Question is ⇒ A frequency multiplier stage should operate as, Options are ⇒ (A) class A, (B) class B, (C) class AB, (D) class C, (E) , Leave your comments or Download question paper.

Question is ⇒ A frequency multiplier stage should operate as, Options are ⇒ (A) class A, (B) class B, (C) class AB, (D) class C, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A frequency multiplier stage should operate as
A.	class A [Wrong Answer]
B.	class B [Correct Answer]
C.	class AB [Wrong Answer]
D.	class C [Wrong Answer]
View Answer 2 -5 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a given magnetic material operating in linear mode B = 0.06 T. Assume permeability = 51, then magnetization is:
44836 A/m
46834 A/m
946 A/m
936 A/m

⇒

Match the following:

	List I		List II
A.	200 MHz	1.	SHF
B.	20 GHz	2.	UHF
C.	500 kHz	3.	VHF
D.	500 MHz	4.	MF

A-3, B-1, C-4, D-2
A-3, B-2, C-4, D-1
A-3, B-4, C-1, D-2
A-3, B-4, C-2, D-1

⇒ In communication systems, the modulating signal is also called
base band signal
side bands
auxiliary signal
none of the above

⇒ The open wired circuit in the given figure works
EX - NOR gate
AND gate
XOR gate
NOR gate

⇒ In Schottky TTL, a Schottky diode is used for
forming the gate
connecting the resistor
clamping of the basic collector junction
none of the above

⇒ The bandwidth of FM for Commercial Purpose is
88 - 108 MHz
85 - 110 MHz
90 - 110 MHz
infinite Range

⇒ In register index addressing mode the effective address is given by
index register value
sum of the index register value and the operand
operand
difference of the index register value and the operand

⇒ How many interrupts are there in 8085 microprocessor?
4
5
6
8

⇒ The minimum permissible size of aluminium cable for lighting circuit is
1.2 sq. mm
1.5 sq. mm
2.2 sq. mm
3.5 sq. mm

⇒ In root locus analysis the breakaway and break in points
lie on the real axis
either lie on the real axis or occur in complex conjugate pairs
always occur in complex conjugate pairs
none of the above

⇒ An instrument of accuracy class 1 can have an error equal to
+ 1% of reading
± 1% of reading
± 1% of full scale deflection
+ 1% of full scale deflection

⇒ Which coupling produces the minimum interference with frequency response?
RC coupling
Transformer coupling
Direct coupling
Impedance coupling

⇒ The output voltage of a charger is
less than battery voltage
same as battery voltage
more than battery voltage
same or more than battery voltage

⇒ The waveguides compared to equivalent transmission lines at low frequency are
able to carry more power
less noisy
having lower attenuation
all of the above

⇒ An I/O processor controls the flow of information between
cache memory and I/O devices
main memory and I/O devices
two I/O devices
cache and main memory

⇒ A binary ladder network D/A converter requires
resistors of one value only
resistors of many different values
resistors of two different values
none of the above

⇒ The number of pins in microprocessor 8086 is
30
40
50
60

⇒

Assertion (A): In class A amplifier the distortion is minimum

Reason (R): In class A amplifier collector current exists for 360° of input cycle

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Minimum no. of 2 I/P NAND gate required to implement the Boolean function Z = ABC, assuming that A, B and C are available is
2
3
5
6

⇒ If a sequence is causal then ROC is (where a is any number)
|z| > a
|z| < a
|z| = a
Entire Plane

⇒ The current through R₁ is(If β = 99, V_BE = 0.7
0.1 mA
0.35 mA
0.2 mA
none

⇒ The specified maximum junction temperature of thyristors is about
50°C
80°C
120°C
200°C

⇒

Assertion (A): Temperature control of the passenger compartment of car uses both feed forward and feedback controls.

Reason (R): Feed forward control gives corrective action before the disturbance affects the output and feedback control applies corrective action after output changes.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Magnetic hysteresis phenomenon is explained by
motion of domain walls
motion of domain walls and domain rotation
domain rotation
none of the above

⇒ Which configuration has high input impedance and low output impedance?
CB
CE
CC
CB and CE

⇒ A sphere with charge Q was placed in, but not touching a larger hollow sphere. If there is any charge initially on the outer sphere; to remove it the outer sphere was earthed momentarily, and then the inner sphere was removed. The charge remaining on the outer sphere was then measured. This charge was found to be __________ to the charge on the inner sphere.
equal and of same again
equal and of opposite sign
unequal and of same sign
unequal and of opposite sign

⇒ A transistor amplifier has pole
s₁
s₁ + s₂ + s₃ + s₄
s₁ + s₄
s₄

⇒ What was the first commercial geostationary communication satellite?
INTELSAT 1
ECHO
INSAT-1A
SPUTNIK

⇒ In a series circuit with X_L constant and R variable the current locus lies in the third quadrant.
TRUE
FALSE

⇒ The emitter coupled pair of BJT's gives a linear transfer relation between the differential output voltage and the differential input voltage V_id only when the magnitude of V_id is less a times the thermal voltage, where a is
4
3
2
1