Question is ⇒ A directional coupler is used to determine, Options are ⇒ (A) rv, (B) rv and VSWR, (C) L and C, (D) wave velocity, (E) , Leave your comments or Download question paper.

Question is ⇒ A directional coupler is used to determine, Options are ⇒ (A) rv, (B) rv and VSWR, (C) L and C, (D) wave velocity, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A directional coupler is used to determine
A.	r_v [Wrong Answer]
B.	r_v and VSWR [Correct Answer]
C.	L and C [Wrong Answer]
D.	wave velocity [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The configuration of figure
Hartley oscillator
Precision Integrator
Wienbridge oscillator
Butterworth high pass filter

⇒ In a gate output is Low if and only if all inputs are High. The gate is
OR
AND
NOR
NAND

⇒ Thermistor is used in
temperature measurement
temperature control
high temperature alarm circuits of devices
all of the above

⇒ Which of the following statement is correct?
A FET is a current controlled device
A BJT is always reverse biased
The semi-conductor material of the gate in an N-channel JFET is p-type
JFET has higher input impedance than MOSFET

⇒ The Thevenin Resistance of the circui
94/7 kΩ
54/7 kΩ
7/54 kΩ
0

⇒ A signal m(t) = 5 cos 2p 100 t frequency modulates a carrier. The resulting FM signal
0.1 kHz
6 kHz
3.2 kHz
100 kHz

⇒ In an op-amp differentiator
the amplitude of output is proportional to rate of change of input
the amplitude of output is proportional to input
output occurs when input is finite and constant
polarity of input and output is the same

⇒ A voltage V(t) is a Gaussian ergodic random process with a mean of zero and a variance of 4 volt². If it is measured by a dc meter. The reading will be
0
4
2
2

⇒ A 20 Ω resistor, a 1H inductor and 1μF capacitor are connected in parallel the combination is driven by a unit step current. Under the steady state, source current flows through
inductor
capacitor
resistor
all

⇒ A TRIAC is equivalent to
two thyristors in series
two thyristors in parallel
one thyristor and one diode
one thyristor and one transistor

⇒ Let f(A, B) = A ⊕ B; then the simplified form of the function f(f(x ⊕ y, z)w) is
(x ⊕ y ⊕ z)w
x ⊕ y ⊕ z ⊕ w
(x ⊕ y ⊕ z) + w
none of these

⇒ A transmission line is feeding 1 watt of power to a horn antenna having a gain of 10 dB. The antenna is matched to the transmission line. The total power radiated by the horn antenna into the free space is
10 watt
1 watt
0.1 watt
0.01 watt

⇒ Which mode is called dominant mode in rectangular wave guide?
TE₀₁
TE₁₁
TE₁₀
TE₂₀

⇒ Kell factor is about
5
3
0.7
0.2

⇒ Calculate the critical frequency for the E layer if maximum ionic densities are 3 x 10⁶
15.58 x 10⁶
15.58 kHz
1.58 x 10³
None of the above

⇒

Assertion (A): Fourier series can also be written in exponential form.

Reason (R): sin (n ωt) and cos (n ωt) can be expressed as sum or difference of exponentials.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Complex poles give rise to oscillatory terms in the response.
TRUE
FALSE

⇒ Which of these has peak and valley points in v-i curve?
Tunnel diode
Zener diode
PIN diode
Schottky diode

⇒ Which of the following is not a valid real variable in FORTRAN 77?
ANUT
MONEY
A MONEY
BS

⇒ A reactance function is always a quotient of
even to odd polynomials
odd to even polynomials
even to odd or odd to even polynomials
even to even polynomials

⇒ A is even or B is true. Negation of above statement is
A is odd or B is false
A is odd and B is false
A is even or B is false
A is even and B is false

⇒ Pirani gauge is used to measure
very low pressure
high pressure
pressure in the range of 1 atmosphere
fluid flow

⇒ If all bubbles are removed, what are the new RAM locati
(8000)_H - (83FF)_H
(80AA)_H - (80FF)_H
(FF00)_H - (FFFF)_H
none of the above

⇒ The number of channels available in MF band (300 kHz - 3 MHz) for AM modulating signal of 20 kHz is
70
67
100
150

⇒ In a medium if ε, μ and σ are constant throughout the medium, then it is known as
perfect vacuum
distributed medium
homogeneous medium
dielectric medium

⇒ The input gate current of FET is closer to
few amperes
few milli amperes
few microamperes
negligibly smaller value

⇒ Since noise phase modulated FM wave, as the noise sideband frequency approaches the carrier frequency, the noise amplitude
is equalized
is increased
is decreased
remains constant

⇒ A piece of iron is placed in a magnetic field
the magnetic field will not be affected
the magnetic lines of force will bend to pass through the piece
the magnetic lines of force will bend away from the piece
any of the above depending on type of iron

⇒ All of the output pulses are at full transmitter power for a strong signal in all of the following except
PWM
PAM
PFM
PCM

⇒ With a variable reluctance tachometer having 60 rotor teeth the count reads 3600 counts per minute. The speed in RPM is
36
60
360
3600