Question is ⇒ A good ohmic contact on a P-type semiconductor chip is formed by introducing, Options are ⇒ (A) gold as an impurity below the contact, (B) high concentration of donors below the contact, (C) high concentration of acceptors below the contact, (D) thin insulator layer between the metal and semiconductor, (E) , Leave your comments or Download question paper.

Question is ⇒ A good ohmic contact on a P-type semiconductor chip is formed by introducing, Options are ⇒ (A) gold as an impurity below the contact, (B) high concentration of donors below the contact, (C) high concentration of acceptors below the contact, (D) thin insulator layer between the metal and semiconductor, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A good ohmic contact on a P-type semiconductor chip is formed by introducing
A.	gold as an impurity below the contact [Wrong Answer]
B.	high concentration of donors below the contact [Correct Answer]
C.	high concentration of acceptors below the contact [Wrong Answer]
D.	thin insulator layer between the metal and semiconductor [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ TV signal strength when expressed in dB m has the reference of
10 μV/m
5 μV/m
2 μV/m
1 μV/m

⇒ In the spectrum of a frequency modulated wave
carrier frequency cannot disappear
carrier frequency vanishes when modulation index is large
the number of significant sidebands depends upon modulation index
none of the above

⇒ When electronic emission occurs due to bombardment of high velocity electrons on a metal surface, it is called secondary emission.
TRUE
FALSE

⇒ When a wave is incident from the more dense into a less dense medium at an angle equal to or exceeding the critical angle, the wave suffers total internal __________ .
reflection
refraction
transmission
none of the above

⇒ Read the following statements:

A μP generally interfaced to several memory chips and I/O devices
Address space provided by μP is partitioned into sub sets of addresses
Address map and address partition refer to different terms in address space

Which of the above are correct?
All
1 and 2 only
2 and 3 only
1, 3 only

⇒ At room temperature a semiconductor material is
perfect insulator
conductor
slightly conducting
any of the above

⇒ In a lead acid cell the density of the acid gives an indication of
the level of the acid
the eventual damages caused to the plates
the charge of the battery
the e.m.f. of the battery

⇒ By the use of which of the following the PPM can be converted to PWM?
A stable multivibrator
Integrator
Monostable multivibrator
Bistable Multivibrator

⇒ In microwave circuits, a mode transducer is used to
change mode of wave transmission
change direction of wave transmission
change polarization of wave transmission
change mode, direction or polarization wave transmission

⇒ If e = 10 sin(10⁸ t + 3 sin 10⁴ t) then the modulation index is
1
2
3
4

⇒ The main drawbacks of EEPROM are
low density
high cost
both low density and high cost
none of the above

⇒ Zip floppy has a capacity of
50 MB
500 MB
25 MB
100 MB or 250 MB

⇒ The number of PM radio channels which can be accommodated in a spectrum of 300 MHz is about
10
100
500
1500

⇒

Assertion (A): Gate triggering is the most commonly used method for triggering of an SCR.

Reason (R): Even a small gate current is sufficient to turn on an SCR.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Audio and video signals are called modulating waves.
TRUE
FALSE

⇒ The number of LED display indicators in logic probe are
1
2
1 or 2
4

⇒ In a single phase semi-converter the number of thyristors is
16
8
4
2

⇒ Let JCOKE = 3 and LPEPSI = 5. Consider the statement 8
1
15
10

⇒ In the amplifier circuit of figure h_fe = 100 and h_ie = 1000 Ω. The voltage gain of amplifier is a
0.33
0.5
0.66
1

⇒ To measure dielectric loss you would use
Anderson bridge
Kelvin bridge
Schering bridge
Maxwell's bridge

⇒ The forbidden energy gap for germanium is
0.12 eV
0.32 eV
0.72 eV
0.92 eV

⇒ In a broadcast superheterodyne receiver
the local oscillator operates below the signal frequency
local oscillator frequency is normally double the IF
RF amplifier normally works at kHz above the carrier frequency
mixer input must be tuned to the signal frequency

⇒ The operating modes of 8255 A are called
mode 0 and mode 1
mode 0, mode 1 and mode 2
mode 0 and mode 2
mode 0, mode 2 and mode 3

⇒

Assertion (A): Absolute instruments are used in standard laboratories.

Reason (R): Absolute instruments do not require calibration.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ If the carrier modulated by a digital bit stream has one of the possible phases of 0°, 90°, 180° and 270°. Then the modulation is called
BPSK
QPSK
QAM
MSK

⇒ (100101)₂ is
(37)₁₀
(69)₁₀
(41)₁₀
(5)₁₀

⇒ The state equations are in the form
X = AX + BW
X = AX + Bu
X = AX + Bx
either (a) or (b)

⇒ Poles and zeros of a driving point function of a network are simple and alternate on jω axis. The network consists of
R and C
L and C
R and L
R, L and C

⇒ In a series L-C circuit fed by ac voltage, voltage drops across L and C are 40 V and 30 V respectively. The supply voltage is
70 V
10 V
50 V
1.333 V

⇒ As applied to a flip flop the word edge triggered's means
flip flop can change state when clock transition occurs
flip flop can change state when clock signal goes from LOW to HIGH only
flip flop can change state when clock signal goes from HIGH to LOW only
none of the above