Question is ⇒ A five bit binary adder is used to add 01001 and 00111. The adders from LSB position are numbered as FA0, FA1, FA2 and FA3. The outputs of FA2 are, Options are ⇒ (A) SUM = 0, (B) SUM = 0, CARRY = 1, (C) SUM = 1, CARRY = 0, (D) SUM = 1, CARRY = 1, (E) , Leave your comments or Download question paper.

Question is ⇒ A five bit binary adder is used to add 01001 and 00111. The adders from LSB position are numbered as FA0, FA1, FA2 and FA3. The outputs of FA2 are, Options are ⇒ (A) SUM = 0, (B) SUM = 0, CARRY = 1, (C) SUM = 1, CARRY = 0, (D) SUM = 1, CARRY = 1, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A five bit binary adder is used to add 01001 and 00111. The adders from LSB position are numbered as FA₀, FA₁, FA₂ and FA₃. The outputs of FA₂ are
A.	SUM = 0 [Correct Answer]
B.	SUM = 0, CARRY = 1 [Wrong Answer]
C.	SUM = 1, CARRY = 0 [Wrong Answer]
D.	SUM = 1, CARRY = 1 [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An RL impedance function can also be realized as
RC impedance function
RC admittance function
LC impedance function
LC admittance function

⇒ Cassegrain feed is used with a parabolic reflection to
reduce the size of the main reflector
increase the gain of the system
increase the beamwidth of the system
allow the feed to be placed at a convenient point

⇒ A cycloconverter is a group of controlled rectifiers.
TRUE
FALSE

⇒ As compared to a full wave diode rectifier circuit using centre tapped transformer, the bridge diode rectifier circuit has the main advantage of
higher current carrying capacity
higher efficiency
lower ripple factor
lower PIV

⇒

Assertion (A): Each memory chip has its own address latch.

Reason (R): ALE signal comes out of microprocessor 8085 and goes to memory chip.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In the following transistor circuit V_BE = 0. 7 V, r_c = 25mV/I_E, and β and the capacitance are very l
1 mA
2 mA
5 mA
10 mA

⇒ In order to rectify sinusoidal signals of millivolt range (< 0.6 V)
bridge rectifier using diodes can be employed
full wave diode rectifier can be used
a diode is to be inserted in the feedback loop of an op-amp
a diode is to be inserted in the I/P of an op-amp

⇒ Which of the following arithmetic operations requires only one operand in FORTRAN 77?
Addition
Multiplication
Negative
Substraction

⇒ In 8085 the instruction MOV A, M is an example of
Direct addressing
Immediate addressing
Register addressing
Register indirect addressing

⇒ Which of these are 16 bit microprocessors?
80286
MC68000
Z8000
All

⇒ The admittance parameter Y₁₂ in the 2 port network in the fi
-0.2 mho
0.1 mho
-0.05 mho
0.05 mho

⇒ In standing wave pattern on a transmission line
voltage and current nodes coincide
voltage and current antinodes coincide
voltage nodes and current antinodes as well as current nodes and voltage antinodes coincide
both (a) and (b)

⇒ Symbol shown in figure represen
P-channel DEMOSFET
N-channel DEMOSFET
UJT with N-type base
UJT with P-type base

⇒ The hexadecimal number (3E8)₁₆ is equal to decimal number
1000
982
768
323

⇒ The dual of the function A(BC + BC + BC) is
A + (B + C) (B + C) (B + C)
A (BC + BC + BC)
C(BA + CA + CA)
ABC + ABC + ABC

⇒ In the integer expression - A * B div C + D which operation is done first in Pascal
-
*
div
+

⇒ The refractive index of E layer, if angle of incidence is 30°
0.5
0.25
0
1

⇒ Maxwell's curl equation for the static electric field E can be expressed as
Δ x E = 0
Δ x E = constant
Δ - E = constant
Δ . E = 0

⇒ Which of the following theorems can be conveniently used to find power consumed in 10 Ω resistor in fig
Thevenin theorem
Maximum power transfer theorem
Millman's theorem
Superposition theorem

⇒ The log magnitude for the system in the given figure is (where T =
20 log (1 + ωT)
-20 log (1 + ωT)
-10 log (1 + ω²T²)
-20 log (1 + ω²T²)

⇒ When the ac base voltage in a CE amplifier circuit is too high, the ac emitter current is
zero
constant
alternating
distorted

⇒ The use of free wheeling diode in controlled rectifier improves the waveshape of load current.
TRUE
FALSE

⇒ In TV scanning sequence of lines is
left to right
right to left
left to right for odd fields and right to left for even field
left to right for even fields and right to left for odd field

⇒ Maxwell's divergence equation for the magnetic field is given as
∇ . B = 0
∇² . B = 0
∇ . B = constant
∇² . B = constant

⇒ A rectangular waveguide measures 3 x 4.5 cm internally and has a 10 GHz signal propagated in it. Calculate the guide wavelength for dominant mode.
13.5 m
3 m
88/3 m
3/88 m

⇒ In a diode rectifier with a capacitance input filter, a surge current is likely to flow when the circuit is switched on. The cause of this surge current is
the non linear behaviour of diodes
the capacitor acts as a short circuit at the instant of switching,
the inductance of leads
both (a) and (b)

⇒ In FORTRAN 77 FLOAT (-28) gives the value
28
-28
-28
none of the above

⇒ An FM signal with deviation δ is passed through mixer. Its frequency is reduced five fold. The deviation in output of mixer is
0.28
δ
5 δ
very very high

⇒ Antenna efficiency of antenna is, if radiation resistance is 370 Ω and loss resistance is 100 Ω
0.8
0.87
0.78
0.2127

⇒ In the signal flow graph in the given figure the number of forward paths and pairs of non-touching loops are respecti
3 and 1
3 and 2
4 and 2
2 and 4