Question is ⇒ A full wave rectifier circuit using centre tapped transformer and a bridge rectifier are fed at 100 V, 50 Hz. The frequencies of outputs in these two rectifiers are, Options are ⇒ (A) 100 Hz each, (B) 50 Hz each, (C) 100 Hz and 50 Hz, (D) 50 Hz and 100 Hz, (E) , Leave your comments or Download question paper.

Question is ⇒ A full wave rectifier circuit using centre tapped transformer and a bridge rectifier are fed at 100 V, 50 Hz. The frequencies of outputs in these two rectifiers are, Options are ⇒ (A) 100 Hz each, (B) 50 Hz each, (C) 100 Hz and 50 Hz, (D) 50 Hz and 100 Hz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A full wave rectifier circuit using centre tapped transformer and a bridge rectifier are fed at 100 V, 50 Hz. The frequencies of outputs in these two rectifiers are
A.	100 Hz each [Correct Answer]
B.	50 Hz each [Wrong Answer]
C.	100 Hz and 50 Hz [Wrong Answer]
D.	50 Hz and 100 Hz [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following statements is correct?
R-C is a dual pair
LC is a dual pair
Norton is a series circuit
Thevenin equivalent a parallel circuit

⇒ The reverse saturation current in a semiconductor diode consists of
avalanche current
zener current
minority carrier current
minority carrier current and surface leakage current

⇒ The series element for a prototype high pass filter is
resistive
inductive
capacitive
combination of L and C

⇒

Assertion (A): The advantages of totem pole output are fast switching and low power consumption.

Reason (R): IC packages available are DIP, surface mount and J lead surface mount.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A capacitor used for power factor correction in single- phase circuit decreases
the power factor
the line current
both the line current and the power factor
the line current and increases power factor

⇒ The data about p the pull required to lift a weight wby a pulley bloc
3.2 + 0.171 w
2.28 + 0.1879 w
1.2 + 0.25 w
0.6 + 0.3 w

⇒

Assertion (A): When excited by a unit step voltage, an inductor behaves as open circuit at t = 0.

Reason (R): Inductance has the property of inertia.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which one of the following is also called 'rat race'?
E plane tee
H plane tee
Magic tee
Hybrid ring

⇒ A reactance function is always a quotient of
even to odd polynomials
odd to even polynomials
even to odd or odd to even polynomials
even to even polynomials

⇒ Frequency shifting keying is basically a method involving
amplitude modulation
frequency modulation
phase modulation
none of the above

⇒ The satellites used for intercontinental communication are called
Comsat
Domsat
Marisat
Intelsat

⇒ An angle modulated signal is given by s(t) = cos 2p (2 x 10⁶t + 30 sin 150t + 40 cos 150t). The maximum frequency and phase deviations of s(t) are
10.5 kHz, 140p rad
6 kHz and 80p rad
10.5 kHz, 100p rad
7.5 kHz, 100p rad

⇒

Assertion (A): In a Schottky diode the reverse recovery time is almost zero.

Reason (R): A Schottky diode has aluminium silicon junction.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ When thyristors are connected in series and parallel, it may be necessary to have :
current derating
voltage derating
both current and voltage derating
none of the above

⇒ A rhombic antenna is a
resonant antenna
non-resonant antenna
coupled antenna
none of the above

⇒ In the given figure shows a root locus plot. Consider the following statements for this plot

The open loop system is a second order system
The system is overdamped for K > 1
The system is stable for all values of K

Which of the above statements are corr
1, 2, 3
1, 3
2, 3
1, 2

⇒

Assertion (A): CO₂ has no resultant dipole moment but CO has a dipole moment.

Reason (R): The structure of CO₂ is O = C = O.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Figure shows a NAND latch used as a switch debouncer. With the switch in STOP position. Q will be equal to
0
1
CLK
none of these

⇒ Single parity check is not reliable in case of
paper tape
magnetic tape
magnetic drum
cores

⇒ The amplifier used in miller voltage sweep should have a gain of
-∞
1
+∞
-1

⇒ The Voltage e₀ in the figu
2 V
4 V
4/3 V
8 V

⇒ A retriggerable one shot is one which
can be triggered only once
has two quasi stable states
can not be retriggered till the complete pulse appears at output
can be retriggered while the output is being generated

⇒ For a series circuit of variable R and X_L, the impedance locus is
a straight line parallel to X axis in first quadrant
a straight line parallel to X axis in fourth quadrant
a straight line parallel to Y axis in second quadrant
a straight line parallel to Y axis in first quadrant

⇒ For the port shown, the short circuit network function at port 2 is give
s + 1/4
s + 4
4s + 1
s + 16

⇒ Full adder circuit can be implemented by
Multiplexers
Half adders
AND or OR gates
Decoders

⇒ Consider an incremental vector element of length ΔL and angle between an electric field E and ΔL s cos &the
In the direction of E
In opposite direction of E
In the angle of 45° with E
In the angle of 60° with E

⇒ In a semiconductor avalanche breakdown occurs when
reverse bias exceeds the limiting value
forward bias exceeds the limiting value
forward current exceeds the limiting value
potential barrier is reduced to zero

⇒ Consider the following statements about polar plots

Addition of a non-zero pole to a transfer function results in further rotation of polar plot through an angle of - 90° as ω → ∞
Addition of a pole at the origin to a transfer function rotates the polar plot at zero and infinite frequencies by a further angle of - 90°

Of the above statements:
Both are correct
Both are wrong
1 is correct and 2 is wrong
2 is correct and 1 is wrong

⇒ The time base of a high frequency CRO whose screen diameter is 10 cm is set at 10 μ sec/cm. The lowest frequency which can be fully displayed on the screen is
more than 100 kHz
equal to 100 kHz
equal to 10 kHz
less than 10 kHz

⇒ The number of interrupt lines in 8085 is
2
3
4
5