Question is ⇒ A Hall effect transducer has KH = - 1 x 10-8. If B = 1 Wb/m2, I = 3 A and bismuth slab is 2 mm wide, the Hall voltage is, Options are ⇒ (A) -7.5 x 10-6 V, (B) -15 x 10-6, (C) -20 x 10-4 V, (D) -22.5 x 10-4 V, (E) , Leave your comments or Download question paper.

Question is ⇒ A Hall effect transducer has KH = - 1 x 10-8. If B = 1 Wb/m2, I = 3 A and bismuth slab is 2 mm wide, the Hall voltage is, Options are ⇒ (A) -7.5 x 10-6 V, (B) -15 x 10-6, (C) -20 x 10-4 V, (D) -22.5 x 10-4 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A Hall effect transducer has K_H = - 1 x 10^-8. If B = 1 Wb/m², I = 3 A and bismuth slab is 2 mm wide, the Hall voltage is
A.	-7.5 x 10^-6 V [Wrong Answer]
B.	-15 x 10^-6 [Correct Answer]
C.	-20 x 10^-4 V [Wrong Answer]
D.	-22.5 x 10^-4 V [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): Negative feedback reduces the gain of an amplifier

Reason (R): Negative feedback is very commonly used in amplifier circuits

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒

Assertion (A): In a full wave rectifier output the lowest ac component is at twice the input frequency

Reason (R): In a full wave rectifier, the output waveform consists of half sinusoids

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A receiver having an RF amplifier and an IF of 450 kHz, has Q of the coils 65 and an incoming frequency of 1200 kHz. The image rejection of the receiver is
5870
3655
236
13.3

⇒

Assertion (A): In liquid system the ratio of change in liquid level to change in flow rate is called resistance of liquid flow.

Reason (R): In liquid level systems the ratio of change in liquid stored in a tank to the change in head is called capacitance of tank.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ In communication systems, the modulating signal is also called
base band signal
side bands
auxiliary signal
none of the above

⇒

Match the following:

	List I (Double Rectifier)		List II (Number of Diodes)
A.	Full wave Bridge rectifier	1.	1
B.	Half wave rectifier	2.	2
C.	Full wave rectifier using centre tapped transformer	3.	4

A-1, B-2, C-3
A-3, B-1, C-2
A-2, B-1, C-3
A-3, B-1, C-2

⇒ The stator of phase shifting transformer for use in conjunction with an ac potentiometer has a
single phase winding
two phase winding
3 phase winding
either (a) or (c)

⇒ 25 persons are in a room. 15 of them play hockey, 17 of them play football and 10 of them play both hockey and football. Then the number of persons playing neither hockey nor football is:
2
17
13
3

⇒ Dielectric strength of polythene is around
10 kV/mm
40 kV/mm
100 kV/mm
140 kV/mm

⇒ Program counter in a digital computer
counts the number of program run in the machine
counts the number of times a subroutine is called
counts the number of times the loops are executed
points the memory address of the current or the next instruction to be executed

⇒ In an underdamped RLC series circuit, the natural frequency is ω_n. The frequency of damped oscillations is
ω_n
less than ω_n
more than ω_n
2 ω_n

⇒

Assertion (A): Absolute instruments are used in standard laboratories.

Reason (R): Absolute instruments do not require calibration.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒

Assertion (A): To add 8 bit words, two 1C 74181 can be cascaded.

Reason (R): In 1C 74181 a sum greater than 15 leads to high carry out.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Schering bridge is used to measure
capacitance and dielectric loss
inductance
resistance
mutual inductance

⇒ If each stage has a gain of 10 dB and noise figure of 10 dB, then the overall noise figure of a two stage cascade amplifier will be
10
1.09
1
10.9

⇒ If a microstrip is enclosed in a metal enclosure
the radiation losses are increased
the radiation losses are reduced RL
the capacitance becomes zero
the inductance becomes zero

⇒ Fourier analysis indicate that a square wave can be represented as
a fundamental sine wave and odd harmonics
a fundamental sine wave and even harmonics
a fundamental sine wave and harmonics
fundamental and subharmonic sine waves

⇒ For a given magnetic material operating in linear mode B = 0.06 T. Assume permeability = 51, then magnetization is:
44836 A/m
46834 A/m
946 A/m
936 A/m

⇒ In colour TV system the colour sub carrier frequency is 4.43 MHz.
TRUE
FALSE

⇒ Consider the following about 'arrays' in C

An array is a collection of similar elements.
An array can not have 10 numbers 5 of which are ints and 5 are floats.
An array can have ints and chars in the same array.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ Consider the following features of an instrument

suitable for both ac and dc
free from hysteresis and eddy current errors
No waveform and frequency errors
it is essentially a voltmeter

This instrument is
moving iron
moving coil
electrostatic
dynamometer

⇒ To realize the full power of 8086 the pin of 8086 connected to ground is
DEN
ALE
INTR
MN / MX

⇒ The integral of k δ(t) is
a step function of magnitude k
a step function 'of magnitude 1/k
a ramp of slope k
a ramp of slope 1/k

⇒ The frequency tolerance for the RF carrier in the standard AM radio broadcast band is
zero
+20 Hz
+1000 Hz
+25 Hz

⇒ A single phase electric heater uses phase controlled thyristors. The firing angle is 90°. The degree of heating is
25% of maximum
50% of maximum
75% of maximum
none of the above

⇒ If the p and T circuits in figure are equivalent, then R₁, R₂, R₃ respectively
9 Ω, 6 Ω, 6 Ω
6 Ω, 6 Ω, 9 Ω
9 Ω, 6 Ω, 9 Ω
6 Ω, 9 Ω, 6 Ω

⇒ When a p-n-p transistor is operating in active region, the current in the n region is due to
only holes
only electrons
mainly holes
mainly electrons

⇒ In a single phase full wave ac regulator feeding R-L load, the gate pulses
are always of short duration
may be of short duration
should be rectangular with width (p - a)
cannot be rectangular with width (p - a)

⇒ In a thyristor the gate current is increased, then
anode current will increase
anode current will decrease
anode current will remain constant
anode current may increase or decrease

⇒ Class A and class B chopper
operate in first quadrant
operate in second quadrant
class A chopper operates in first quadrant while class B operates in second quadrant
may operate in either first or second quadrant