Question is ⇒ A dynamometer wattmeter is connected in ac circuit. The reading will be, Options are ⇒ (A) V-A product, (B) average power, (C) peak power, (D) instantaneous power, (E) , Leave your comments or Download question paper.

Question is ⇒ A dynamometer wattmeter is connected in ac circuit. The reading will be, Options are ⇒ (A) V-A product, (B) average power, (C) peak power, (D) instantaneous power, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A dynamometer wattmeter is connected in ac circuit. The reading will be
A.	V-A product [Wrong Answer]
B.	average power [Correct Answer]
C.	peak power [Wrong Answer]
D.	instantaneous power [Wrong Answer]
View Answer 3 -5 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In an ac circuit that delivers constant power at varying p.f., the current is
lowest when p.f. is leading
lowest when p.f. is lagging
lowest when p.f is unity
the same for all power factors

⇒ The open collector gates in the given figure are tied together. The output
A + B + C + D
A + B + C + D
(A + B) (C + D)
AB + CD

⇒ In high frequency region, an amplifier behaves like a
band pass filter
low pass filter
high pass filter
any of the above

⇒ The output voltage of a charger is
less than battery voltage
same as battery voltage
more than battery voltage
same or more than battery voltage

⇒ In saturation region JFET acts like a
bipolar device
short circuit
switch
resistance

⇒ A capacitor used for power factor correction in single- phase circuit decreases
the power factor
the line current
both the line current and the power factor
the line current and increases power factor

⇒ In the self biasing scheme (R_F across collector to base) of BJT, S₁ tends to unity by __________ R_C is the collector load Resistance.
increasing R_F
decreasing R_F
decreasing R_F and increasing R_C
increasing R_F and decreasing R_C

⇒ Greatest mobility can be expected in case of
holes
protons
electrons
negative ions

⇒ The electrical power to a megger is provided by
battery
inverter
permanent magnet dc generator
ac generator

⇒ Binary number 1101101101 is equal to decimal number
3289
2289
1289
289

⇒ In free space
phase velocity is greater than light velocity
phase velocity is equal to group velocity
phase velocity is equal to light velocity
Both (b) and (c)

⇒ The impulse response h(t) of a linear invariant continuous time system is given by h(t) = exp (- 2t) u(t), where u(t) denotes the unit step function. The output of this system to the sinusoidal input x(t) = 2cos(2t) for all time t, is
0
2^-0.25 cos (2t - 0.125p)
2^-0.5 cos (2t - 0.125p)
2^-0.5 cos (2t - 0.25p)

⇒ Consider the following statements

Dissipative attenuator has a fixed value of attenuation.
Reflective attenuator has a fixed value of attenuation.
Both dissipative and reflective attenuators are available only with fixed attenuation.
Both dissipative and reflective attenuators are available with either fixed or variable attenuation.

Which of the above are correct?
1 only
1 and 2
1, 2 and 3
4 only

⇒

Match the following:

	List I		List II
A.	RC coupled amplifier	1.	Very low drift
B.	Tuned amplifier	2.	Flat frequency response from zero frequency onwards
C.	Chopper stabilized amplifier	3.	Flat frequency response with upper and lower cut off frequency
D.	DC amplifier	4.	Peak in gain frequency response

A-4, B-3, C-1, D-2
A-3, B-4, C-2, D-1
A-3, B-4, C-1, D-2
A-4, B-3, C-2, D-1

⇒ ECL can be used to high frequencies in the order of
500 kHz
1 MHz
100 MHz
500 MHz

⇒ A loss less transmission line is terminated in a load which reflects a part of the incident power. The measured VSWR is 2. The percentage of the power that is reflected back is
57.73
33.33
0.11
11.11

⇒ The MOS symbols shown indica
1, 3, 6
2, 4, 6
1, 3, 5
2, 3, 6

⇒ Which of the following material can be used in cable shields?
Copper
Aluminium
Cast iron
Lead

⇒ High cut off frequency can be expected in case of
common-base
common-emitter
common-collector
all of the above

⇒ In most of instruments, the controlling torque is provided by
fluid fraction
spring
eddy current
either (a) or (c)

⇒ Decimal 8 in excess-3 code =
1000
1001
1011
1111

⇒ Which one of the systems described by the following I/P - O/P relations is time invariant
y(n) = n x(n)
y(n) = x(n) - x(n - 1)
y(n) = x(- n)
y(n) = x(n) cos 2pf₀n

⇒ For a bipolar transistor, avalanche multiplication factor depends on __________ .
V_CE
V_CB
V_BE
none of these

⇒ The resistivity of intrinsic semiconductors, at room temperature, is of the order of
1 Ω-m
1000 Ω-m
10⁶ Ω-m
10^-3 Ω-m

⇒

Match the following:

	List I (Binary)		List II (Hexadecimal)
A.	10101010	1.	FF
B.	11111111	2.	88
C.	10001000	3.	92
D.	10010010	4.	AA

A-4, B-1, C-2, D-3
A-1, B-2, C-3, D-4
A-3, B-1, C-2, D-4
A-1, B-3, C-4, D-1

⇒ 4 bit 2's complement representation of a decimal number is 1000. The number is
8
0
-7
-8

⇒ Hexadecimal number E is equal to binary number
1110
1101
1001
1111

⇒

Assertion (A): In a BJT, the base region is very thick.

Reason (R): In p-n-p transistor most of holes given off by emitter diffuse through the base.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ For a depletion type NMOS, V_p = - 4 volts. For V_GS = 0, 1_D = 16 mA in the pinch off region of V_DS. For V_GS = - 2, the value of I_D in the pinch off region of V_DS is given by
64 mA
32 mA
16 mA
4 mA

⇒ A vertical loop antenna, like a horizontal dipole, is vertically polarised.
TRUE
FALSE