Question is ⇒ A diode peak reading VTVM and thermocouple meter are connected across output of an amplitude modulated circuit. In the absence of modulation both meters read 10 V. When sinusoidal AM is applied, VTVM reads 15V The reading of thermocouple meter will be, Options are ⇒ (A) 10 V, (B) 12.5 V, (C) 14.1 V, (D) 15 V, (E) , Leave your comments or Download question paper.

Question is ⇒ A diode peak reading VTVM and thermocouple meter are connected across output of an amplitude modulated circuit. In the absence of modulation both meters read 10 V. When sinusoidal AM is applied, VTVM reads 15V The reading of thermocouple meter will be, Options are ⇒ (A) 10 V, (B) 12.5 V, (C) 14.1 V, (D) 15 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A diode peak reading VTVM and thermocouple meter are connected across output of an amplitude modulated circuit. In the absence of modulation both meters read 10 V. When sinusoidal AM is applied, VTVM reads 15V The reading of thermocouple meter will be
A.	10 V [Correct Answer]
B.	12.5 V [Wrong Answer]
C.	14.1 V [Wrong Answer]
D.	15 V [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a full wave bridge rectifier supplied with 50 Hz a.c., the lowest ripple frequency will be
50 Hz
100 Hz
200 Hz
400 Hz

⇒ The wave applied to X plates, for ohtaining trace of voltage wave, is
sawtooth wave
sinusoidal wave
rectangular wave
either (a) or (c)

⇒ The Z inverse of the given Z transfor
Unit step
Unit ramp
Unit impulse
Unit parabola

⇒ In figure, i(0^-) and v(0^-) are zero. The switch is closed at t = 0, i(0⁺) and (∞)
3 A and 1.5 A
1.5 A and zero
3 A and zero
1.5 A and 3 A

⇒ Which of the following exhibits negative resistance in a portion of its characteristics?
Tunnel diode
Zener diode
JFET
MOSFET and tunnel diode

⇒ A capacitor used for power factor correction is single phase circuit decreases
power factor
line current
both line current and p.f.
the line current and increases p.f.

⇒ In MF range, increasing the transmitter power
increases the range of transmitter
does not increase the range of transmitter because propagation is limited by tilt
decreases the range of transmitter because propagation is limited by tilt
increases the range of transmitter because propagation is through space waves

⇒ A signal having uniformly distributed amplitude in the interval (- V to + V) is to be encoded using PCM with uniform quantization. The signal to quantization noise ratio is determined by
dynamic range of signal
sampling rate
number of quantizing levels
power spectrum of signal

⇒ Which of the following is likely to be associated with FM radio broadcasting?
90 Hz
90 kHz
900 kHz
90 MHz

⇒ Voltage standing wave pattern in a loss less transmission line with characteristic impedance 50 Ω and a resistive load is shown in the figu
-0.6
-1
0.6
0

⇒

Assertion (A): Dynamic RAM needs refreshing.

Reason (R): Capacitors tend to loose charge.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In single tone AM modulation, the transmission efficiency for m = 1 is
0.333
0.5
1
0.1665

⇒ In an R-S latch, to set the output to high
R is low and S is high
R and S are high
R and S are low
R is high and S is low

⇒ The S (sign) flag is set when the contents of accumulator become negative during an operation.
TRUE
FALSE

⇒

Assertion (A): If contents of F register in 8085 are 01010001, it means S = 0, Z = 1, AC= 1, P = 0 and CY = 1.

Reason (R): When an instruction is called from memory, the op. code of instruction is stored in instruction register.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ If I = J = K = 13, then in Fortran 1 = 10 - (1 / 10) * 10 + (J / 5) * 4 + K ** (- 2) is equal to
8
7
6
5

⇒ An R-C coupled amplifier has mid-frequency gain of 200 and a frequency response from 100 Hz to 20 kHz. A negative feedback network with β = 0.2 is incorporated into the amplifier circuit, the Bandwidth will be
50 kHz
20 kHz
100 kHz
infinite

⇒ In a radio receiver, the local oscillator is tuned to a frequency
lower than the incoming frequency
higher than the incoming frequency
equal to incoming frequency
any of the above

⇒ In figure The minimum and maximum load currents
0 and 60 mA
0 and 120 mA
10 mA and 60 mA
10 mA and 120 mA

⇒ In rectangular waveguides the ratio of width to height is about
0.5
1
2
4

⇒ How much r.m.s. current does a 300 W, 200 V bulb take from the 200V, 50 Hz power line?
0.5 A
1.5 A
0.0833333333333333
0.125

⇒

Match the following:

	List I		List II
A.	Evanescent wave	1.	Pattern multiplication
B.	Skip distance	2.	Mismatched transmission line
C.	Return loss	3.	Propagation in lossy medium
D.	Antenna array	4.	Short wave propagation
		5.	Propagation below cut-off

A-5, B-2, C-4, D-3
A-2, B-4, C-1, D-5
A-5, B-4, C-2, D-1
A-1, B-3, C-4, D-5

⇒ When analysing two port networks in cascade, it is more convenient to use
z parameters
h parameters
T parameters
y parameters

⇒ CC circuit is suitable for impedance matching.
TRUE
FALSE

⇒

Assertion (A): To add 8 bit words, two 1C 74181 can be cascaded.

Reason (R): In 1C 74181 a sum greater than 15 leads to high carry out.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The inputs to a 4 channel MUX have the following bandwidths. Channel 1-50 Hz, channel 2-200 Hz. Channel 3-75 Hz. Channel 4-90 Hz. The theoretical minimum sampling rate of the MUX is
200 Hz
400 Hz
415 Hz
1600 Hz

⇒ Loading effect is primarily caused by instruments having
high resistance
high sensitivity
low sensitivity
high range

⇒ Which one of the following cannot be used to remove the unwanted sideband in SSB?
Balanced modulator
Phase shift method
Filter system
Third method

⇒ The value of 2⁵ in octal system is
40
20
100
200

⇒ Which of the following periodic waveforms will have only odd harmonics of sinusoidal wavef
1 and 2
1 and 3
1 and 4
2 and 4