Question is ⇒ A divide by 78 counter can be obtained by, Options are ⇒ (A) 6 numbers of mod-13 counters, (B) 13 numbers of mod-6 counters, (C) one mod-13 counter followed by mod-6 counter, (D) 13 number of mod-13 counters, (E) , Leave your comments or Download question paper.

Question is ⇒ A divide by 78 counter can be obtained by, Options are ⇒ (A) 6 numbers of mod-13 counters, (B) 13 numbers of mod-6 counters, (C) one mod-13 counter followed by mod-6 counter, (D) 13 number of mod-13 counters, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A divide by 78 counter can be obtained by
A.	6 numbers of mod-13 counters [Wrong Answer]
B.	13 numbers of mod-6 counters [Wrong Answer]
C.	one mod-13 counter followed by mod-6 counter [Correct Answer]
D.	13 number of mod-13 counters [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A white noise X(t) with two-sided power spectral density 1 x 10^-10 W/Hz is input to a filter whose magnitude squared response is shown be
5 x 10^-7W
1 x 10^-6W
2 x 10^-6W
5 x 10^-6W

⇒ Which of the following is invalid in Basic?
A ** B - C
5.2 ** 4.3
5.2 ** (- 4.3)
(- 5.2) ** (4.3)

⇒ The amount of time between the creation and recombination of a free electron and hole is called
relaxation time
life time
lorentz time
collision time

⇒ Which of these are 16 bit microprocessors?
80286
MC68000
Z8000
All

⇒ A 555 timer can be used as
an astable multivibrator
monostable multivibrator
frequency Divider only
any of the above

⇒ The current in a circuit with 10 Ω resistance is i = 3 + 4 sin (100 t + 45°) + 4 sin (300 t + 60°) A. The rms current and power dissipated are
41 A and 410 W
35 A and 350 W
5 A and 250 W
11 A and 1210 W

⇒ In a flip-flop with a NAND latch, a low R and a low S produces
active condition
inactive condition
race condition
dead condition

⇒ Value of 'K' for the system for which the system is stab
K < 1
K > 1
K < 2
K > 2

⇒

Assertion (A): Schottky transistors are preferred over normal transistors in digital circuits

Reason (R): A Schottky transistor when used as a switch, between cutoff and active region.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ If sequence currents I_a1 = 2 ∠- 90°, I_a2 = 0.2 ∠ 90° and I_a3 = 1.8 ∠ 90°, I_a =
0
1
4
8

⇒ A T network is inserted between source and R as shown in figure. The resistance seen by the source remains the same with or without T network when
5 Ω
10 Ω
15 Ω
20 Ω

⇒ Multiplex techniques are used for
low density communications
low density point-to-point communications
high-density point-to-point communications
all of the above

⇒ In 8085 microprocessor with memory mapped I/O which of the following is true?
I/O devices have 16 bit addresses
I/O devices are accessed during IN and OUT instructions
There can be a maximum of 256 input and 256 output devices
Logic operations can not be performed

⇒ The product of which of the following gives the figure of merit of a logic family?
Gain and bandwidth
Propagation delay time and power dissipation
Fan-out and propagation delay time
Noise margin and power dissipation

⇒ Which of the following lines is non-radiating?
Open two wire
Coaxial
Both
None of the above

⇒ Binary 1111 when added to binary 11111, the result in binary is
111111
1111
1000
10000

⇒ Insertion of a dielectric material between the plates of an air capacitor
increases the capacitance
decreases capacitance
has no effect an capacitance
increases breakdown voltage

⇒ When a complex voltage wave is applied to a capacitor the resulting current wave is more distorted than the voltage wave.
TRUE
FALSE

⇒ In drawing phasor diagram
rms values are used
peak values are used
either rms or peak values are used
either rms or peak or averages values are used

⇒ Consider the following statements : A clamper circuit

adds or subtracts a dc voltage to a waveform
does not change the waveform
amplifiers the waveform

Which are correct?
1, 2
1, 3
1, 2, 3
2, 3

⇒

Match the following:

	List I (Instruction)		List II (Flag's getting affected)
A.	ORI	1.	CY reset
B.	DAA	2.	CY reset and AC reset
C.	PCHIL	3.	S, Z, AC, P, CY flags affected
		4.	S, S, P are modified
		5.	No flags affected

A-2, B-3, C-5
A-4, B-3, C-5
A-1, B-2, C-3
A-2, B-4, C-1

⇒ The maximum range of a radar is proportional to
square root of peak transmitted pulse power
fourth root of peak transmitted pulse power
peak transmitted pulse power
none of the above

⇒ Resistivity of electrical conductors is most affected by
Pressure
temperature
composition
ageing

⇒ The main feature of a parametric amplifier is
low noise
very high gain
broad bandwidth
both (b) and (c)

⇒ For an ideal 3000 Hz channel, S/N ratio is
3
1.5
4
2

⇒ The system in the given fi
will be unstable due to the presence of positive feedback in the inner loop
may be stabilized by the negative feedback outer loop
can never be stable
will always be stable

⇒ For a good public address system the sound intensity at the farthest point should be at least
20 dB over threshold of hearing
40 dB over threshold of hearing
80 dB over threshold of hearing
120 dB over threshold of hearing

⇒ When a series RL circuit having power factor angle 0 is switched on to an ac voltage V_m sin (ωt + Φ), the transient term is zero if Φ = 0.
TRUE
FALSE

⇒ If a linear time invartant system is exicited by a pure random signal like white noise, the output of the linear system will have which of the following properties?
Output will be a white noise
Output will be periodic
Output will be random
Output will be correlated or coloured noise

⇒ The rule that resistivity of conductors can be separated into two parts viz. temperature independent and temperature dependent is known as
Matthiessen's rule
Debye rule
Curie rule
Onne's rule