Question is ⇒ A function f(t) = k is, Options are ⇒ (A) stable, (B) marginal stable, (C) unstable, (D) none, (E) , Leave your comments or Download question paper.

Question is ⇒ A function f(t) = k is, Options are ⇒ (A) stable, (B) marginal stable, (C) unstable, (D) none, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A function f(t) = k is
A.	stable [Wrong Answer]
B.	marginal stable [Correct Answer]
C.	unstable [Wrong Answer]
D.	none [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Match the following:

	List I (μP)		List II (Number of bits in register)
A.	8085	1.	32 bit
B.	8086	2.	16 bit
C.	68000	3.	8/16 bit

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-2, C-1
A-3, B-1, C-2

⇒ In 8085 the instruction MOV A, M is an example of
Direct addressing
Immediate addressing
Register addressing
Register indirect addressing

⇒ Find equivalent resistance. Each resistance is l &Om
5/12 Ω
5/6 Ω
6/5 Ω
6/10 Ω

⇒ The impurity commonly used for realizing the base region of a n-p-n transistor is
gallium
indium
boron
phosphorus

⇒ Which of the following real expressions is incorrect in Pascal?
Y - X
(A + B) (C + D)
X / Y - Z
P * Z - 5.0

⇒ In n-well CMOS fabrication substrate is:
heavily doped n-type
heavily doped p-type
lightly doped n-type
lightly doped p-type

⇒ Which one is a linear system?
y[n] = x[n] x x[n - 1]
y[n] = x[n] + x[n - 10]
y[n] = x²[n]
(a) and (c)

⇒ If σ is standard deviation, variation is
σ - 1
σ^1.5
σ²
σ³

⇒

Assertion (A): The impedance of a matched load is equal to characteristic impedance of line.

Reason (R): A matched termination absorbs all the power incident on it.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Hexadecimal number E is equal to binary number
1110
1101
1001
1111

⇒ In a half wave voltage doubler circuit the input frequency is 50 Hz. The ripple frequency is
25 Hz
50 Hz
100 Hz
150 Hz

⇒ Figure shows the variation of Z(ω) for a positive real function. The functio
RC impedance
RL impedance
RLC impedance
Reactance function

⇒ The sensor generally used in incremental optical encoder is
LED
LCD
photodiode
either (a) or (b)

⇒ In H-plane metal plate lens the travelling wave front is
totally retarded
retarded
accelerated
neither accelerated nor retarded

⇒ Multiplex techniques are used for
low density communications
low density point-to-point communications
high-density point-to-point communications
all of the above

⇒ The circuit of figure is ca
current mirror
voltage mirror
impedance inversion
phase splitting

⇒ In the circuit shown in figure, maximum power will be transferred
Z_L = 13 - j 9
Z_L = 13 + j 9
Z_L = 9 - j 13
Z_L = 9 + j 13

⇒ If output power of a radio receiver is doubled, its volume is increased by __________ dB.
2
3
1
-3

⇒ For insulators the energy gap is of the order of
0.1 eV
0.7 eV
1.1 eV to 1.2 eV
5 to 15 eV

⇒ If f₁(t)<< F₁(jω) and f₂(t)↔ F₂(jω), then [a₁ f₁(t) + a₂f₂(t)]↔
a₁F₁(jω) + a₂F₂(jω)
a₁a₂F₁(jω) + F₂(jω)
a₁F₁(jω) - a₂F₂(jω)
a₁F₁*(jω) + a₂F₂*(jω)

⇒ Which device changes parallel data to serial data?
Decoder
Multiplexer
Demultiplexer
Flip flop

⇒ Companding is used in PCM to
reduce bandwidth
increasing S/N ratio
get almost uniform S/N ratio
increase bandwidth

⇒ In n channel JFET
I_D and V_DS are positive but V_GS is negative
I_D and V_GS are positive but V_DS is negative
V_DS and V_GS are positive but I_D is negative
I_D, V_DS and V_GS are all positive

⇒

Match the following:

	List I		List II
A.	p type semiconductor	1.	silicon
B.	n type semiconductor	2.	holes are majority carriers
C.	Intrinsic semiconductor	3.	electrons are majority carriers
D.	Tungsten	4.	is a metal

A-2, B-3, C-1, D-4
A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-1, C-2, D-4

⇒ In radio receiver, the maximum contribution to noise is from
mixer stage
power supply
power amplifier
equally from above three

⇒ A communication receiver is
TRF receiver
a superheterodyne receiver
either (a) or (b)
neither (a) nor (b)

⇒

Assertion (A): When excited by a unit step voltage, an inductor behaves as open circuit at t = 0.

Reason (R): Inductance has the property of inertia.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Two ammeters A and B are connected in parallel in a circuit carrying 100 A. Their resistances are 0.8 mΩ. Their readings will be.
55.56 and 44.44 A respectively
44.44 A and 55.56 A respectively
60 A and 40 A respectively
40 A and 60 A respectively

⇒

Assertion (A): CE amplifier is the most widely used BJT amplifier

Reason (R): CE amplifier has zero phase difference between input and output

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In solids the current flow is due to electrons only.
TRUE
FALSE