and V_th is known to be of frequency ω = 10⁷ rad/sec and r_d = 2.5 Ω and Z_Th = R_Th = 10 Ω Then phase angle between i_d and V_{d26.5°
25°
30°
0°}

⇒ For a type 0 system and unit ramp input, the steady state error is
0
∞
1
1/K_V

⇒ If a function Z(s) has a pole at infinity, then
the degrees of numerator and denominator are equal
the degree of numerator is one higher than that of denominator
the degree of denominator is one higher than that of numerator
the difference between the degrees of numerator and denominator is 0 or 1

⇒ Which one of the following is true?
Alternating voltage and current contain odd and even harmonics
The inductance in a circuit reduces the effect of harmonics and makes current wave more sinusoidal than voltage wave
Alternating voltage and current waveforms, in general, do not contain odd harmonics
Inductance of a circuit does not alter wave shape at all

⇒ The attenuation in a waveguide near the cut off frequency is
zero
low
high
very high

⇒ Large scale integration refers to
more than 50 gates on the same chip
more than 80 gates on the same chip
more than 100 gates on the same chip
none of the above

⇒ The presence of some holes in an intrinsic semiconductor at room temperature is due to
valence electrons
doping
free electrons
thermal energy

⇒ In figure the output v(t)
phase modulated signal
amplitude modulated signal
frequency modulated signal
none of the above

⇒ Contents of RAM cannot be altered.
TRUE
FALSE