Question is ⇒ A directional coupler is used, Options are ⇒ (A) to transmit microwave signals, (B) to generate microwave signals, (C) to measure amplitude and phase of a travelling wave, (D) both (a) and (b), (E) , Leave your comments or Download question paper.

Question is ⇒ A directional coupler is used, Options are ⇒ (A) to transmit microwave signals, (B) to generate microwave signals, (C) to measure amplitude and phase of a travelling wave, (D) both (a) and (b), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A directional coupler is used
A.	to transmit microwave signals [Wrong Answer]
B.	to generate microwave signals [Wrong Answer]
C.	to measure amplitude and phase of a travelling wave [Correct Answer]
D.	both (a) and (b) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A series RLC circuit has a resonant frequency of 1000 Hz. The maximum voltage across C is likely to occur at a frequency of about
1000 Hz
2000 Hz
1025 Hz
975 Hz

⇒ When a large number of atoms are brought together to form a crystal
the energy levels of inner shell electrons are affected appreciably by the presence of other neighbouring atoms.
The energy levels of outer shell electrons are affected appreciably by the presence of other neighbouring atoms.
the energy levels of both inner and outer shell electrons are affected appreciably by the presence of other neighbouring atoms.
none of the above.

⇒ Photoconductive devices uses
metallic conductors
good quality insulators
semiconductors
either (a) or (c)

⇒ The main advantage of TDM over FDM is
TDM requires more bandwidth than FDM
less complicated in hardware than FDM
better SNR
required filter

⇒ Thermal noise is independent of
temperature
bandwidth
centre frequency
Boltzmann constant

⇒ The bridge is balanced when the value of R is
50 Ω
100 Ω
200 Ω
250 Ω

⇒ Switching systems
are limited to small data networks
require additional lines
are not used in data system
improve the efficiency of data transfer

⇒ Figure represen
JFET shunt switching circuit
JFET series switching circuit
JFET analog switch
multiplexing

⇒ The unit of magnetic flux density is
farad/metre
ohm/metre
tesla
ampere/metre

⇒ A cycloconverter for single phase operation has
one positive group and one negative group converters
two positive group and two negative group converters
three positive group and three negative group converters
any of the above

⇒ The term critical frequency denotes
the lowest frequency that is reflected by the ionosphere
the highest frequency that is reflected by the ionosphere at vertical distance
the lowest frequency by which communication is possible between two given points
none of the above

⇒ In a Weston synchronoscope, the moving coil is connected across
bus bar
incoming alternator
lamp
fixed coils

⇒

Assertion (A): Derivative control action is also called rate control and has an anticipatory character.

Reason (R): Derivative control amplifies noise signals.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒

Assertion (A): A universal RLC bridge has a battery and also a high frequency ac source.

Reason (R): RLC bridge uses a Wienbridge arrangement for measuring capacitance.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Which of the following is not an omnidirectional antenna?
Log periodic
Half-wave dipole
Discone
Marconi

⇒ In CE configuration, the output characteristics of a bipolar junction transistor is drawn between
I_C and V_CB
I_E and V_CB
I_C and V_CE
I_E and V_CE

⇒ In digital circuits Schottky transistors are preferred over normal transistors because of their
lower propagation delay
lower power dissipation
higher propagation delay
higher power dissipation

⇒ The depletion type MOSFET can operate in
depletion mode only
enhancement mode only
depletion or enhancement mode
neither depletion nor enhancement mode

⇒ The curve representing Ohm's law is
linear
a parabola
a hyperbola
sine function

⇒

Match the following:

	List I (μP)		List II (Number of bits in register)
A.	8085	1.	32 bit
B.	8086	2.	16 bit
C.	68000	3.	8/16 bit

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-2, C-1
A-3, B-1, C-2

⇒ The degradation of satellite solar cells with time is mainly due to
their bombardment by electrons
collection of meteoric dust
increase in resistivity of silicon
gradual leakage of charge carriers from the semiconductor material

⇒ A constant k band pass filter has a pass band from 100 to 400 Hz. The resonant frequency of series and shunt arms is
3000 Hz
2500 Hz
2000 Hz
1500 Hz

⇒ A 3 stage Johnson counter shown in figure is clocked at a constant frequency of f_c from the starting state of Q₀ Q₁ Q₂ = 101. The frequency of output Q₀ Q₁ Q₂ wil
f_c/2
f_c/3
f_c/6
f_c/8

⇒ The function δ' (t-b) is
a step function originating at t = b
an impulse function originating at t = b
a unit doublet originating at = t - b
none of the above

⇒ A half bridge inverter
needs a 3 wire dc supply
may use a two wire or 3 wire dc supply
has higher output voltage if fed from 3 wire dc supply
has higher efficiency if fed from 3 wire dc supply

⇒ In a diode rectifier with a capacitance input filter, a surge current is likely to flow when the circuit is switched on. The cause of this surge current is
the non linear behaviour of diodes
the capacitor acts as a short circuit at the instant of switching,
the inductance of leads
both (a) and (b)

⇒

Assertion (A): Negative values of incremental operator in DO loop are allowed in Fortran 77 but not in earlier versions of Fortran.

Reason (R): Fortran 77 has better array facilities than earlier versions of Fortran.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ A network is said to be two port network if there is

no independent source in the network
no dependent source in the network
non-linear component in the circuit
no external connection exist between I/P and 0/P

1, 2, 3
3, 4, 2
1, 3, 4
4, 3, 1, 2

⇒ In communication systems, the modulating signal is also called
base band signal
side bands
auxiliary signal
none of the above

⇒ IC 74181 performs arithmetic operations when M = 1.
TRUE
FALSE