Question is ⇒ A dual trace CRO has, Options are ⇒ (A) one electron gun, (B) two electron guns, (C) one electron gun with one two pole switch, (D) two electron guns with one two pole switch, (E) , Leave your comments or Download question paper.

Question is ⇒ A dual trace CRO has, Options are ⇒ (A) one electron gun, (B) two electron guns, (C) one electron gun with one two pole switch, (D) two electron guns with one two pole switch, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A dual trace CRO has
A.	one electron gun [Wrong Answer]
B.	two electron guns [Wrong Answer]
C.	one electron gun with one two pole switch [Correct Answer]
D.	two electron guns with one two pole switch [Wrong Answer]
View Answer 10 -17 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ What is the characteristic impedance at 10 MHz?
547.7 Ω
54.7 Ω
5.47 Ω
.547 Ω

⇒ Antiferromagnetic materials do not have permanent dipoles.
TRUE
FALSE

⇒ A dc amplifier can operate
at zero frequency
only at low frequency
only at high frequencies
both at low and high frequencies

⇒ An earth mat for a communication tower consists of
one or two radials extending from base of tower at a depth of about 5 cm below ground
a large number of radials extending from base of tower at a depth of about 3 m
a large number of radials extending from base of tower at a depth of about 30 cm
none of the above

⇒

Assertion (A): For a dielectric, P = ∈₀(∈_r - 1) E.

Reason (R): Dipole moment per unit volume is called polarization of dielectric.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following microphones is the cheapest?
Moving coil
Condenser
Ribbon
Carbon

⇒ The noise margin of a TTL gate is about
0.2 V
0.4 V
0.6 V
0.8 V

⇒ Strip lines are used at
microwave frequency
low frequency
High frequency
at any frequency

⇒ The time constant of the network shown in figur
2 RC
5/3 RC
RC/2
None of these

⇒ Which one of the following is not a negative resistance device?
Gunn diode
Tunnel diode
Impatt diode
Varactor diode

⇒

Assertion (A): R-2R ladder type DAC has higher speed of operation than weighted resistor DAC

Reason (R): R-2R ladder type DAC uses only two different values of resistor network uses many different values of resistors

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In a class C amplifier, full cycle conductor of the current is achieved by employing
tuned circuit
transformers
complementary pair
Push pull configuration

⇒ The boundary conditions at the interface between two dielectrics in an electric field are given by
D_normal = 0, E_tangential = 0
D_normal = 0, E_normal = 0
D_tangential = 0, E_tangential = 0
D_tangential = 0, E_normal = 0

⇒ The reading of the voltmeter V in figure should be __________ v
60
10
66
0

⇒ A series RC circuit has fixed R and C and variable f. The current locus will lie in the first quadrant.
TRUE
FALSE

⇒

Assertion (A): A tree of graph contains all the nodes of the graph.

Reason (R): The number of links is always less than the number of tree branches.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ When a plane wave is incident normally from dielectric '1' (μ₀, ε₁) onto dielectric '2' (μ₀, ε₂) the electric field of the transmitted wave is 2 times the electric field of the reflected wave. The ratio ε₂/ε₁ is
0.5
1
2
4

⇒ To separate channels in FDM receiver we have to use
integration
AND gate
band pass filter
differentiation

⇒

Assertion (A): In CC amplifier the collector is at ac ground

Reason (R): CC amplifier is also called emitter follower

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒

Assertion (A): The impedance of a series resonant circuit is minimum at resonance.

Reason (R): Resonance condition implies unity power factor condition.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The residual resistivity of a binary alloy at 0°K is
the sum of the residual resistivities of the component metals
the difference of the residual resistivities of the component metals
the product of the residual resistivities of the component metals
depend on the concentration of the minor component in the alloy

⇒ In an idealized half wave rectified system the average and r.m.s. values of voltage are __________ respectively.
2V_m/p, V_m/2
V_m/p, V_m/2
V_m/p, V_m/2
V_m.p, V_m/2

⇒ Which of the following lines behaves as infinite line?
a line terminated in inductance
a line terminated in capacitance
a short line
a line terminated in z₀

⇒ Four terminal approach is used in measuring low resistance because it
eliminates thermoelectric energy
eliminates stray capacitance
eliminates stray inductance
eliminates the effect of leads and contacts

⇒ Narrow band FM signal can be represented as
A cos (2pf_ct) - βA sin (2pf_ct) sin (2pf_mt)
A cos (2pf_mt) - βA sin (2pf_ct) sin (2pf_mt)
A cos (2pf_ct) + βA sin (2pf_ct) sin (2pf_mt)
A cos (2pf_mt) + βA sin (2pf_mt) sin (2pf_ct)

⇒ The ac bridge in figure is balanced. Z₁ = 100∠30°, Z₂ = 150∠0°, Z₃ = 250∠ - 40° Then Z_{4375∠70° Ω
375∠ - 70° Ω
150∠0° Ω
150∠20° Ω}

⇒ In a rectangular waveguide there is one half wave variation of electric field across the narrow dimension and two half wave variations of electric field across wider dimension. The dominant mode is
TM₁₂
TE₁₃
TE₂₁
TM₂₅

⇒ A two branch parallel tuned circuit has a coil of resistance 100 Ω and inductance 0.005 H in one branch and 10 nF capacitor in the second branch. At resonance frequency is
100 rad/sec
10000 rad/sec
1000 rad/sec
more than 10000 rad/sec

⇒ For the output F to be 1 in the logic circuit shown, the input combination shoul
A = 1, B = 1, C = 0
A = 1, B = 0, C = 0
A = 0, B = 1, C = 0
A = 0, B = 0, C = 1

⇒ If the inputs to a 3 bit binary adder are 111₂ and 111₂, the output will be 110₂
TRUE
FALSE