Question is ⇒ A FET is a __________ controlled device whereas a bipolar transistor is a __________ controlled device., Options are ⇒ (A) gate, drain, (B) drain, gate, (C) current, voltage, (D) voltage, current, (E) , Leave your comments or Download question paper.

Question is ⇒ A FET is a __________ controlled device whereas a bipolar transistor is a __________ controlled device., Options are ⇒ (A) gate, drain, (B) drain, gate, (C) current, voltage, (D) voltage, current, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A FET is a __________ controlled device whereas a bipolar transistor is a __________ controlled device.
A.	gate, drain [Wrong Answer]
B.	drain, gate [Wrong Answer]
C.	current, voltage [Wrong Answer]
D.	voltage, current [Correct Answer]
View Answer 2 -6 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The equation D = ∈₀∈_r E refers only to isotropic materials.
TRUE
FALSE

⇒ A bypass capacitor produces
dc ground
ac ground
both dc and ac ground
none of the above

⇒ A plane EM wave is travelling in an unbound loss less dielectric having μ_y = 1 and ε_y = 4, the time average Poynting vector of the wave is 5 W/m³ . The phase velocity v_p (assuming velocity of light as 3 x 10⁸ m/sec) is
1.5 x 10⁸ m/sec
3 x 10⁸ m/sec
2.5 x 10⁸ m/sec
0.5 x 10⁸ m/sec

⇒ Form factor for a sine wave is
1.414
0.707
1.11
0.637

⇒ AECF1₁₆ + 15ACD₁₆ = __________ .
C47BB₁₆
C47BE₁₆
A234F₁₆
A1111₁₆

⇒ In a telephone system, the grade of service means
the quality of sound reception at the receiver telephone
the probability that a called for connection is established
the type of wires cables used for the system
none of the above

⇒ In a three variable K map four adjacent cells give
single variable term
two variable term
three variable term
either (a) or (b)

⇒ A semi converter operates in two quadrants.
TRUE
FALSE

⇒ A Hartley oscillator uses
a tapped inductor
a tapped capacitor
both (a) and (b)
neither (a) nor (b)

⇒

Match the following:

	List I (Octal)		List II (Decimal number)
A.	35	1.	53
B.	65	2.	62
C.	54	3.	29
D.	76	4.	44

A-4, B-3, C-2, D-1
A-1, B-2, C-3, D-4
A-2, B-3, C-1, D-4
A-3, B-1, C-4, D-2

⇒ In an amplifier if conductor during the cycle is from 0 to 90° and again from 180° to 270°, the amplifier will be termed as
class A
class B
class C
class AB

⇒ As per BIS, the number of accuracy classes of instrument is
5
6
7
8

⇒ Lead mounting for SCR is used for
rating less than mA
rating about 1 A or less
rating of 20 A or less than 20 A
rating 100 A or less

⇒ The pre-emphasis in FM aids in providing extra noise immunity by
emphasizing only the higher frequency components
emphasizing the entire frequency band
emphasizing only the lower frequency band
cutting down the low frequency noise

⇒ (SI - A)^-1 = adj(sI - A)/det (sI - A)
TRUE
FALSE

⇒ A transistor is operated as non-saturated switch to eliminate
turn on time
turn off time
storage time
delay time

⇒ It is required to measure pressure using LVDT. The additional device needed is
strain gauge
pitot tube
bourden tube
rotameter

⇒ A d.c. power supply has an open circuit voltage of 100 V. When the full load current is drawn, the output drops to 80 V. The percentage voltage regulation is
0.9725
0.75
0.5
0.25

⇒

Match the following:

	List I		List II
A.	Horn antenna	1.	High directivity
B.	Parabolic antenna	2.	Very high directivity
C.	Lens antenna	3.	Moderate directivity

A-1, B-2, C-3
A-3, B-2, C-1
A-3, B-1, C-2
A-1, B-3, C-2

⇒ In deriving ac equivalent circuit for an amplifier circuit we short circuit
all resistors
all transistors
all inductors
all capacitors

⇒ If we need a device to shut off a few ampere current in a few nano seconds, the proper devices is
VMOS
CMOS
BJT
UJT

⇒ In 8085 microprocessor, which of the following interrupts has the lowest priority?
RST 5.5
RST 7.5
TRAP
INTR

⇒ For an RC admittance function Y, the slope dY/dσ
is positive
is negative
may be positive or negative
0

⇒ The range of memory location in given memory interfacing scheme
0000H - 07FFH
F800H - FFFFH
0000H - 03FFH
0000H - 3FFFH

⇒ In the basic series inverter circuit, the source supplies load
only in positive half cycle
both in positive and negative half cycles
only in part of positive half cycle
in positive half cycle and part of negative half cycle

⇒ After reflection from a plane conducting surface, the apparent velocity of electromagnetic wave becomes greater than the velocity of light in free space is called
conventional velocity
phase velocity
propagation velocity
group velocity

⇒ When an electromagnetic wave travelling in one medium strikes upon a second medium (having a different conductivity) the wave will be
totally transmitted
totally reflected
neither transmitted nor reflected
partially transmitted and partially reflected

⇒ A doped semi-conductor is called
impure semi-conductor
dipole semi-conductor
bipolar semi-conductor
extrinsic semi-conductor

⇒ A waveguide connected to a circularly polarized antenna must be able to efficiently propagate both vertically and horizontally polarised waves.
TRUE
FALSE

⇒ In the figure circuit, V₁ = 40 V. When R is 10 Ω. When R is zero, the value of V₂ wil
40 V
30 V
20 V
10 V