Question is ⇒ A half adder adds, Options are ⇒ (A) 2 bits, (B) 3 bits, (C) 4 bits, (D) 2 or 3 bits, (E) , Leave your comments or Download question paper.

Question is ⇒ A half adder adds, Options are ⇒ (A) 2 bits, (B) 3 bits, (C) 4 bits, (D) 2 or 3 bits, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A half adder adds
A.	2 bits [Correct Answer]
B.	3 bits [Wrong Answer]
C.	4 bits [Wrong Answer]
D.	2 or 3 bits [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following pairs of semiconductors and current carriers is correctly matched?
Intrinsic : number of electrons = number of holes
P type : number of electrons > number of holes
N type : number of electrons < number of holes
Bulk : neither electrons nor holes

⇒ Beamwidth (between first nulls) will be for an antenna at 3 MHz with directivity of 100
140°
70°
210°
60°

⇒ The register set and instruction set of 8088 is similar to that of
8085
8086
partly 8085 and partly 8086
none of the above

⇒ A capacitor can be represented by a capacitance C in parallel with a resistance R. For a good capacitor, the resistance R should be
very high
high
very low
low

⇒ A FET
has two P-N junctions
has three P-N junctions
depends on the variation of the depletion layer width with reverse voltage, for its operation
depends on the variation of a magnetic field for its operation

⇒ In FORTRAN 77 FLOAT (-28) gives the value
28
-28
-28
none of the above

⇒ Laplace transform of unit doublet is
1/s
s²
s
none

⇒ In a NAND SR latch S = R = 1. Then
Q = 1, Q = 0
Q = 0, Q = 1
both Q and Q will be same as before
the latch will be set

⇒ For a sinusoidal input, the circuit shown in the figure will act
Pulse generator
Full wave rectifier
Ramp generator
Voltage Doubler

⇒ Sampling frequency
100 Hz
200 Hz
400 Hz
none of these

⇒ In an op-amp comparator, the positive or negative output is
saturated
amplifier
unsaturated
any of the above

⇒ A Colpitt's oscillator uses
a tapped inductor
an inductor and two capacitors
both (a) and (b)
either (a) or (b)

⇒ In figure, the short circuit current through terminal AB wil
1.5 A
0.125
0.0833333333333333
0.0416666666666667

⇒ The static characteristic of an adequately forward biased P-n junction is a straight line, if the plot is of __________ V_s → versus
log I V_s log V
log I V_s V
I V_s log V
I V_s V

⇒ The atomic number of silicon is 14. It can be therefore concluded that
a silicon atom contains 14 protons
a silicon atom contains 14 neutrons
a silicon atom contains 14 electrons
all of the above

⇒ In a modified series inverter
the maximum output frequency is less than frequency of damped oscillations
the output frequency can be even higher than the frequency of damped oscillations
the output frequency cannot exceed the frequency of damped oscillations
any of the above

⇒ The frequency at which phase angle is 180° is called
phase crossover frequency
stability limit frequency
frequency of limited stability
gain margin frequency

⇒ In the circuit shown, the steady state is reached with S open S is closed at t = 0, the current I in the 1 Ω resistor connected is to be determined at t = 0⁺ is give
1
2
3
42828

⇒ The following Variable Entered Map (VEM) represents which of the following funct
f(A, B, C, D) = ∑(1, 2, 3, 4, 7, 8, 9, 14, 15) + Φ(3, 5, 12, 13)
f(A, B, C, D) = ∑(1, 2, 4, 8, 10, 8, 13, 15) + Φ(3, 6, 12, 14)
f(A, B, C, D) = ∑(1, 2, 4, 7, 8, 10, 13, 15) + Φ(6, 12, 13)
f(A, B, C, D) = ∑(1, 2, 4, 7, 8, 9, 12, 13) + Φ(3, 5, 14, 15)

⇒ The ALU carrier out arithmetic and logic operations (OR AND, NOT, etc.) it processes
decimal numbers
binary numbers
hexadecimal numbers
octal numbers

⇒ Consider the cascade structure of two filte
1 and 3
only 2
2 and 3
only 3

⇒ Which of the following statement is correct?
FET and junction transistor both are unipolar
FET and junction transistor both are bipolar
The FET is bipolar, while junction transistor are unipolar
The FET is unipolar, while junction transistor are bipolar

⇒ Monostable multivibrator is called one-shot or single-shot circuit because it
can be used once
can be used single and not with other circuits.
always returns by itself to its single stable state
changes to quasistable for a fixed period of time upon receipt of triggering signal.

⇒ Time delay of a TTL standard family is about
180 ns
50 ns
18 ns
3 ns

⇒ In the given figure shows a logic circuit. The minimum Boolean expression for this circui
A + B
A + B + C
AB + C
AB + AC + BC

⇒

Assertion (A): 2's complement arithmetic is preferred in digital computers

Reason (R): The hardware required to obtain 2's complement is simple.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The op amp is used in
A/D converters
D/A converters
both (a) and (b)
shift registers

⇒ MEWS stands for
Missile Early Warning System
Moving Target Early warning System
Missile Early Warning Signal
Moving Target Early Warning Signal

⇒ The inputs to a 4 channel MUX have the following bandwidths. Channel 1-50 Hz, channel 2-200 Hz. Channel 3-75 Hz. Channel 4-90 Hz. The theoretical minimum sampling rate of the MUX is
200 Hz
400 Hz
415 Hz
1600 Hz

⇒ The number of unused states in a 4 bit Johnson counter is
2
4
8
12