Question is ⇒ A feedback network to be used with an amplifier to provide oscillation is tested and found to give an output of 0.124 V with a 0.5 V input. What will be the effect on output if the amplifier's gain is twice that required by the Barkhausen criterion?, Options are ⇒ (A) Linear oscillations, (B) Non-linear oscillations, (C) Damped oscillations, (D) No oscillations, (E) , Leave your comments or Download question paper.

Question is ⇒ A feedback network to be used with an amplifier to provide oscillation is tested and found to give an output of 0.124 V with a 0.5 V input. What will be the effect on output if the amplifier's gain is twice that required by the Barkhausen criterion?, Options are ⇒ (A) Linear oscillations, (B) Non-linear oscillations, (C) Damped oscillations, (D) No oscillations, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A feedback network to be used with an amplifier to provide oscillation is tested and found to give an output of 0.124 V with a 0.5 V input. What will be the effect on output if the amplifier's gain is twice that required by the Barkhausen criterion?
A.	Linear oscillations [Wrong Answer]
B.	Non-linear oscillations [Wrong Answer]
C.	Damped oscillations [Wrong Answer]
D.	No oscillations [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a 50 Ω resistor for 3 GHz application, the stray capacitance should be less than
1 μF
1 nF
1 pF
0.1 pF

⇒ The advantage of Weinbridge oscillator over the phase shift oscillator is that oscillator the frequency may be varied over a range of
0.0430555555555556
0.04375
0.0451388888888889
0.0486111111111111

⇒ Which of the following insulating material is restricted to temperatures below 100°C?
Micanite
Asbestos
Teflon
Polythene

⇒ CSSB stands for
Compatible Single Sideband
Compressed Single Sideband
Carrier Single Sideband
Coded Single Sideband

⇒ For FM, which of the following statement is not true?
The bandwidth increases as modulation index is increased
The total power remains constant with respect to modulation index
The carrier never becomes zero
All of the above

⇒ An XOR gate with 8 variable is as foll
255
127
128
256

⇒ CMRR of a difference amplifier is equal to
(A_v')/(A_com)
A_v/A_com
A_com/A_v'
(A_v)/(A_com)²

⇒ If transfer function of a system is H(z) = 6 + z^-1 + z^-2 then system is
minimun phase
maximum phase
mixed phase
none

⇒ The two-transistor model of a thyristor consists of two transistors :
one n-p-n and other p-n-p
both p-n-p
both n-p-n
one n-p-n and other UJT

⇒ A constant k low pass filter has f_c = 500 Hz. At f = 1000 Hz, the attenuation is
zero
infinity
may be zero or infinity
more than zero but less than infinity

⇒ A 3 bit up-down counter can count from
000 to 111
111 to 000
000 to 111 and also from 111 to 000
none of the above

⇒ Figure shows a chopper feeding RLE load, The free wheeling diode conducts w
thyristor is on
thyristor is off
both when thyristor is on and thyristor is off
partly when thyristor is off and partly when thyristor is on

⇒ For a 12 pulse operation, the two 6 pulse units are fed by
Y - Y and Y - Y transformers
Δ - Δ and Δ - Δ transformers
Y - Y and Y - Δ transformers
Y - Δ and Y - Δ transformers

⇒ If a signal g(t) has energy E, then the energy of the signal g(2t) is equal to ...
E/2
E/4
E
2E

⇒ For the transport lag G(jω) = e^-jωT, the magnitude is always equal to
0
1
10
0.5

⇒ The units of thermal capacitance are
k cal/°C
°C/k cal
°C sec/k cal
none of the above

⇒ A 300 Hz sound wave of intensity 20 dB is transmitted by a 1500 kHz radio wave by frequency modulation. It is seen that instantaneous frequency varies between 1500.2 kHz and 1499.8 kHz, 300 times a second. If the intensity of sound wave is 100 dB.
The instantaneous frequency variations will be between 1500.2 and 1499.8 kHz, 1500 times a second
The instantaneous frequency variations will be between 1501 and 1499 kHz, 1500 times a second
The instantaneous frequency variations will be between 1501 and 1499 kHz, 300 times a second
The instantaneous frequency variations will be between 1501 and 1499 kHz, 60 times a second

⇒ In 3 phase power measurement by two wattmeter method, both wattmeters had equal reading. The power factor of load is
1
0.5 lagging
0.5 leading
0

⇒ Schering bridge is used to measure
capacitance and dielectric loss
inductance
resistance
mutual inductance

⇒ In radar system if the antenna diameter is increased by a factor of 4, the minimum range will increased by a factor of
1
2
22
4

⇒ In intrinsic semiconductors, the number of free electrons is equal to the number of mobile holes.
TRUE
FALSE

⇒ Which of the following are the properties of a medium?
Permeability, flux, magnesium
Permittivity, permeability, insulation
Permeability, resistivity, conductivity
Permittivity, permeability, conductivity

⇒ Which of the following is used to provide tracking between RF amplifier and local oscillator stages of receiver?
Variable tuning inductor
Ganged tuning inductor
Variable capacitor
Variable preset

⇒ In the circuit shown in the given figure, R_L will absorb maximum power when its valu
2.75 Ω
7.5 Ω
25 Ω
27 Ω

⇒ The triangular wave of the given figure can be written as v(t) = u(t) - tu(t) + (t - 1) u(t
TRUE
FALSE

⇒ When the number of quantising levels is 16 in PCM, the number of pulses in a code group will be
3
4
8
16

⇒ As compared to AM, FM requires
narrow channel
same channel
2 to 3 times as large channel
7 to 15 times as large channel

⇒ Which of the following statements is not correct regarding modes of electromagnetic energy transmission?
In TE mode the direction of electric field is always and everywhere transverse to the direction of propagation
In TM mode the magnetic field pattern is always and everywhere transverse to the direction of propagation
The subscripts is TE and TM designations denote the number of half sine wave variations of the field components in x and y directions respectively.
TM₁₁ is called the dominant mode.

⇒ ROC of sequence x[n] = δ[n] is
Not exist
z = 0
Entire Plane
Entire Plane expect z = 0, z = ∞

⇒ In the case of the circuit shown in the figure V_io = 10 mV dc maximum, the maximum possible output offset voltage V_oo caused by the input offset voltage V_io with respect to groun
60 mV dc
110 mV dc
130 mV dc
150 mV dc