Question is ⇒ A half adder adds __________ bits and a full adder adds __________ bits., Options are ⇒ (A) two, three, (B) three, four, (C) four, six, (D) two, four, (E) , Leave your comments or Download question paper.

Question is ⇒ A half adder adds __________ bits and a full adder adds __________ bits., Options are ⇒ (A) two, three, (B) three, four, (C) four, six, (D) two, four, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A half adder adds __________ bits and a full adder adds __________ bits.
A.	two, three [Correct Answer]
B.	three, four [Wrong Answer]
C.	four, six [Wrong Answer]
D.	two, four [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following is a valid real constant?
1281
1281
KM
11821

⇒ In communication satellites, the up-link normally operates at a higher frequency than the down-link because it
gives a narrow beam shining into space
results in lesser signal attenuation
gives better beam-shaping
is easier to polarize a high frequency beam

⇒ In a DM system, the granular noise occurs when modulating signal
decrease Rapidly
increase
has high frequency component
change within step size

⇒ Why does a FM radio station perform better than and AM station radiating the same actual power?
FM is immune to noise
AM has only two sidebands while FM has more
FM uses larger bandwidth for large modulation depth.
Capture effects appears in FM.

⇒ The PC contains 0450 H and SP contains 08D 6 H. What will be content of P and SP following a CALL to subroutine at location 02 AFH?
0453 H, 08 D 8 H
0453 H, 08 D 4 H
02 AFH, 08 D 8 H
02 AFH, 08 D 4 H

⇒ A chopper cannot be line commutated.
TRUE
FALSE

⇒ In FORTRAN 77 the total number of characters in a variable can be a maximum of
6
1
8
9

⇒ A single phase half wave regulator uses
2 diodes and 2 thyristors
2 thyristors
1 diode and 1 thyristor
2 diodes

⇒ Secondary emission is always decremental.
TRUE
FALSE

⇒ The data about p the pull required to lift a weight wby a pulley bloc
3.2 + 0.171 w
2.28 + 0.1879 w
1.2 + 0.25 w
0.6 + 0.3 w

⇒ The difference between measured value and true value is called
gross error
relative error
probable error
absolute error

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and (CY) contain after XRA A?
A 6 H, 1
A 6 H, 0
00 H, 0
00 H, 1

⇒ Which of the following is true as regards photo emission?
Velocity of emitted electrons is dependent on light intensity
Rate of photo emission is inversely proportional to light intensity
Maximum velocity of electron increases with decreasing wave length
Both holes and electrons are produced

⇒ In a half bridge inverter each thyristor is gated at a frequency f. The output frequency is
2 f
f
0.5 f
0.25 f

⇒ In full wave rectification, if the input frequency is 50 Hz, then frequency at the output of filter is
50 Hz
0 Hz
100 Hz
75 Hz

⇒

Assertion (A): If Z₁(s) and Z₂(s) are positive real then Z₁(s) + Z₂(s) as well as 1/Z₁(s) and 1/Z₂(s) are positive real.

Reason (R): The poles of a positive real function are real or occur in conjugate pairs.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Refer to the NAND and NOR latches shown in the figure. The inputs (P₁, P₂) for both the latches are first made (0, 1) and then, after a few seconds, made (1, 1). The corresponding stable outputs (Q₁, Q₂)
NAND: first (0, 1) then (0, 1) NOR: first (1, 0) then (0, 0)
NAND: first (1, 0) then (1, 0) NOR: first (1, 0) then (1, 0)
NAND: first (1, 0) then (1, 0) NOR: first (1, 0) then (0, 0)
NAND: first (1, 0) then (1, 1) NOR: first (0, 1) then (0, 1)

⇒ The value of current read by ideal ammeter A in figure is __________ amp
0
3
2.5
5

⇒ The upper end of the d.c. load line is called the __________ point and the lower end is the __________ point.
cut off, saturation
saturation, active
saturation, cut off
active saturation

⇒ For an amplifier the input output signals are shown in figure. The class of amplifie
A
AB
B
C

⇒ An m derived low pass filter has f_c = 1000 Hz, f_∞ = 1250 Hz and m = 0.6. If m is increased, then
both f_c and f_∞ will increase
both f_c and f_∞ will decrease
f_c will remain constant but f_∞ will decrease
f_c will remain constant but f_∞ will increase

⇒ Which of the following statement is incorrect?
Z₀ is an ac characteristic that is the same for any length of time
The characteristic impedance can be measured approximately with a sensitive ohm meter
A line terminated in its Z₀ is a flat or non-resonant line
A twin lead has higher Z₀ but lower losses than coaxial cable

⇒ A parity check usually can detect
one-bit error
double-bit error
three-bit error
any-bit error

⇒ The impurity commonly used for realizing the base region of a n-p-n transistor is
gallium
indium
boron
phosphorus

⇒ The resistance of voltmeter affects the accuracy of measurement in loss of charge method.
TRUE
FALSE

⇒ When avalanche breakdown occurs covalent bonds are not affected.
TRUE
FALSE

⇒ In a half wave diode rectifier circuit the current flows in the load circuit for
90° in each cycle
180° in each cycle
270° in each cycle
360° in each cycle

⇒

Assertion (A): In Darlington pair, the overall β is product of individual β_s

Reason (R): The voltage gain of a base driven amplifier is equal to ac collector voltage divided by ac base voltage

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A single layer air cored coil has n turns and inductance L. If a new coil is formed by having 2n turns while keeping the coil length and diameter the same, the new inductance is
0.5 L
L
2 L
4 L

⇒

Assertion (A): An instruction cycle consists of fetch and execute cycles.

Reason (R): Fetch cycle has one machine cycle but execute cycle may have one or more machine cycles depending on length of instruction.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct